DC-8.0 GHz InGaP HBT, MMIC or Packaged, Matched Gain Block Amplifier

Transcription

1 Features.5 6 GHz MHz 36.0 m Output 850 MHz Noise 850 MHz 20.3 m 850 MHz Low Performance Variation Over Temperature Low Cost: Die Form or SOT-8 Package 100% DC On-Wafer Testing ESD Protection on All Die: >1000V HBM Low Thermal Resistance: <ºC/Watt Applications PA Driver Amp, IF Amp, LO Buffer Amp Cellular, PCS, GSM, UMTS Wireless Data and SATCOM WLAN 2.11a/b/g and WiMAX Transmit and Receive Functions CATV Description The is a Darlington Configured, high dynamic range, utility gain block amplifier. Designed for applications operating within the DC to 8.0 GHz frequency range, Mimix s broadband, cascadable, gain block amplifiers are ideal solutions for transmit, receive and IF applications. These MMIC amplifiers are available in bare die form or an industry standard SOT-8 package. Mimix's InGaP HBT technology and an industry low thermal resistance offers a Functional Block Diagram (SOT-8) Ground Input Ground Output Bias Absolute Maximum Ratings Max Device Voltage Max Device Current Max Device Dissipated Power RF Input Power Storage Temperature Junction Temperature Operating Temperature Thermal Resistance EDS (HBM) +6.0 V 130 ma 0.65 W + m -55ºC to 150ºC 150ºC -0ºC to +85ºC º C/W 1000 V Operation of this device above any of these parameters may cause permanent damage. thermally robust and reliable gain block solution. The InGaP HBT die have extra pads to enable thorough DC testing. This unique test capability and the inclusion of ESD protection on all die, significantly enhances the quality, reliability and ruggedness of these products. With a single bypass capacitor, optional RF choke and two DC blocking capacitors, this gain block amplifier offers significant ease of use in a broad range of applications. Electrical Characteristics Unless otherwise specified, the following specifications are guaranteed at room temperature in a Mimix test fixture. Parameter Small Signal Gain Output P1 Output IP3 Noise Figure Operating Current Input Return Loss Output Return Loss -5 c, ACP IS-5, Forward Channels Temperature (ºC) -0 to to to to to to to to MHz 150 MHz 200 MHz 3500 MHz 6000 MHz Units m m m m ma ma m m Notes: 1. Test Conditions in Mimix eval board, Vs = 8 V, Id = ma, Rbias = 3, Zs = Zl = 50, OIP3 tone spacing = 1 MHz, Pout per tone = 6 m. 2. Values reflect performance in recommended application circuit. Mimix Broadband, Inc., 1075 Rockley Rd., Houston, Texas 770 Page 1 of 7 Tel: Fax: mimixbroadband.com

2 Typical S-Parameter and Noise Performance 26 S21 Vs Frequency - S11 Vs Frequency C -8-0 C S21 () 20 1 S11 () S Vs Frequency - S22 Vs Frequency C -8-0 C S () S22 () Noise Figure Vs Frequency Noise Figure () C Mimix Broadband, Inc., 1075 Rockley Rd., Houston, Texas 770 Page 2 of 7 Tel: Fax: mimixbroadband.com

3 Typical Power and Linearity Performance P1 (m) P1 Vs Frequency C OIP3 (m) OIP3 Vs Frequency 1 MHz separation, 6 m/tone C Linearity Performance - Base Station ACP IS MHz Vs Pout Channels Forward, 750 khz Offset 30 khz BW -5 Alt1 Ch. 850 MHz Vs Pout Channels Forward, 1.8 MHz Offset 30 khz BW ACP (c) C ACP (c) C Pout (m) Pout (m) MHz Vs. Pout Forward Channels, 885 khz Offset 30 khz BW -0 Alt1 Ch. 150 MHz Vs Pout Channels Forward, 1.25 MHz Offset.5 khz BW -0-0 C C ACP (c) ACP (c) Pout (m) Pout (m) Mimix Broadband, Inc., 1075 Rockley Rd., Houston, Texas 770 Page 3 of 7 Tel: Fax: mimixbroadband.com

4 Typical Scattering Parameters (Vd = +.75V, Icc = 77 ma, T = 23 C, device in a 50 ohm system) Frequency S 11 S 21 S S 22 (MHz) (Mag) (Ang) (Mag) (Ang) (Mag) (Ang) (Mag) (Ang) Continues Next Page. S-Parameter Data Files are available on-line at: Mimix Broadband, Inc., 1075 Rockley Rd., Houston, Texas 770 Page of 7 Tel: Fax: mimixbroadband.com

5 Typical Scattering Parameters (Vd = +.75V, Icc = 77 ma, T = 23 C, device in a 50 ohm system) Frequency S 11 S 21 S S 22 (MHz) (Mag) (Ang) (Mag) (Ang) (Mag) (Ang) (Mag) (Ang) S-Parameter Data Files are available on-line at: Mimix Broadband, Inc., 1075 Rockley Rd., Houston, Texas 770 Page 5 of 7 Tel: Fax: mimixbroadband.com

6 Application Circuit Note: This schematic represents the topology of the application circuit recommended by Mimix. Recommended Bias Resistor Values for ID = ma Supply Voltage (V) 7V 8V 10V V Rbias (R1 Description: 06 1/W 1%) 25 3 Rbias (R1 Description: 10 1/2W 1%) 6 8 Note: Rbias provides DC bias stability over temperature. Vs RF IN R Bias = (Vs - Vd) / Id R1 1 C1 2 3 C3 uuuu L1 C2 Vd RF OUT Ref Designator Value Description Size C1, C pf MCH5A101JK 05 C3 1.0 F VITR 1.0 F 25V CER 05 CAP 05 X7R 10% L1 56 nh Coilcraft 0603 CS 10% 0603 R 1 R Bias = (Vs - Vd) / Id 06 / 10 C DNP (Do Not Place) N/A Mimix Broadband, Inc., 1075 Rockley Rd., Houston, Texas 770 Page 6 of 7 Tel: Fax: mimixbroadband.com

7 Physical Dimensions - SC Package (SOT-8).50 [0.7] 1.73 [0.068] 0.71 [0.028] 1.55 [0.061] 0.38 [0.015] 1.70 [0.067] 0.1 [0.0] XXXXXXX XXXXXX ZYYWW 2.50 [0.06] 2.06 [0.081].1 [0.3] 3.8 [0.137] 5.33 [0.210] [0.] 3X 1.50 [0.05] 3.00 [0.1] 0. [0.03] 0.76 [0.030] 0.38 [0.015] DIMENSIONS IN MILLIMETERS [INCHES] 0.58 [0.023] 0.6 [0.025] 3.86 [0.152] 1.27 [0.050] 0.86 [0.03] MARKINGS: XXXXXXX = MIMIX MODEL NO. XXXXXX = WAFER LOT NO. ZYYWW = DATE CODE (YR/WEEK) FIRST LETTER COUNTRY OF ORIGIN IF OTHER THAT USA Physical Dimensions - BD (Bare Die) Ordering Information Part Number for Ordering CGB701-BD CGB701-SC-0G00 CGB701-SC-0G0T CGB701-SP-0G00 CGB701-SP-0G0T PB-CGB701-SC-0000 PB-CGB701-SP-0000 Description Bare die in GelPak Matte Tin plated RoHS compliant SOT-8 surface mount package in bulk quantity Matte Tin plated RoHS compliant SOT-8 surface mount package in tape and reel Matte Tin plated RoHS compliant SOT-86 surface mount package in bulk quantity Matte Tin plated RoHS compliant SOT-86 surface mount package in tape and reel Evaluation Board for SOT-8 packaged device with SMA connectors Evaluation Board for SOT-86 packaged device with SMA connectors We also offer the plastic packages with SnPb (Tin-Lead) or NiPdAu plating. Please contact your regional sales manager for more information regarding different plating types Mimix Broadband, Inc., 1075 Rockley Rd., Houston, Texas 770 Page 7 of 7 Tel: Fax: mimixbroadband.com