Precise Aerial Roof Measurement Report

Transcription

1 Precise Aerial Roof Measurement Report ugar Land - 49 Prepared for you by RoofBidders RoofBidders.com 6200 avoy Dr., te 1165 Houston, TX 036 Ron Glaser tel orders@roofbidders.com

2 TABL OF COTT Images...1 Length Diagram...4 Pitch Diagram...5 Area Diagram...6 otes Diagram... Report ummary...8 MAURMT Total Roof Area =3,306 sq ft Total Roof Facets =26 Predominant Pitch =8/12 umber of tories Unknown Total Ridges/Hips =365 ft Total Valleys =204 ft Total Rakes =5 ft Total aves = ft In this 3D model, facets appear as semi-transparent to reveal overhangs. PRPARD FOR Contact: Ron Glaser Company: RoofBidders Address: 6200 avoy Dr uite 1165 Houston, TX 036 Phone: Measurements provided by

3 IMAG The following aerial images show different angles of this structure for your reference. Top View PAG 1

4 IMAG orth ide outh ide PAG 2

5 IMAG ast ide est ide PAG 3

6 LGTH DIAGRAM Total Line Lengths: Ridges = 63 ft Hips = 302 ft Valleys = 204 ft Rakes = 5 ft aves = ft Flashing = 10 ft tep flashing = 19 ft Parapets = 0 ft agleview Technologies, Inc ote: This diagram contains segment lengths (rounded to the nearest whole number) over 5 feet. In some cases, segment labels have been removed for readability. Plus signs preface some numbers to avoid confusion when rotated (e.g. +6 and +9). PAG 4

7 agleview Technologies, Inc. PITCH DIAGRAM Pitch values are shown in inches per foot, and arrows indicate slope direction. The predominant pitch on this roof is 8/ ote: This diagram contains labeled pitches for facet areas larger than 20 square feet. In some cases, pitch labels have been removed for readability. Blue shading indicates a pitch of 3/12 and greater. PAG 5

8 ARA DIAGRAM Total Area = 3,306 sq ft, with 26 facets agleview Technologies, Inc ote: This diagram shows the square feet of each roof facet (rounded to the nearest foot). The total area in square feet, at the top of this page, is based on the non-rounded values of each roof facet (rounded to the nearest square foot after being totaled). PAG 6

9 OT DIAGRAM Roof facets are labeled from smallest to largest (A to Z) for easy reference. M T L H R I D C Y U X 2016 agleview Technologies, Inc. Z O G F V P A B Q K J PAG

10 RPORT UMMARY Areas per Pitch Roof Pitches 8/12 9/12 12/12 Area (sq ft) % of Roof 54.9% 0.8% 44.3% The table above lists each pitch on this roof and the total area and percent (both rounded) of the roof with that pitch. aste Calculation Table aste % 0% 10% 12% 15% % 20% 22% Area (sq ft) 3,306 3,63 3,03 3,802 3,868 3,96 4,033 quares This table shows the total roof area and squares (rounded up to the nearest decimal) based upon different waste percentages. The waste factor is subject to the complexity of the roof, individual roofing techniques and your experience. Please consider this when calculating appropriate waste percentages. ote that only roof area is included in these waste calculations. Additional materials needed for ridge, hip, valley, and starter lengths are not included. Total Roof Facets = agleview Technologies, Inc. Lengths, Areas and Pitches Ridges = 63 ft (9 Ridges) Hips = 302 ft (18 Hips). Valleys = 204 ft (13 Valleys) Rakes * = 5 ft (8 Rakes) aves/tarter ** = ft (20 aves) Drip dge (aves + Rakes) = 252 ft (28 Lengths) Parapet alls = 0 (0 Lengths). Flashing = 10 ft (4 Lengths) tep flashing = 19 ft (3 Lengths) Total Area = 3,306 sq ft Predominant Pitch = 8/12 * Rakes are defined as roof edges that are sloped (not level). ** aves are defined as roof edges that are not sloped and level. PAG 8