F780HD, 3, 3-Way Butterfly Valve Resilient Seat, 304 Stainless Steel Disc

Transcription

1 F80HD, 3, 3-Way utterfly Valve Resilient Seat, 304 Stainless Steel Disc pplication Valve is designed for use in NSI flanged piping systems to meet the needs of bi-directional high flow HV hydronic applications with 0% leakage. Typical applications include cooling tower bypass, primary flow change-over systems, and large air handler coil control. Jobsite Note Valve assembly should be stored in a weather protected area prior to installation. Reference the butterfly valve installation instruction for additional information. Flow/v v 0 v 20 v 30 v 40 v 50 v 60 v 0 v 80 v Suitable ctuators Non-Spring Electronic Fail-Safe F80HD 2*GM(X) 2*GK(X) Date created, /02/206 - Subject to change. elimo ircontrols (US), Inc. Technical Data 90 Service chilled, hot water, up to 60% glycol Flow haracteristic modified linear ontrollable Flow Range 90 rotation Size [mm] 3 [80] End Fitting for use with NSI lass 25/50 flanges ody ductile iron STM 536 ody Finish epoxy powder coated Seat EPDM standard Shaft 46 stainless steel ushings RPTFE Disc 304 stainless steel ody Pressure Rating [psi] 200 psi at -20 F to +50 F Number of olt Holes 4 Lug Threads 5/8- UN Media Temperature Range -22 F to 250 F [-30 to 20 ] (Water) lose-off Pressure 200 psi Rangeability 0: (for 30 to 0 range) Maximum Velocity 2 FPS v 302 Weight 50.5 lb [22.9 kg] Leakage 0% Servicing maintenance free J 2*GK F D D E F J [00] [482] [326.9] [35] [323] [40] [8] E US ND LTIN MERI / RIEN

2 F80HD, 3, 3-Way utterfly Valve Resilient Seat, 304 Stainless Steel Disc 2*GM/2*GK D E F J [00] [482] [326.9] [35] [323] [40] [8] J D GM..N4(H) F D E F J [85].38.8 [98] [482] [326.9] [523.2] [438] [8] E Date created, /02/206 - Subject to change. elimo ircontrols (US), Inc US ND LTIN MERI / RIEN

3 Modulating, Electronic Fail-Safe, 24 V, for 2 to 0 VD or 4 to 20 m ontrol Signal Date created, 09/0/206 - Subject to change. elimo ircontrols (US), Inc. Technical Data Power Supply 24 V ± 20%, 50/60 Hz, 24 VD ± 0% Power onsumption Running 2 W Power onsumption Holding 3 W Transformer Sizing 40V (class 2 power source) Electrical onnection 8 G plenum rated cable with /2 conduit connector protected NEM 2 (IP54) 3ft [m] 0 ft [3m] and 6 ft [5m] Overload Protection electronic throughout 0 to 95 rotation Operating Range Y 2 to 0 VD, 4 to 20 m w/ ZG-R0 (500, /4 W resistor), variable (VD, floating point, on/off) Impedance 00 k for 2 to 0 VD (0. m), 500 for 4 to 20 m, 500 for PWM, floating point and On/Off Feedback Output U 2 to 0 VD, 0.5 m max, VD variable ngle of Rotation max. 95, adjustable with mechanical stop Direction of Rotation (Motor) reversible with built-in switch Direction of Rotation (Fail-Safe) reversible with switch Position Indication reflective visual indicator (snap on) Manual Override external push button Running Time (Motor) 50 sec (default), variable (95 to 50 sec) Running Time (Fail-Safe) 35 sec ridge Time programmable 0 to 0 sec (2 sec default) delay before fail-safe activates Pre-charging Time 5 to 20 seconds Humidity 5 to 95% RH non condensing (EN 6030-) mbient Temperature Range -22 F to +22 F [-30 to +50 ] Storage Temperature Range -40 F to +6 F [-40 TO +80 ] Housing NEM 2, IP54, UL enclosure type 2 Housing Material UL94-5V gency Listings culus acc. to UL6030-/-2-4, N/S E6030-:02, E acc. to 2004/08/E and 2006/95/E Noise Level (Motor) <45 d () Noise Level (Fail-Safe) <45 d () Servicing maintenance free Quality Standard ISO 900 Weight 9 lb [4. kg] Rated Impulse Voltage 800V, Type of action., ontrol Pollution Degree US ND LTIN MERI / RIEN

4 Modulating, Electronic Fail-Safe, 24 V, for 2 to 0 VD or 4 to 20 m ontrol Signal Wiring Diagrams INSTLLTION NOTES 24 V Transformer ctuators with appliance cables are numbered. Provide overload protection and disconnect as required. ctuators may also be powered by 24 VD. Only connect common to negative (-) leg of control circuits. 500 resistor (ZG-R0) converts the 4 to 20 m control signal to 2 to 0 VD. ontrol signal may be pulsed from either the Hot (Source) or (Sink) 24 V line. For triac sink the connection from the actuator must be connected to the Hot connection of the controller. Position feedback cannot be used with a triac sink controller; the actuator internal common reference is not compatible. Feedback VD (+) On/Off 24 V Transformer ( Only) Pnk (4) Y Y IN4004 or IN400 diode. (IN400 supplied, elimo part number 4055). Y 46 4 ctuators may be controlled in parallel. urrent draw and input impedance must be observed. Master-Slave wiring required for piggy-back applications. Feedback from Master to conrol input(s) of Slave(s). Meets culus requirements without the need of an electrical ground connection.! WRNING! LIVE ELETRIL OMPONENTS! During installation, testing, servicing and troubleshooting of this product, it may be necessary to work with live electrical components. Have a qualified licensed electrician or other individual who has been properly trained in handling live electrical components perform these tasks. Failure to follow all electrical safety precautions when exposed to live electrical components could result in death or serious injury. Feedback VD (+) Floating Point 24 V Transformer ontrol Signal ( ) VD / m (+) VD/m ontrol 500 /4 watt 24 V Transformer ( only) Feedback VD (+) PWM ontrol Pnk (4) Y Y Pnk (4) Y Y Pnk (4) Y 2 Date created, 09/0/206 - Subject to change. elimo ircontrols (US), Inc US ND LTIN MERI / RIEN

5 Modulating, Electronic Fail-Safe, 24 V, for 2 to 0 VD or 4 to 20 m ontrol Signal 24 V Transformer ( Only) 5 ontrol Signal ( ) VD / m (+) Functions Min 0% Mid 50% Max 00% Normal ontrol mode acc. to Y Override ontrol 2 Pnk (4) a b c Org (5) Y Y 2 24 V Transformer ( ) ontrol Signal (+) Master Org (5) Y Slave Org (5) Y Master - Slave Date created, 09/0/206 - Subject to change. elimo ircontrols (US), Inc US ND LTIN MERI / RIEN