UNDER DEVELOPMENT UNDER DEVELOPMENT UNDER DEVELOPMENT UNDER DEVELOPMENT

Transcription

1 UNDER DEVELOPMENT UNDER DEVELOPMENT UNDER DEVELOPMENT UNDER DEVELOPMENT Model Name : OLB500P701N1A Features : ㅡ Flikerless LED control gear ㅡ Independent type LED control gear & Class II construction ㅡ Full-protection provided: OCP/OVP/OTP/SCP/OLP ㅡ Compliant with CB, CE, KC safety requirements for LED lighting ㅡ Compliant with IP 67(Ingress Protection rating ㅡ Wide Vout : 36 ~ 65Vdc ㅡ Non dimming ㅡ Constant Current Type

2 Electrical specification No. Item Min Typ Max Unit Remark 1 Nominal Input Voltage Vac 2 Variable Input Voltage Vac 3 Maximum Input Current Arms 4 Nominal Input Frequency 47 50/60 63 Hz 5 Power Factor (PF % 1 6 Total Harmonic Distortion (THD % 1 7 Inrush Current A 8 Electrical Efficiency % 2 9 Turn-on Delay Start, 3 10 LED Output Current Load 11 LED Output Current Ripple ma 20MHz Bandwidth, 2 12 LED Output Voltage Vdc 13 12V Output Voltage Vdc N.A 14 12V Output Voltage Ripple Vdc N.A 15 12V Output Current ma N.A 16 No Load STBY Power Dissipation Open 17 Output Open LED Protection Output Short Circuit Protection Auto-recovery 19 Over-temperature Protection Auto-recovery 20 Storage Temperature Operating Temperature Case Temperature (Tc Humidity % Insulation Resistance MΩ 500Vdc between Input & Output Dielectric Withstand Voltage Surge ESD Input to Output Vac Input to Case Vac Output to Case Vdc Line to Line Line to Ground Contact Discharge Air Discharge kv kv Apply for 1 minute kv kv 6 7

3 Notes 1 Test Condition:198/264Vac 50/60Hz Input,Typical LED Load,Ambient Temperature 25, Measure at the cable-end 2 Test Condition: 220Vac 60Hz Input, LED Max. Load, 30min Aging, Ambient Temperature 25 3 At least, Turn-On Time should be continued for 1sec. 4 Surge Specification above is higher than IEC/EN (Differential 1kV, Common 2kV 5 The metal case of the LED driver must be connected with F.G 6 ESD Specification above meets IEC/EN Requirements (Contact 4kV, Air 8kV 7 The metal case of the driver should be grounded. 8 Determined by Paragraph , UL1310 or Paragraph 8.4.2, UL8750, EN , EN Safety Standards Including safety requirements above, the LED driver complies with the following safety standards: No. Item Description 1 IEC/EN , IEC/EN IEC/EN Safety Standards 2 KC K , K , K IEC/EN Conducted and Radiated Emission Test 4 IEC/EN Harmonic current emissions: Class C 5 IEC/EN Voltage Fluctuations and Flicker 6 IEC/EN Electrostatic Discharge (ESD: Contact 4kV, Air 8kV 7 IEC/EN Radio-frequency Electromagnetic Fields 8 IEC/EN Electrical Fast Transients (EFT 9 IEC/EN Surges: Differencial 1kV, Common 2kV 10 IEC/EN Injected Currents 11 IEC/EN Power Frequency Magnetic Fields 12 IEC/EN Voltage Dips and Short Interruptions 13 IP GRADE IP 67

4 Life Time vs Tcase OLB500P701N1A Flickerless Power supply *Currently Measurement Data Life Time [hrs] Vac(Vmax=65V Tc[ ] Remark LED Driver has a rated lifetime of 50,000 Tc 70 Power Factor Power Factor 100% 90% 80% 70% 60% 50% Input Voltage (Vac Load(Vout=36V Load(Vout=60V Load(Vout=65V THD(% 30% 25% 20% THD 15% 10% 5% 0% Input Voltage (Vac Load(Vout=36V Load(Vout=60V Load(Vout=65V

5 Efficiency(% 100% 90% OLB500P701N1A Flickerless Power supply *Currently Measurement Data Load(Vout=36V Eff 80% 70% Load(Vout=60V 60% 50% Input Voltage (Vac Load(Vout=65V Output Current( ma Load(Vout=36V Current Input Voltage (Vac Load(Vout=60V Load(Vout=65V

6 Mechanical Specification Enclosure Size Unit Width Length Height Mount Length Overall Length mm inch Case Material : Aluminium

7 Wiring Diagram INPUT L LED Control gear LED+ OUTPUT N LED- Out connector description Classification Part No. Connector ( Cable end Connector ( Opposite side Type#1 N.A N.A Type#2 PSOH500701B MG610320(KET MG610322(KET Type#3 PSOH500701C 02R-JWPF-VSLE-S(JST or 02R-JWPKF-VKLE-S(JST 02T-JWPF-VSLE-S(JST or 02T-JWPKF-VKLE-S(JST Rating Label Drawing

8 Barcode Label Box Label Material Code ITEM LOT No OLB500P701N1A REV. A** ********* MAKER USER Model Code SOLUM Model Code SOLUM LOT NO & Quantity of Products Quantity [PCS] 21 SOLUM EXP. Date 20**.**.** ~ 20**.**.** Product Date ~ After 5 years B001 E601 P0315D001 USER Barcode

9 Packing Drawing 1. Out Box Dimmension Weight Quantity 460(L 302(W 100(H [mm] < 7Kg 21EA / 1Box CROSS PAD A CROSS PAD B CUSHION PAD NIL PAD OUT BOX 2. Pallet