Page 1 of 14 Report No Test Report 2119: EOPENBOX LIMITED. Product: OPENBOX V8S. Commercial-In-Confidence

Transcription

1 Page 1 of 14 Report No Test Report 2119: EOPENBOX LIMITED Product: OPENBOX V8S Commercial-In-Confidence Date: September 21 st 2016

2 Page 2 of 14 Report No CONTENTS Section Page 1.0 Report Summary Introduction and Conclusions Product Photographs Conducted Emissions Radiated Emissions 11

3 Page 3 of 14 Report No Test Report Number : Date of issue : Number of pages : 2119 September 21st TEST REPORT SUMMARY : CONDUCTED & RADIATED EMISSIONS EMC TESTING OPENBOX V8S SATELLITE RECEIVER Applicants Name: Address: OPENBOX LTD 7 HARROW AVENUE MANCHESTER M19 1PF Factory: CHINA FACTORY Test specification : EN 55022:2010 / EN :2007 Item description : SATELLITE RECEIVER Model Type: V8S Ratings : V AC 50/60Hz (PSU) 12V DC 1.5A Serial number : 0PHDV81608X05215 Summary of testing: Clause Description Testing Location - Conducted emissions EMC test - Radiated emissions EMC test KBO Dynamics International Ltd. Unit 3 Hare Law Industrial Estate Stanley County Durham Telephone EMC testing: Test standards: EN 55022:2010 / EN :2007 Testing Verdict Key: N/A = None applicable to the standard. F = Does not meet the requirements of the standard. P = Meets the requirements of the standard. Tested by : Colin Arrowsmith (KBO Dynamics) Approved by: Andy Fallon (KBO Dynamics)

4 Page 4 of 14 Report No Introduction and Conclusions The tests indicated in the table below were performed on the product specified as described in section 1.0 of this document. Based on the results of our investigation, we have concluded that the product tested complies with the requirements of the standards referenced. In accordance to the immunity requirements for European CE Mark, the product was continuously monitored during the duration of all tests. No errors or degradation in performance was observed. Section Test Type Specifications / Standard Result EN 55022:2010 Referencing : 4.0 Conducted Emissions EN :2007 PASS 5.0 Radiated Emissions EN :2007 PASS

5 Page 5 of 14 Report No Test Report This document is an EMC testing report intended to form part of a technical construction file to demonstrate that the product has been assessed for radiated and conducted emissions compliance with reference to : EN 55022:2010 / EN :2007 Electromagnetic compatibility (EMC) Part 6-3: Generic standards Emission standard for residential, commercial and light-industrial environments. A technical construction file must include a report or certificate asserting EMC compliance. As with the standards route to conformity, the manufacturer is ultimately responsible for the Declaration of Conformity. A manufacturer has to show that the product in question is designed to meet the EMC and safety requirements of the operating environment. This is accomplished by showing that appropriate measures have been taken in the design, which are verified by test data and/or a theoretical assessment. Equipment Used Summary Conducted emissions tests were performed using a Line Impedance Stabilization Network (LISN), which is designed to eliminate the effects of mains line impedance variations due to local influences, such as distance from bulk supply point, supply cable impedance etc. The measurements were made using a PMM Model 8010 signal Analyser and Artificial Mains Network (LISN) Type L2-16 and associated PC software. The analyzer sweeps a set of filters across a pre-determined frequency band and in software selectable increments, over the range of 9kHz to 30MHz. The amplitude of the measured voltage at each increment is displayed graphically on a logarithmic scale. Radiated emissions testing were performed with a Rhode & Schwartz (Hameg) HMS spectrum analyser & control/report software scan 30MHz - 1GHz (Semi-Anechoic Chamber). AARONIA Broadband Antenna 30MHz - 1GHz (3m). Test Conditions Test conditions, powered with 230V 50 Hz to PSU. 12V DC from PSU to EUT.

6 Page 6 of 14 Report No Product Photographs Figure 1 : Product Photograph : Top View Figure 2 : Product Photograph : Front View

7 Page 7 of 14 Report No Figure 3 : Product Photograph : Bottom View Figure 4 : Product Photograph : Back View

8 Page 8 of 14 Report No Conducted Emissions Specification Reference EN55022 / EN :2007 Electromagnetic compatibility (EMC) Emission standard for residential, commercial and light-industrial environments Equipment Under Test (EUT) OPENBOX V8S SATELLITE RECEIVER Date of Test and Modification State 19th September 2016 Modification State 0 Test Equipment Used PMM Model 8010 signal Analyser Artificial Mains Network (LISN) Type L2-16 and associated PC software Test Method The equipment under test (ETU) was tested in an operating mode producing the largest emission in the frequency band being evaluated i.e. based on pre-tests and consistent to normal operation / normal application. The configuration of the ETU was typical with normal applications and installation practices which achieve maximum emissions. The measurements were carried out with parameters within the operating ranges of temperature, humidity and atmospheric pressure for the product at the rated supply voltage. Measurements were made using a PMM Model 8010 signal Analyser and Artificial Mains Network (LISN) Type L2-16 and associated PC software. The analyzer sweeps a set of filters across a pre-determined frequency band and in software selectable increments, over the range of 9kHz to 30MHz. The amplitude of the measured voltage at each increment is displayed graphically on a logarithmic scale. Environmental Conditions Ambient Temperature 22 C Relative Humidity 42% Atmospheric Pressure 1000mbar

9 Page 9 of 14 Report No Figure 5 : Conducted Emissions: Test Set Up Figure 6 : Conducted Emissions :Test Set Up Block Diagram

10 Page 10 of 14 Report No GRAPH 1 : Conducted Emissions P Settings 230V AC 50Hz to PSU. 12V DC from PSU to EUT.

11 Page 11 of 14 Report No Radiated Emissions Specification Reference EN55022 / EN :2007 Electromagnetic compatibility (EMC) Emission standard for residential, commercial and light-industrial environments Equipment Under Test (EUT) OPENBOX V8S SATELLITE RECEIVER Date of Test and Modification State 19th September 2016 Modification State 0 Test Equipment Used Radiated emissions testing were performed with a Rhode & Schwartz (Hameg) HMS spectrum analyser & control/report software scan 30MHz - 1GHz (Semi-Anechoic Chamber).AARONIA Broadband Antenna 30MHz - 1GHz (3m). Test Method The equipment under test (ETU) was tested in an operating mode producing the largest emission in the frequency band being evaluated i.e. based on pre-tests and consistent to normal operation / normal application. The configuration of the ETU was typical with normal applications and installation practices which achieve maximum emissions. The measurements were carried out with parameters within the operating ranges of temperature, humidity and atmospheric pressure for the product at the rated supply voltage. Environmental Conditions Ambient Temperature 22 C Relative Humidity 42% Atmospheric Pressure 1000mbar

12 Page 12 of 14 Report No Figure 7 : Radiated Emissions :Test Set Up Broadband Antenna 30MHz - 1GHz (3m) Rhode & Schwartz (Hameg) HMS spectrum analyser Figure 8 : Radiated Emissions :Test Set Up Black Diagram

13 Page 13 of 14 Report No GRAPH 2 : Radiated Emissions P

14 Page 14 of 14 Report No Figure 9 : Table Of Radiated Emissions Significant Peaks P *reference GRAPH 2