1500 UNDERGROUND J-BOXES & VAULTS

Transcription

1 00 UNDEGOUND J-BOXES & VAULTS //0 C UE4-UE Secondary J-Box " x 0" x " Deep ~ UJ Primary Junction Box Single Phase ~ UJ Primary Junction Box Three Phase ~ UJ Primary Ø Padmount Junction Box pad ~ UJM Primary Junction Box Single & Three Phase Material List ~ ULE Loop Enclosure ~ UVG,UVG Underground Vault Grounding System ~ UVN Installation of Telephone Ground at Padmount Transformers and Junction Boxes N New Standard edrawn Standard C Changed Standard ~ No Change

2 LOAD SOUCE LOAD GOUND LEVEL IN SIDEWALK TOP VIEW 4" GOUND LEVEL IN FLOWE BED O GASS STACK SUBMESIBLE PED'S VETICALLY "-4" SIDE VIEW ESIDENTAL- UP TO 0 KCM COMMECIAL - UP TO 00 KCM NOTES:. DO NOT INSTALL S/N IN STEETS, ALLEYS, O HIGHWAYS.. CUT ALL CABLES LONG ENOUGH TO ALLOW MAKEUP TO BE DONE ABOVE THE BOX TOP WITH CABLES IN AN APPOXIMATELY VETICAL POSITION.. BEND CABLES DOWN AFTE MAKEUP SO THAT LID CAN BE INSTALLED. 4.. USE SILICONE GEASE ON ALL ALLEN WENCH PLUGS AND CABLE BOOTS (BOTH ENDS). IF ADDITIONAL DEPTH IS NEEDED, PLACE ONE BOX UPSIDE DOWN, BOLT THE BOXES TOGETHE AND SALVAGE ONE LID. (S/N ONLY). ev : emoved all Fiberglass box (S/N ), added Notes for occasional and heavier traffic areas, and updated material issue SECONDAY JUNCTION BOX " x 0" x " DEEP DATE ENG OPS //00 HWH MA //0 JEH T 0// CM DK of UE4,UE,UE,UE4,UE,UE UE4 JEH //00 00

3 OCCASIONAL TAFFIC AEAS (S/N ): ATED 0,000 POUNDS THIS BOX IS NOT FO USE IN STEETS, ALLEY O HIGHWAYS DO NOT USE IN DIVEWAYS IF LOCATION IS PAT OF THE NOMAL TAVELED WAY HEAVIE TAFFIC AEAS (S/N 0): ATED 0,000 POUNDS THIS BOX IS 4" x " x " MAY BE USED IN ALLEYS O DIVEWAYS-ONLY ATED 0k DO NOT USE IN STEETS O HIGHWAYS ev : emoved all Fiberglass box (S/N ), added Notes for occasional and heavier traffic areas, and updated material issue Secondary J-Box " x 0" x " (H Is 4" x " x ") Connector, Submersible, Sec., 4 Position, #0 to 00 MCM Al/Cu Secondary J-Box " x 0" x " (H Is 4" x " x ") Connector, Submersible, Sec., Position, #0 to 00 MCM Al/Cu Secondary J-Box " x 0" x " (H Is 4" x " x ") Connector, Submersible, Sec., Position, # to 00 MCM Al/Cu Secondary J-Box " x 0" x " (H Is 4" x " x ") Connector, Submersible, Sec., 4 Position, #0 to 00 MCM Al/Cu Secondary J-Box " x 0" x " (H Is 4" x " x ") Connector, Submersible, Sec., Position, #0 to 00 MCM Al/Cu Secondary J-Box " x 0" x " (H Is 4" x " x ") Connector, Submersible, Sec., Position, # to 00 MCM Al/Cu SECONDAY JUNCTION BOX " x 0" x " DEEP UE4H UEH UEH 4 UE4H 4 0 UEH UEH UE4 UE UE 4 UE4 4 0 UE 0 4 UE 4 4 DATE ENG OPS //00 HWH MA //0 JEH T 0// CM DK of UE4,UE,UE,UE4,UE,UE UE4 JEH //00 00

4 J OUT (LOAD) IN (SOUCE) " FUTUE " 4" " Notes:. TYPICAL ELBOW AANGEMENT IS SHOWN.. DO NOT PUT DIT INSIDE JUNCTION BOX. SPACE IS EQUIED FO CABLE SLACK AND OPEATING CLEAANCE.. LEAVE CABLE SLACK FO FUTUE OPEATIONS. LEGEND: FAULT INDICATO NOMALLY OPEN (ON STANDOFF BACKET) ev 4: Changed to Voltage-reset fault indicators and added equipment lock. UJM4 UJM4 Ground od /" x ' UJM4 Clamp, Ground od /", Small UJM4 UJM44 UJM4 UJM4 MATEIAL LIST UJM4 UJM4 UJM4 Junction Box, Ø 4 4 Equipment Lock, UG DATE ENG OPS PIMAY JUNCTION BOX SINGLE PHASE QTY S/N 4 //00 HWH MA //04 LB AH //04 LB AH 4 4//0 CM AH of UJ UJ JEH //00 00

5 " BACK " " FOM EDGE " CONDUIT " LEFT SIDE " CONDUIT FUTUE FEEDS OUT GOUND OD AT CENTE OF J-BOX IGHT SIDE FONT PLAN VIEW -PHASE J-BOX ev 4: Changed to Voltage-reset fault indicators and added equipment lock. PIMAY JUNCTION BOX SINGLE PHASE DATE ENG OPS //00 HWH MA //04 LB AH //04 LB AH 4 4//0 CM AH of UJ UJ JEH //00 00

6 J 4 0 A B C 0" " FUTUE CL NOTES: ". TYPICAL ELBOW AANGEMENT IS SHOWN.. DO NOT PUT DIT INSIDE JUNCTION BOX. SPACE IS EQUIED FO CABLE SLACK AND OPEATING CLEAANCE.. LEAVE CABLE SLACK FO FUTUE OPEATIONS. 4" LEGEND: FAULT INDICATO NOMALLY OPEN (ON STAND OFF BACKET) ev : Changed to Voltage-reset fault indicators and added equiment lock. UJM4 UJM4 UJM4 UJM4 UJM44 UJM4 UJM4 UJM4 UJM4 UJM4 Ground od /" x ' Clamp, Ground od, Small Junction Box, Ø MATEIAL LIST 4 Equipment Lock, UG PIMAY JUNCTION BOX THEE PHASE QTY DATE ENG S/N 4 04 OPS 0 //00 HWH MA //04 LB AH //04 LB AH 4//0 CM AH of UJ UJ AH //00 00

7 " AØ BACK BØ " CØ 4" 4" O " CONDUITS " LEFT SIDE CL 4" O " FUTUE CONDUITS L C GOUND OD AT CENTE OF J-BOX IGHT SIDE FONT PLAN VIEW -PHASE J-BOX 4" J-4 FONT FINAL GADE 4" MAX. GOUND OD " FINAL GADE " " SWEEP 4" MAXIMUM 4" PVC CONDUIT PIMAY J-BOX CONDUIT AANGEMENT ev : Changed to Voltage-reset fault indicators and added equiment lock. PIMAY JUNCTION BOX THEE PHASE DATE ENG OPS 0 //00 HWH MA //04 LB AH //04 LB AH 4//0 CM AH of UJ UJ AH //00 00

8 PLAN " " " MAK A " A " MAK B-0 KINDOF CHANNEL " '-4" OPENING " WELD CHANNEL TO EBA MAK " " MAK " " " " " " " 4 " 4 " 4'-" 4" " "A-A" NOTE: EINFOCING SCHEDULE MAK SIZE LENGTH EMAKS 4 /" '-0" STAIGHT 4 /" 4'-" STAIGHT ALL CONCETE SHALL BE --4 AND HAVE A SLUMP OF 4" TO " EINFOCING SHALL CONFOM TO A.S.T.M. DESIGNATION A AND A0. TOWEL SMOOTH SUFACES AND BUSH FINISH. OUND ALL EDGES, PIMAY Ø PADMOUNT JUNCTION BOX PAD DATE ENG 0 //0 OPS of UJ UJ 0 EDAWN IN CAD ELM //0 00

9 ev : Changed to Voltage-reset fault indicators. Elbow, Loadbreak, /0, 00A, mil Cap, Protective Insulated, 00A U.G. 0 UJM ft 0 Elbow, Loadbreak, /0, 00A, mil Voltage-eset Fault Indicator, 400A Trip, Ø UG Bushing, Standoff Insul. 00A Cap, Protective Insulated, 00A U.G. UJM ft 0 Elbow, Loadbreak, /0, 00A, mil Voltage-eset Fault Indicator, 400A Trip, Ø UG Bushing, Standoff Insul. 00A Cap, Protective Insulated, 00A U.G. UJM4 0 ft Elbow, Loadbreak, /0, 00A, mil Voltage-eset Fault Indicator, 400A Trip, Ø UG Bushing, Standoff Insul. 00A Cap, Protective Insulated, 00A U.G. UJM ft Elbow, Loadbreak, /0, 00A, mil Voltage-eset Fault Indicator, 400A Trip, Ø UG Cap, Protective Insulated, 00A U.G. UJM ft 4 4 PIMAY JUNCTION BOX SINGLE AND THEE PHASE MATEIAL LIST of UJM UJM DATE ENG OPS 0 //00 HWH MA //04 LB AH //04 LB AH 4//0 CM AH JEH //00 00

10 0 ev : Changed to Voltage-reset fault indicators. Elbow, Loadbreak, /0, 00A, mil Voltage-eset Fault Indicator, 400A Trip, Ø UG Bushing, Standoff Insul. 00A Cap, Protective Insulated, 00A U.G. UJM ft 0 Elbow, Loadbreak, /0, 00A, mil Voltage-eset Fault Indicator, 400A Trip, Ø UG Bushing, Standoff Insul. 00A Cap, Protective Insulated, 00A U.G. UJM ft 0 Elbow, Loadbreak, /0, 00A, mil Voltage-eset Fault Indicator, 400A Trip, Ø UG Cap, Protective Insulated, 00A U.G. UJM ft 0 Elbow, Loadbreak, /0, 00A, mil Voltage-eset Fault Indicator, 400A Trip, Ø UG Bushing, Standoff Insul. 00A Cap, Protective Insulated, 00A U.G. UJM4 4 0 ft Elbow, Loadbreak, /0, 00A, mil Voltage-eset Fault Indicator, 400A Trip, Ø UG UJM ft PIMAY JUNCTION BOX SINGLE AND THEE PHASE MATEIAL LIST of UJM UJM DATE ENG OPS 0 //00 HWH MA //04 LB AH //04 LB AH 4//0 CM AH JEH //00 00

11 GOUND LEVEL " GOUND LEVEL 00 UG J-Box/Vault DO NOT GLUE ELBOWS TO CONDUIT MATEIAL LIST CABLE LOOP ENCLOSUE MAKE, UG, FULL ANGE, DISC QTY. S/N 0 00 UG J-Box/Vault NOTES:. BUY APPOXIMATELY ONE FOOT OF THE ENCLOSUE.. CONDUITS SHALL BE BUIED 4" TO 4" DEEP UNLESS OTHEWISE APPOVED BY CPU.. THE DISC MAKE IS TO BE INSTALLED FLAT WITH THE INSTUCTIONS FACING UP. 4. THE DISC SHOULD BE PLACED IN ADIUS OF ELBOW.. CPU HAS THE LOCATO FO FINDING THESE MAKES.. THE MAKES AE EUSABLE.. LOOP ENCLOSUES AND MAKE DISCS POVIDED BY CPU. EV - MEGED WITH STD. UBM AND UPDATED FO ALL-CONDUIT SYSTEM. LOOP ENCLOSUE DATE ENG OPS 0 //04 LB AH //04 LB AH of ULE ULE 0 KP 00

12 VAULT BOTTOM WALL KNOCKOUT INSTALL GOUND ODS AND OUTSIDE /0 COPPE BEFOE VAULT IS INSTALLED. FEED /0 TAPS FOM OUTSIDE GOUND THOUGH VAULT WALL KNOCKOUTS. 4 FO NEW VAULTS UVG- VAULT BOTTOM CUT GOUND ODS IN HALF. DIVE ONE HALF. COUPLE ON SECOND HALF AND DIVE SO THAT ONLY THE CLAMP IS EXPOSED ABOVE THE FLOO. 4 UNDEGOUND VAULT GOUNDING SYSTEM FO EXISTING VAULTS UVG- DATE ENG OPS 0 //00 HWH MA of UVG-, UVG- UVG- 0 JEH //00 00

13 NOTE: INSTALL GOUNDING LUG TO TANK * - GOUNDING LUG * BY TELEPHONE TELEPHONE CLOSUE NOTE: IN JOINT TENCH INSTALLATIONS A #4 CU. GOUND, FO TELEPHONE USE, FOM THE CONCENTIC NEUT. MUST BE POVIDED AT INTEVALS NOT TO EXCEED 000 FT. 0' OF #4 CU. # CU. MIN. BY TELEPHONE COMPANY EV - CHANGES MAKED WITH STA; ADDED GOUNDING LUG & CENTE GOUNDING OD EV - MINO DAWING CHANGES INSTALLATION OF TELEPHONE GOUND AT PADMOUNT TANSFOMES O PHASE JUNCTIONS of UVN UVN DATE ENG OPS //00 HWH MA //0 JEH T MINO DAWING CHANGES JEH //00 00