BDW93C, BDW94C Series

Transcription

1 Features Designed for general-purpose amplifier and low speed switching applications Collector-emitter sustaining voltage- CEO (sus) = (Minimum) Collector-emitter saturation voltage- CE (sat) = 2 (Maximum) at I C = 5 A Monolithic construction with built-in-base-emitter shunt resistor Dimension Minimum Maximum A B Pin 1. Base 2. Collector 3. Emitter 4. Collector (Case) Maximum Ratings Characteristic C D E F G H I J K L M O Dimensions : Millimetres BDW93C Symbol BDW94C 12 Amperes Darlington Complementary Silicon Power Transistors 45 - olts 80 Watts TO-220 Unit Collector-Emitter oltage CEO Collector-Base oltage CBO Emitter-Base oltage EBO 5 Collector Current-Continuous -Peak I C I CM Base Current I B 0.2 A Total Power Dissipation at T C = 25 C Derate Above 25 C Operating and Storage Junction Temperature Range Thermal Characteristics P D A W W/ C T J, T STG -65 to +150 C Characteristic Symbol Maximum Unit Thermal Resistance Junction to Case R θjc 1.56 C/W Page <1> 28/11/11 1.1

2 Figure1 Power Derating P D, POWER DISSIPATION (WATTS) T C, TEMPERATURE ( C) Electrical Characteristics (T C = 25 C unless otherwise noted) OFF Characteristics Characteristic Symbol Minimum Maximum Unit Collector-Emitter Sustaining oltage (1) (I C = ma, I B = 0 Collector Cut off Current ( CE = 80, I B = 0) Collector-Base Cut off Current ( CB = Rated CB, I E = 0) Emitter-Base Cut off Current ( EB =5, I C = 0) CEO (sus) 80 - I CEO - 1 ma I CBO - µa I EBO - 2 ma ON Characteristics (1) (I C = 3 A, CE = 3 ) (I C = 5 A, CE = 3 ) (I C = 10 A, CE = 3 ) h FE 1, ,000 - Collector-Emitter Saturation oltage (I C = 5 A, I B = 20 ma) (I C = 10 A, I B = ma) CE (sat) Base-Emitter Saturation oltage (I C = 5 A, I B = 20 ma) (I C = 10 A, I B = ma) BE (sat) (1) Pulse Test: Pulse Width = 300 µs, Duty Cycle 2.0% Page <2> 28/11/11 1.1

3 BDW93C NPN BDW94C PNP R1 Typical 10 kω R2 Typical 150 Ω R1 Typical 10 kω R2 Typical 150 Ω I C - be I C - be EE, BASE - EMITTER OLTAGE () Switching Time EE, BASE - EMITTER OLTAGE () Switching Time t, TIME (µs) t, TIME (µs) I c, COLLECTOR CURRENT (AMP) I c, COLLECTOR CURRENT (AMP) Page <3> 28/11/11 1.1

4 / Active-Region Safe Operating Area (SOA) h FE, DC CURRENT GAIN h FE, DC CURRENT GAIN - Collector Saturation Region Collector Saturation Region I B, BASE CURRENT (ma) I B, BASE CURRENT (ma) Page <4> 28/11/11 1.1

5 CE (Sat) - I C CE (Sat) - I C Specification Table I C (av) maximum (A) CEO maximum h FE minimum at I c = 5 A P tot at 25 C (W) Package Type Part Number TO-220 NPN PNP BDW93C BDW94C Important Notice : This data sheet and its contents (the "Information") belong to the members of the Premier Farnell group of companies (the "Group") or are licensed to it. No licence is granted for the use of it other than for information purposes in connection with the products to which it relates. No licence of any intellectual property rights is granted. The Information is subject to change without notice and replaces all data sheets previously supplied. The Information supplied is believed to be accurate but the Group assumes no responsibility for its accuracy or completeness, any error in or omission from it or for any use made of it. Users of this data sheet should check for themselves the Information and the suitability of the products for their purpose and not make any assumptions based on information included or omitted. Liability for loss or damage resulting from any reliance on the Information or use of it (including liability resulting from negligence or where the Group was aware of the possibility of such loss or damage arising) is excluded. This will not operate to limit or restrict the Group's liability for death or personal injury resulting from its negligence. Multicomp is the registered trademark of the Group. Premier Farnell plc Page <5> 28/11/11 1.1