4-Pin Red LED Lamp (7.6mm) OPTEK Tec hnology

Transcription

1 Packaged in tubes Compatible with automatic placement equipment Compatible with infrared and vapor phase reflow solder process Mono-color type Pb-free Product Photo Here The is designed with higher forward voltage to maimize brightness and incorporates a low-profile lens to enhance efficient light distribution. Response time is fast and it consumes less power resulting in low current requirements from circuit power supply. Tubular arrays replace neon in outdoor and indoor signs. This square package allows high-density arrays to form light engines. Applications Automotive: Rear Stop/Turn Signal Lamps/Truck Marker Lamps Mood-setting Decoration and Landscape Lighting Special Decorative Interior/Eterior Lighting Special Effects Stage Lighting Illumination for Signs and Channel Letters Traffic Signals, Pedestrian and Walkway Signs Part Number Material Emitted Color Flu Typ. mlm AlInGaP Red 4500 Lens Color Water Clear RoHS 2,3 ANODE 1,4 CATHODE Data is subject to change without prior notice. Page 1

2 Absolute Maimum Ratings T A = 25 o C unless otherwise noted Storage Temperature Range Operating Temperature Range -40 ~ +100 C -40 ~ +100 C Lead Soldering Temperature (3mm from the base of the epoy bulb) C Reverse Voltage Continuous Forward Current 2 Peak Forward Current (10% Duty Cycle, PW VHF Power Dissipation 5 V mw Notes: 1. Solder time less than 5 seconds at temperature etreme. 2. Heat sink is adequate if the device is operated at ambient temperature higher than 25 C. For long term performance the drive currents between 10 and 50 are recommended. Please contact an Optek sales representative for more information on recommended drive conditions. Electrical Characteristics T A = 25 o C unless otherwise noted SYMBOL PARAMETER MIN TYP MAX UNITS CONDITIONS lumen Luminous Flu mlm I F = 70 V F Forward Voltage V I F = 70 I R Reverse Current µa V R = 5V D Dominant Wavelength nm I F = 70 2 ½ 50% Power Angle deg I F = 70 Standard Bins (I F = 70) Lamps are sorted to luminous flu ( V), forward voltage (V F ), and dominant wavelength ( D ) bins shown. Orders for may be filled with any or all bins contained as below. Luminous Flu (mlm) M L K J 618 Dominant Wavelength (nm) 630 Luminous flu is at J bin or above. Forward Voltage (V F ) Rank V3 V4 V5 V6 V7 Voltage (V) Important Notes: 1. All ranks will be included per delivery, rank ratio will be based on the chip distribution. 2. To designate luminous intensity ranks, please contact OPTEK. Issue Page 2

3 Typical Electro-Optical Characteristics Curves % V Forward Current vs. Forward Voltage Relative Luminous Flu vs. Forward Current Half Power WL = 23nm nm Relative Luminous Flu vs. Wavelength C Maimum Forward DC Current vs. Ambient Temperature 50% Power Angle: 100 V A Far Field Pattern Reverse Current vs. Reverse Voltage Page 3

4 Moisture Resistant Packaging 60/Tube Aluminum Moisture-proof Bag Desiccant Bar Code Label Issue Page 4

5 Issue Change Description Approval Date 1.0 Initial Release R. Bailey 5/19/05 Page 5