Premium Report PREPARED FOR. 123 Main St., City, ST Report: Sample TABLE OF CONTENTS MEASUREMENTS. February 21, 2017

Transcription

1 TABL OF COTT Images...1 Length Diagram...4 Pitch Diagram...5 Area Diagram...6 otes Diagram...7 Report ummary...8 In this 3D model, facets appear as semi-transparent to reveal overhangs. MAURMT Total Roof Area =6,788 sq ft Total Roof Facets =26 Predominant Pitch =/12 umber of tories <=1 Total Ridges/Hips =435 ft Total Valleys =288 ft Total Rakes =4 ft Total aves =276 ft PRPARD FOR Contact: Company: xteriors Company Address: 321 Main t. City, T Phone: Measurements provided by

2 IMAG The following aerial images show different angles of this structure for your reference. Top View PAG 1

3 IMAG orth ide outh ide PAG 2

4 IMAG ast ide est ide PAG 3

5 LGTH DIAGRAM Total Line Lengths: Ridges = 120 ft Hips = 315 ft Valleys = 288 ft Rakes = 4 ft aves = 276 ft Flashing = 3 ft tep flashing = 16 ft Parapets = 0 ft agleview Technologies, Inc. 19 ote: This diagram contains segment lengths (rounded to the nearest whole number) over 5 feet. In some cases, segment labels have been removed for readability. Plus signs preface some numbers to avoid confusion when rotated (e.g. +6 and +9). PAG 4

6 PITCH DIAGRAM Pitch values are shown in inches per foot, and arrows indicate slope direction. The predominant pitch on this roof is / agleview Technologies, Inc. ote: This diagram contains labeled pitches for facet areas larger than 20 square feet. In some cases, pitch labels have been removed for readability. Blue shading indicates a pitch of 3/12 and greater. PAG 5

7 ARA DIAGRAM Total Area = 6,788 sq ft, with 26 facets agleview Technologies, Inc ote: This diagram shows the square feet of each roof facet (rounded to the nearest foot). The total area in square feet, at the top of this page, is based on the non-rounded values of each roof facet (rounded to the nearest square foot after being totaled). PAG 6

8 OT DIAGRAM Roof facets are labeled from smallest to largest (A to Z) for easy reference. T L U P G A B X Q Y J R K 2015 agleview Technologies, Inc. V Z H I O M F D C ote: This diagram also appears in the Property Owner Report PAG 7

9 Premium Report RPORT UMMARY Areas per Pitch Roof Pitches /12 Area (sq ft) % of Roof 0% The table above lists each pitch on this roof and the total area and percent (both rounded) of the roof with that pitch. aste Calculation Table aste % 0% % 12% 15% 17% 20% 22% Area (sq ft) 6,788 7,467 7,603 7,806 7,942 8,146 8,281 quares This table shows the total roof area and squares (rounded up to the nearest decimal) based upon different waste percentages. The waste factor is subject to the complexity of the roof, individual roofing techniques and your experience. Please consider this when calculating appropriate waste percentages. ote that only roof area is included in these waste calculations. Additional materials needed for ridge, hip, valley, and starter lengths are not included. Total Roof Facets = agleview Technologies, Inc. Lengths, Areas and Pitches Ridges = 120 ft (12 Ridges) Hips = 315 ft (14 Hips). Valleys = 288 ft (17 Valleys) Rakes * = 4 ft (12 Rakes) aves/tarter ** = 276 ft (26 aves) Drip dge (aves + Rakes) = 390 ft (38 Lengths) Parapet alls = 0 (0 Lengths). Flashing = 3 ft (2 Lengths) tep flashing = 16 ft (2 Lengths) Total Area = 6,788 sq ft Predominant Pitch = /12 Property Location Longitude = Latitude = otes This was ordered as a residential property. There were no changes to the structure in the past four years. Online Maps Online map of property Directions from xteriors Company to this property * Rakes are defined as roof edges that are sloped (not level). ** aves are defined as roof edges that are not sloped and level. PAG 8