Technical Specificatin Sheet Dcument N. A6V11470500 July 31, 2018 Wireless Bridge Mdule fr DXR2.E Descriptin A wireless bridge cnnects tw wired netwrks tgether ver Wi-Fi utilizing a Wireless Access Pint. A wireless bridge is based n 802.11 prtcl and acts as a client, lgging in t the primary ruter and getting an Internet cnnectin, which it passes n t the devices cnnected t its LAN jacks. This Wireless Bridge Mdule prvides wireless BACnet/IP cmmunicatin with flr level devices thrugh a Wi-Fi link within a building. Each wireless bridge supprts up t five daisy-chained Ethernet DXRs. Fr infrmatin n daisy-chaining the DXRs, see APOGEE Wiring Guidelines fr Field Panels and Equipment Cntrllers (125-3002). The fllwing cnfiguratins are available: Lcal Installatin the bridge mdule is attached t a lcatin near the DXR. Enclsure r Plenum Installatin the bridge mdule is installed in an enclsure with a remtemunt antenna. Features Uses Wireless Access Pint n a Wi-Fi netwrk t facilitate BACnet IP cmmunicatins fr the DXR and ther flr level devices. Pre-wired Wireless Bridge Mdules make interface t Ethernet DXRs simple and easy. Multiple antenna ptins exist t meet lcal installatin requirements External antenna (included) Optinal 10-ft and 25-ft antenna extensin cables Optinal tamper-resistant ceilingmunt antenna Applicatins Building lcatins where it becmes expensive r impractical t install Ethernet cmmunicatins wiring, like lder structures, museums, churches r crrectinal facilities. Figure 1. Page 1 f 5
Orderable Prduct Descriptins Tw Wireless Bridge Mdule Optins Wireless Bridge Mdule Part Number 563-301 (Orderable part number S55622-H235) This standard Wireless Bridge Mdule is used in mst applicatins, particularly with the DXR2.E12P-102B variant with the built-in differential pressure sensr fr VAV and fan-pwered bx applicatin types. This mdel cntains a wireless bridge transceiver, external antenna, antenna extensin cable and regulated pwer supply n a cnvenient munting tray. Installatin instructins and sheet metal screws are included. The pwer supply is wired t the same 24 Vac pwer at the DXR, prviding 24 Vdc utput pwer required fr the transceiver. instructins and sheet metal screws are included. There is n pwer supply in this mdel as the transceiver pwer plug has a 48-inch cable t interface specifically with the DXR2-E18-101B mdel if there are n ther devices cnnected t the 24 Vdc utput vltage available via terminals 39 (V+) and 40 ( ). If the DXR2-E18-101B has ther external devices cnnected t these terminals, use Part Number 563-301 instead. NOTE: A user-prvided Ethernet patch cable is required fr cnnectin t the DXR. NOTE: A user-prvided Ethernet patch cable is required fr cnnectin t the DXR. Figure 3. Part Number 563-302. Optinal Enclsures If lcal cde requires the DXR and Wireless Bridge Mdule t be munted in a cntrl cabinet, bth units may be munted tgether using the Siemens Cntrl Panel 567-351 r 540-155 (see Figure 4). Figure 2. Part Number 563-301. Part Number 563-302 (Orderable part number S55622-H236) An alternate Mdule, mdel 563-302 seen in Figure 3, is fr specific use with the DXR2.E18-101B variant fr fan cil, unit vent, and heat pump applicatin types as this mdel can derive its pwer directly frm the DXR2.E18-101B mdel. This mdel cntains a wireless bridge transceiver, 48-inch POE pwer cable, external antenna and antenna extensin cable n a cnvenient munting tray. Installatin Page 2 f 5 567-531 540-155 Figure 4. Cntrl Cabinets.
Remte Antenna Accessries Munting Optins fr Standard Antenna (included with Wireless Bridge Mdule) The Wireless Bridge Mdule includes an adjustable, 8-inch, mni-directinal, external antenna that screws directly nt the transceiver. This antenna will prvide extended wireless perfrmance in mst wall-munt r equipment-munt installatins (see Figure 5). If the Wireless Bridge Mdule is munted in a lcatin that is internal t an enclsure r is in an area that makes wireless transmissin t ther devices impractical, tw lnger antenna extensin cables (10-ft and 25-ft lng versins) are rderable accessries (see Figure 7). Figure 7. Lng Antenna Extensin Cables Available in 10-ft and 25-ft Lengths. (Optinal) Ceiling-Munt Antenna Kit Accessries Figure 5. Direct Munt Antenna. If the Wireless Bridge Mdule is munted inside f a cntrl enclsure r equipment electrical enclsure, the external antenna will need t be repsitined t an external lcatin with gd line f sight t ther wireless devices. The Wireless Bridge Mdule includes a 12-inch extensin cable with a bulkhead fitting t supprt the repsitining f the antenna t a nearby lcatin n the utside f the enclsure. Attach ne end f the cable t the transceiver, drill a hle in the enclsure, install the bulkhead fitting with the cnnectr extending thrugh the enclsure and attach the antenna t this fitting (see Figure 6). The antenna can be adjusted t meet transmissin requirements. Fr installatins requiring a secure, tamper-resistant antenna such as schls, public areas, retail areas r detentin facilities, mni-directinal ceiling-munt external antenna kits are available that can replace the standard, included antenna. The antenna is white in clr and has an appearance similar t a smke detectr. Utilizing these ceilingmunt antennas reduces the pprtunity fr issues due t antenna damage r theft. Tw kits are available: ne cntaining the ceiling antenna and a 10-ft extensin cable, r ne with a 25-ft extensin cable (see Figure 8). Figure 8. Ceiling Munt Antenna Kit. Figure 6. Shrt Antenna Extensin Cable. Figure 9. Ceiling Munt Antenna Munting. Munting is easy by making a 5/8-inch hle in the ceiling panel, inserting the antenna, installing a threaded fastener t munt it securely t the ceiling panel and cnnecting the cable t the cnnectr n the back f the antenna). Then, run the cable back t the Wireless Bridge Mdule. See Figure 9. Page 3 f 5
Specificatins General Specificatins Pwer Supply Input Output Specificatins Transceiver Input Pwer Requirements Pwer Methd fr Wireless Bridge Transceiver Maximum Wireless Bridge Pwer Cnsumptin Wi-Fi Standards and Supprted Data Rates 802.11n 802.11b 802.11g (nly included with Part Number 563-301) 24 Vac; 50/60 Hz 24 Vdc nminal with 1.5A current utput, 3A ver current prtected 24 Vdc, full wave rectified, regulated @ 0.5 Amps PE Adapter, 24 Vdc (included) 4 Watts 6.5 Mbps t 150 Mbps (MCS0 MCS7, HT 20/40) 1, 2, 5.5, 11 Mbps 6, 9, 12, 18, 24, 36, 48, 54 Mbps Wireless Security WEP, WPA-PSK, WPA-TKIP, WPA2 AES, 802.11i Operating Frequency Antenna Maximum TX Pwer Range Netwrking Interface Reset Buttn Wireless Bridge Status LED Clrs Regulatry, Cmpliance, Envirnmental Wireless Apprvals Cmpliance Wireless Bridge ESD/EMP Prtectin Operating Temperature Range Humidity Enclsure Material Dimensins 2412 2484 MHz (2.4 GHz nminal) Omni-directinal, adjustable 8-inch antenna, 4.5 dbi nminal gain 18 dbm 75 t 250 feet, unbstructed line f sight. Site evaluatin and wireless site survey recmmended t estimate actual range. Dual 10/100 Ethernet Prts (POE and LAN); Male RJ45 Cnnectrs Lcated n bttm. Resets wireless bridge t factry defaults. Steady White: indicates bt-up, initializatin, r pwer-n Steady Blue: indicates that the device is wrking prperly, active cnnectin Alternating Blue/White: indicates that the device is busy; d nt mve r unplug. FCC, IC, CE RHS ± 24 kv, RJ45 Interface 32 F t 132 F (0 C t 55 C) 5% t 95% RH, nn-cndensing Plycarbnate 2.1-in. 1.7-in. 1.2-in. (54 mm 44 mm 30 mm) Specificatins Ceiling-Munt, Tamper-Resistant Antenna Kit Operating Frequency Ceiling Munt Antenna Maximum Antenna Input Pwer Impedance Enclsure Material Dimensins Antenna Cable (see specs belw) Specificatins Antenna Cables Antenna Extensin Cable Extensin Cables fr Transceiver Antenna Cables fr Ceiling Munt Antenna 2300 t 5900 MHz Omni-directinal, ceiling munt style, 4.5 dbi nminal gain @ 2.4 GHz 50 watts 50 hms White Plymer, UL 94HB flame rating, RHS 5.7-in. diameter, 1.3-in. height (145 mm 35 mm) 10-ft. r 25-ft cable included with ceiling antenna kit 12-inch extensin cable included, RP-SMA (male) t RP-SMA (female) with bulkhead fitting fr use with external munt antenna. LMR-100A, RHS. RP-SMA (male) t RP-SMA (female); CA-195, LSZH rated cable fr interir use nly. RHS N Jack-Female (Antenna side) and RP-SMA Male CA-195, LSZH rated cable fr interir use nly. RHS Page 4 f 5
Ordering Infrmatin Orderable Part Number Article Number Descriptin Wireless Bridge Mdules S55622-H235 563-301 Wireless Bridge Mdule with Pwer Supply fr 24 Vac Input Vltage S55622-H236 563-302 Wireless Bridge Mdule with Pwer Cable fr DXR2.E18 (24 Vdc) Remte Antenna Kits and Antenna Extensin Cables S55622-H237 563-321-10 Ceiling-Munt, Tamper Resistant Antenna Kit with 10-ft extensin cable S55622-H238 563-321-25 Ceiling-Munt, Tamper Resistant Antenna Kit with 25-ft extensin cable S55622-H239 563-356 Antenna Extensin Cable, RP-SMA, M-F, 10-ft cable S55622-H240 563-357 Antenna Extensin Cable, RP-SMA, M-F, 25-ft cable Related Dcuments A6V11470476 Wireless Bridge Mdule fr DXR2.E Installatin Instructins Dimensins (Nminal) 563-301, 563-302 563-321-xx Figure 10. Dimensins in Inches (Millimeters). Infrmatin in this dcument is based n specificatins believed crrect at the time f publicatin. The right is reserved t make changes as design imprvements are intrduced. Prduct r cmpany names mentined herein may be the trademarks f their respective wners. 2018 Building Technlgies Divisin 1000 Deerfield Parkway Buffal Grve, IL 60089-4513 USA +1-847-215-1000 Yur feedback is imprtant t us. If yu have cmments abut this dcument, please send them t sbt_technical.editr.us.sbt@siemens.cm. Dcument N. A6V11470500 Printed in the USA Page 5 f 5