DMT113 Engineering Drawing. Chapter 3 Stretch System

Transcription

1 DMT113 Engineering Drawing Chapter 3 Stretch System

2 Contents Theory & Multiview Planes 6 Principle Views Multiview Sketching Technique & Perspective First & Third Angle Multiview Representations

3 Theory & Multiview Planes theory: comprises the principles used to graphically represent 3D objects & structures on 2D media LOS (Line of Sight): Imaginary ray of light between an observer s eye and an object Plane of projection: Imaginary flat plane upon which the image created by the lines of sight is projected Parallel projection: Object to be positioned at infinity & viewed from multiple points on an imaginary line parallel to the object Perspective projection: Object to be positioned at a finite distance & viewed from a single point Ortographic projection: parallel projection technique in which the plane of projection is positioned between the observer & the object & is perpendicular to the parallel lines of sight Multiview projection: orthographic projection for which the object is behind the plane of projection & the object is oriented such that only 2 of its dimensions are shown Multiview drawings:common 3 views are shown: top view, frontal view & right side view

4 Theory & Multiview Planes

5 Theory & Multiview Planes Multiview drawing of an object

6 6 Principle Views 6 mutually perpendicular views that are produced by 6 mutually perpendicular planes of projection Front view Top view Right side view Left side view Rear view Bottom view

7 6 Principle Views

8

9 Isometric pictorial: type of parallel projection that represents all 3 dimensions in a single image

10 Basic steps used to create an isometric sketch of an object

11 Oblique pictorial: the front face is seen in its true shape & is square with the paper & only the depth axis is drawn at an angle Isometric vs oblique sketches

12

13 Visualizing a multiview drawing

14 Center lines: represent symmetry & paths of motion & to mark the centers of circles & axes of symmetrical parts ie cylinders & bolts Visible lines: final drafting of the technical drawing Construction lines: initial drafting of the technical drawing Hidden lines: represent features that cannot be seen in the current view Phantom lines: represent a movable feature in its different positions Cutting plane lines: used in section drawings to show the locations of cutting planes Dimension & extension lines: used to indicate the sizes of the features on a drawing Section lines: used in section views to represent surfaces of an object cut by a cutting plane

15

16

17 Drawing conventions for hidden lines

18 Creating a three view sketch

19 Perspective Bird s eye view Relationship: Ground line well below the horizon line Effect: Observer is much taller than the object Human s eye view Relationship: Ground line six feet below the horizon line Effect: Observer is somewhat taller than the object Ground s eye view Relationship: Ground line at the same level as the horizon line Effect: Observer is the same height as the object Worm s eye view Relationship: Ground line well above the horizon line Effect: Observer is much shorter than the object

20

21 One, two & three-point perspective sketches of the same object

22 Multiview Representations Multiview drawings of solid primitive shapes

23 First & Third Angle s

24 First & Third Angle s Pictorial comparison between first & third angle projection techniques

25 Multiview Representations Fillet: a rounded interior corner, normally found on cast, forged or plastic parts Round: a rounded exterior corner

26 Multiview Representations

27 END