105 SERIES REMOTE RECEIVER DECODERS

Transcription

1 Remote Decoder; Radio, Infra-Red, Pager 4 Channel Expandable To 15 Radio ; 433 / 458 / 868 MHz IP65 Rated Encloure Eay Intallation Via Screw Terminal 230Vac Or 12-30Vdc Supply 15 CMOS/TTL Channel O/P' Led Indication of Each. Momentary or Latching 1 Timed Adjutable 0 To 255 Sec Contact 230Vac (5A pk, 2.5A cont) Require No Radio Licence A general-purpoe Rx decoder which may operate a radio, infra-red or pager ytem. The unit i upplied in a tough ABS encloure with IP65 rating, complete and ready to operate. A a pager ytem (uing Globemater Module G100UK), the unit i a tand-alone pager controller. A a radio or infrared Rx decoder, the ytem may be upplied a one of everal option to enable the uer to chooe the optimum frequency modulation and range. The Rx decoder ha a elf-learning feature, which enable it to learn the ignature code of up to 50 individual RF Solution KEELOQ Tx encoder. Connection to the power upply and relay output are provided through crew terminal (thee are the only connection required). The output relay are rated 240Vac operating a either momentary of latched operation. An additional Low battery LED and relay i alo provided to indicate that the Tx encoder battery voltage i low. 1 ha a variable time feature, which may be adjuted to give a timed output (upto 4 minute). A further 15 momentary digital output are alo provided for expanion uing the 115 Expander (See dataheet DS115). Performance Table Modulation RF uency Tranmit Power (mw) Range ** Infra-Red AM QM FMNB 433NB FM ,000 Globemater See Dataheet DS100 The UK ** Range tated i optimum, direct line of ight. In wort condition thi can be reduced by over 50% (m) DS105-4 Aug Reg. No , England Page 1

2 Connection ANT SW1 LEARN SWITCH GND POWER LED LEARN LED BATT LOW LED J3 J7 J2 Connector to Expander J14 INFRA-RED HEADER VR1 RF RECEIVER / PAGER CH4 CH2 RLY 9 RLY 1 RLY 2 RLY 3 MAINS TRANSFORMER CH3 J9 J10 J11 J12 D8 D7 D10 D9 T1 F1 E N L 230Vac Main 0V Vdc CH4 RLY 4 J4 J5 The decoder require either a ingle Vac upply or 240Vac main. NOT BOTH! N/O COMM N/C N/O COMM N/C N/O COMM N/C N/O COMM N/C N/O COMM N/C LOW BATT O/P1 O/P2 O/P3 O/P4 Warning! The unit i deigned to be a fixed intallation, which may be connected to a main upply. Before removing the cover enure that the main input upply i removed. Any operation of the product that involve removal of the front cover hould only be carried out by a competent peron or qualified electrician. Configuration the (Jumper Link J2, J3) Thee link configure the operation of the digital output according to the table below. NOTE: The link tatu i read only on power up, after changing the link pleae to remove and re-apply power. The ytem i upplied with relay() type OMRON GL5114P or equivalent. Note: The uer mut enure that the load connected doe not overload the relay! J2 J3 RL 1 RL 2 RL 3 RL 4 Open Open Latch Latch Latch Latch Open Connected Timed Momentary Momentary Momentary Connected Open Latch Latch Momentary Momentary Connected Connected Timed Momentary Latch Latch Latch: The relay operate until the next valid tranmiion i received Momentary: The relay operate momentarily, or for a long a the Tx encoder witch i held on. Removing Timed : Turn the trimmer (VR1) fully anti Clockwie. Timed (O/P1) Thi i a variable timed output controlled by VR1. Thi may be adjuted from no delay to a maximum of 4 minute 15 econd. Turning VR1 anti-clockwie increae the output delay. To remove the timed delay (for either momentary or latching mode) turn the trimmer fully clockwie. DS105-4 Aug Reg. No , England Page 2

3 Low Battery The low battery feature inform the uer that the Tx encoder ued ha a low voltage battery. The LOW BATT channel operate if the Rx decoder ha received a tranmitted ignal with low voltage ignal preent. Thi will continue to operate until a tranmitted ignal without the low voltage ignal ha been received. NOTE: the LOW BATT relay i type BT47W/6 or equivalent. Expanding the ytem to 15 output The EX115C16A unit i available to connect directly to the 105 Serie Decoder providing 15 momentary relay output. For further information pleae ee Dataheet DS115. Learning A New Tranmitter Encoder 1. Pre and releae the programming witch (PSW1) 2. Note that the LED will illuminate 3. Depre and releae the tranmitter once, LED on the decoder will extinguih 4. Depre and releae the tranmitter again, LED on the decoder will flah 5. After the LED ha topped flahing the tranmitter ha been uccefully taught to the decoder 6. Thi tranmitter will now operate the ytem 7. To completely erae the tranmitter, pre PSW1 on the decoder for 10 econd. The LED will turn off after the 10 econd to indicate that the tranmitter() have been eraed Eraing Exiting Tx Encoder 1. To completely erae the Tx encoder, pre SW1 on the Rx decoder for 10 econd. 2. The learn LED will turn off after the 10 econd to indicate the Tx encoder() have been eraed NOTE: You can not erae individual Tx encoder **Range Pleae note that all radio ytem are dependant on a radio ignal being received through airpace. The range quoted i the optimal in direct line of ight without obtacle and in good atmopheric condition. Range i affected by many thing, e.g. local environmental condition, atmopheric condition, interference from other radio tranmitter. In very wore cae application the range quoted may be reduced to 30% of the optimal range tated. Technical Specification Dimenion: Encloure : 190 x 120 x 60 mm (PCB: 174 x 106mm) Storage Temperature; -10 to +70 o Celiu. Operating Temperature; 0 to +55 o Celiu. Electrical Characteritic Min Typical Max Unit Supply Voltage V Supply Current : Quiecent 25 ma Time from Encoder Switch depreed to Decoder 100 msec output change Time from Encoder Switch releae to Decoder output 300 msec change All operating 400 ma Rating (240Vac) RLY A Low Battery Rating (RLY9) 2 DS105-4 Aug Reg. No , England Page 3

4 102 SERIES RADIO / IR ENCODER TRANSMITTERS Highly Secure Protocol QM, FM or Infra Red uency Option; 315, 433, 915MHz LED Indication Of Tranmiion 1,2 or 4 Switch Verion Expandable To 15 Power Saving Auto Shut Off Feature Automatically Tranmit Battery Low Condition IP40 Rated Encloure Uer Cutomiable Overlay Board Level Programmable 315MHz verion FCC Compliant 433MHz verion EMC Compliant The RF Solution 102 range of tranmitter encoder are available a either FM, FMNB radio or Infra Red. The encoder ue the KEELOQ encryption algorithm providing the world mot advanced high ecurity protocol. Each encoder may be ued with one of RF Solution decoder, or with one of the KEELOQ decoder I/C. Alternatively, the uer may decode the KEELOQ algorithm and embed within a PIC Microcontrolller. (Pleae ee dataheet DS600). When paired with one of the KEELOQ Rx decoder board, a complete high ecurity code hopping remote control ytem may be achieved. The tranmitter i upplied a a complete product with battery ready to operate (PP3). Each encoder can be board level programmed with a pecific manufacturer ID code if required Cutom olution may alo be upplied unique to cutomer pecific requirement. Pleae contact RF Solution for further information. Block Diagram V CC ANTENNA SW5-15 SW4 SW3 SW2 SW1 FM TX KEELOQ MCU LED DS102-4 Sept Reg. No , England Page 1

5 102 SERIES RADIO / IR ENCODER TRANSMITTERS Low Battery When the unit meaure a low battery voltage level, the data tranmitted include a Low battery tatu flag to the receiver decoder. Power Supply The circuit ha been deigned to operate from a ingle PP3 battery upply. Thi will provide in exce of 1,000,000 tranmiion. Note: revere voltage polarity connection may caue damage to the circuit. Licene Exemption (Radio Tranmitter) Europe: The tranmitter encoder ue ECM compliant radio tranmitter module and complie with ETSI and ETSI USA: Thi device complie with part 15 of the FCC Rule. Operation i ubject to the following two condition: 1. Thi device may not caue harmful interference, and 2. Thi device mut accept any interference received, including interference that may caue undeired operation." KEELOQ Protocol Configuration Each encoder i upplied ready programmed with a unique random erial number. The decoder ha the ability to memorie thi erial number uing a imple learn procedure (pleae ee decoder dataheet). How doe KEELOQ technology work? KEELOQ i baed on a code hopping algorithm which provide Rock Solid Security. KEELOQ ue a programmable 64-bit encryption key that i unique to each device to generate 32-bit hopping code. The key length and hopping code combination reduce the poibility of unwanted acce, due to code grabbing and code canning, to eentially zero. Such CIA-like level of ecurity are deirable, but many manufacturer would expect them to be cot-prohibitive. KEELOQ offer the olution for affordable, Rock Solid Security that i the future of technology for the car, home and office we wih to protect. Adding Additional Switche Additional witche may be added through Connector J1. The four connection of J1-1, 2, 3, & 4 repreent the four input line to the HCS360 encoder device. Thee may be connected to a binary coded decimal (bcd) input to obtain 1 of 16 tate. Connection J1-6 i connected to V CC. Abolute Maximum Rating Supply Voltage (V CC to GND) Storage Temperature Operating Temperature Dimenion +5.5 to Volt -10 C to +70 C 0 C to +55 C 110mm x 65mm x 24mm Electrical Characteritic Min Typical Max Dimenion Supply Voltage V Supply Current ma uency 315MHz FM 433MHz QM / FM Wideband MHz 433MHz FM Narrow band 915MHz Narrow band RF Power 433 MHz - 10 mw DS102-4 Sept Reg. No , England Page 2

6 102 SERIES RADIO / IR ENCODER TRANSMITTERS FM102 QM Serie Encoder (Red Tranmit LED) 102C1-433QR1 QM Encoder 1 Sw C2-433QR1 QM Encoder 2 Sw C4-433QR1 QM Encoder 4 Sw Decoder FM-001B-433 FM FM-008C4B-433 U105C4A-433 FM102 FM Serie Encoder (Yellow Tranmit LED) 102C1-315FR1 FM Encoder 1 Sw C2-315FR1 FM Encoder 2 Sw C4-315FR1 FM Encoder 4 Sw C1-433FR1 FM Encoder 1 Sw C2-433FR1 FM Encoder 2 Sw C4-433FR1 FM Encoder 4 Sw Decoder FR FR FR FR FR FR2 FM102 Narrow Band Serie Encoder (Red Tranmit LED) 102C1-433NBFR1 FM Narrow Band Enc 1 Sw C2-433NBFR1 FM Narrow Band Enc 2 Sw Decoder 105C4-433NBFR2 102C4-433NBFR1 FM Narrow Band Enc 4 Sw IR102 Serie Infra-Red Encoder (Red Tranmit LED) 102C1-IR2 Infra Red Encoder 1 Sw C1-IR2 Infra Red Encoder 2 Sw 20 Decoder IR-105C4A 102C1-IR2 Infra Red Encoder 4 Sw 20 Should you require further aitance pleae contact R. F. Solution Ltd., Unit 21, Cliffe Indutrial Etate, South Street, Lewe, E Suex, BN8 6JL, England Tel +44 (0) Fax +44 (0) ale@rfolution.co.uk R F Solution i a member of the Low Power Radio Aociation. All Trademark acknowledged and remain the property of the repected owner. Information contained in thi document i believed to be accurate, however no repreentation or warranty i given and R.F. Solution Ltd. aume no liability with repect to the accuracy of uch information. Ue of R.F.Solution a critical component in life upport ytem i not authoried except with expre written approval from R.F.Solution Ltd. DS102-4 Sept Reg. No , England Page 3

7 ing AM105 Serie Decoder RFSL Encoder AM-105C3A AM-Superegen Decoder 45 AM-030 Serie Univeral IR, AMS and QM Serie Decoder RFSL Encoder U105C4A Univeral Decoder AM-110 Serie 102C-433Q Serie IR106 Serie IR102 Serie FM105 Serie Decoder FR C4A-433NBFR C4A-458FR FM 433 Radio Module for increaed Range FM 433 Narrow Band Radio Module for increaed Range Long Range Remote Control RFSL Encoder F Serie NB, NB Serie NB, NB Serie G105 Serie Decoder RFSL Encoder G C4A 4 N/A Pager Baed Unit The UK Any DTMF Telephone ** Range tated i optimum, direct line of ight. In wort condition thi can be reduced by over 50% For more information or general enquirie, pleae contact R. F. Solution Ltd., Unit 21, Cliffe Indutrial Etate, South Street, Lewe, E Suex, BN8 6JL. England Tel +44 (0) Fax +44 (0) ale@rfolution.co.uk RF Solution i a member of the Low Power Radio Aociation Information contained in thi document i believed to be accurate, however no repreentation or warranty i given and R.F. Solution Ltd. aume no liability with repect to the accuracy of uch information. Ue of R.F.Solution a critical component in life upport ytem i not authoried except with expre written approval from R.F.Solution Ltd. DS105-4 Aug Reg. No , England Page 4