RETRO SNOW. by Kristin Gassaway

Transcription

1 RETRO SNOW by Kristin Gassaway EXCLUSIVE

2 Retro Snow by Kristin Gassaway PALETTE DecoArt Americana Acrylics Bahama Blue #13249 Foilage Green #13259 Lamp (Ebony) Black #13067 Leaf Green #13051 Moon Yellow #13007 Pumpkin* Santa Red #13170 Slate Grey #13068 Terra Coral # Warm White #13239 *Discontinued by DecoArt DecoArt Neons Fiery Red #18000 SURFACE Oblong Plaque #63160 MISC. SUPPLIES Large Sanding Pad Fine/Medium #70796 White Graphite Paper 18x36 #70139 Soft Grip Embossing & Stylus set of 3 #70125 Polka Dot Stencil #70842 DecoArt Multi Purpose Sealer #87392 Dura Clear Matte Varnish # /8" Sawtooth Hangers set of 6 #82218 BRUSHES Papillon by the Artist's Club 1/4 inch Stencil Brush (from set #20189) 7 Piece Starter set # Piece Highlighter set #20173 Maxine s Mop size 3/8 inch #27182 Maxine s Mop size 3/4 inch #27181 Old scruffy brush or Deerfoot brush (from set #20167) Old toothbrush for spattering PAINTING INSTRUCTIONS Lightly sand the board with sanding pad to remove any imperfections. Seal with DecoArt multipurpose sealer. Basecoat the board (except for the border) in Bahama Blue and let dry. Trace the pattern onto the board using the White graphite paper and a stylus. Basecoat as follows using a flat shader or round brush to best fit the size of area you are painting: Letters Santa Red Snowman head Warm White Nose Pumpkin Hat Foilage Green Hat brim Terra Coral Letters Use the polka dot stencil and Terra Coral to stencil small dots on all the letters. I used my own stencil that I ve had for a while, but you can either purchase your own, or make one using a hole punch and some sturdy cardstock paper. The one that Artists Club carries has two sizes of dots, and either would work beautifully. Remember when stenciling to use a dry brush and very little paint so that you don t bleed through the bottom of the stencil. I always rub some of the paint off of my brush by scrubbing it into a paper towel before I begin stenciling. You can always add more layers if you need to, by repeating the same process. When you are done, you may need to go around your letters with some Bahama Blue to touch up any polka dots that have strayed outside the lines. Use a dry highlighter brush and a touch of Fiery Red to add highlights down the centers of all the letters. A very small amount goes a long way. Start out light, and add more paint if you feel it needs to be brighter, but be careful not to cover too much of your polka dots. Mine is very subtle, but you can add more to your liking. Snowman Face Using a 1:1 ratio mix of Slate Grey and Warm White, shade around edges the snowman s face. Use a mop brush to soften. Use a dry highlighter brush and a bit of Terra Coral to make the cheek. The eyes and mouth are based in Lamp Black. I made these irregular to look like coal. Use your stylus and Warm White to add a small dot to the left side of each piece of coal. Highlight the top of the nose with a bit of Moon Yellow. 2 artistsclub.com

3 artistsclub.com 3

4 Hat Shade all around the hat with Leaf Green and use a mop brush to soften. The center is highlighted with a 1:1 mix of Foilage Green and Moon Yellow. Hat Brim and Pom-Pom Paint the stripes with Santa Red, and then float shade around the entire brim with Santa Red. Drybrush a highlight across the center with Fiery Red. The pom-pom is made by pouncing layers of paint using a small old scruffy brush or a Deerfoot brush. I did not rinse my brush in between each color. This is very light and airy, so after dipping your dry brush in paint, pounce your brush on a paper towel first to remove some of the paint. First pounce Santa Red, then Terra Coral, then Warm White, followed by a bit more Santa Red on top. 4 artistsclub.com

5 Snowflakes Use a liner brush and thinned Warm White to paint the various snowflakes on each end of the letters, on hat, and scattered around as you choose. Use your stylus to place a dot on all the snowflake tips, and the center of each, using Warm White. Use an old toothbrush or fan brush to spatter Warm White all over the board to look like snow. artistsclub.com 5

6 6 artistsclub.com

7 FINISHING Base the border edge with Santa Red. Varnish with Dura Clear Matte Varnish and attach the Sawtooth Hanger to the back. Copyright Kristin Gassaway. All rights Reserved. For personal use only, unless given written permission from the artist. For questions, contact artistsclub.com 7

8 8 artistsclub.com

9 Pattern at 100% 1" x 1" To ensure your pattern is at 100%, this box should measure 1" x 1" when printed. artistsclub.com 9

10 10 artistsclub.com

11 Pattern at 100% 1" x 1" To ensure your pattern is at 100%, this box should measure 1" x 1" when printed. artistsclub.com 11

12 Copyright 2018 by Kristin Gassaway and Crafts Group, LLC. All Rights Reserved. # No. *A332429* Artist s Club. All rights reserved. For private, non-commercial use only. Please see our web site for terms of use.