Guide to Making a Fleece Hat

Transcription

1 Guide to Making a Fleece Hat

2 Introduction This guide was created specifically for 4-H members who want to become familiar with sewing steps necessary for making a fleece hat as seen on the cover page photo. It is written based under the assumption that users of this guide will already be familiar with the basic sewing concepts mentioned in Let s Sew! by Nancy Zieman or any similar beginner sewing manual. The Measuring and Cutting section of these instructions is specifically meant for the 4-H leader so that the remaining instructions can be easily followed. Any person unfamiliar with how to use a sewing machine should seek supervision and instruction. All bold type text found within this guide is defined in the glossary found on the last page. Materials 2 x 1½ ft piece of fleece style fabric 2 x 1½ ft of newspaper or wrapping paper scissors marking chalk pen or marker measuring stick sewing machine thread (matches fabric) pins iron pressing cloth

3 Measuring and Cutting (It is recommended that the 4-H leader use this section to create a master cutout.) (dimensions in inches) Step 1 Measure and draw with pen or marker and a ruler the following dimensions on piece of newspaper or wrapping paper according to the following diagram in = cm in = cm in = cm in = cm Step 2 Cut the pattern out with a pair of paper scissors along the lines to create master copy.

4 Making the Hat (It s time to begin!) Step 3 Trace (or pin) the master copy onto the piece of fleece material using marking or tailor s chalk. (Note: Press lightly with the chalk to prevent bunching or stretching the fabric.) Step 4 Cut the shape out with a pair of sewing scissors along the lines.

5 Making the Hat (cont.) Step 5 With right sides together, fold fleece shape in half as shown. Step 6 Pin fleece material at corners to keep fold in place.

6 Making the Hat (cont.) Step 7 Use sewing machine to backstitch at Point A using a ¼- inch seam allowance. (Refer to image below for the location of point A.) Step 8 Stitch from Point A to Point B maintaining a ¼ inch of seam allowance. (Caution: Remove each pin before stitching over the point to prevent sewing machine needle from breaking.)

7 Making the Hat (cont.) Step 9 Lift presser foot and pivot fabric at Point C and then lower presser foot again. Step 10 Repeat steps 8 and 9 from Point B to Point C and then from Point C to Point D. (You re half finished!)

8 Making the Hat (cont.) Step 11 Backstitch at Point D to reinforce seam. Step 12 Trim any excess thread from stitching.

9 Making the Hat (cont.) Step 13 Press entire seam open using iron on medium setting using steam. Step 14 Turn up bottom edge 2 inches all the way around using measuring instrument.

10 Making the Hat (cont.) Step 15 Press turned up edge. Step 16 Place a few pins around the turned up edge to hold it in place.

11 Making the Hat (cont.) Step 17 Sew along top of folded edge using 1/8 inch seam allowance. (Caution: Remove each pin before stitching over the point to prevent sewing machine needle from breaking.) Step 18 Backstitch after sewing around entire edge. (You re almost there!)

12 Finishing the Hat Step 19 Turn hat right side out, pushing corners out with fingers. Step 20 Lay hat flat and press hat along all edges with iron using pressing cloth over fabric. Your new hat is ready to wear! Enjoy!

13 References Various photos and sewing terms taken from: Let s Sew!: A Beginner s Sewing Guide by: Nancy Zeiman

14 Glossary Backstitch: This is the process of sewing 2 or 3 stitches forward, then reverse, then forward again. Pivot: With the needle still in the fabric, lift the presser foot and rotate the fabric to the direction you want to sew. Press: The act of ironing fabric using only an up and down motion. Presser Foot: The metal piece that holds the fabric in place while sewing. Seam Allowance: The space left between the stitch and the end of the fabric when sewing. Wrong Side: The side of the fabric that you don t want to have showing when you are finished the hat. This side is usually rougher or has less color than the right side.

15 Guide to Making a Fleece Hat By: Jim Andrukattis Mark Hutzell Joe Salvey Ed Skirkie

16 College of Agricultural Sciences Cooperative Extension Prepared under the supervision of Jan Scholl, associate professor of agricultural and extension education. Visit Penn State s College of Agricultural Sciences on the Web: Penn State College of Agricultural Sciences research, extension, and resident education programs are funded in part by Pennsylvania counties, the Commonwealth of Pennsylvania, and the U.S. Department of Agriculture. Where trade names appear, no discrimination is intended, and no endorsement by Penn State Cooperative Extension is implied. Issued in furtherance of Cooperative Extension Work, Acts of Congress May 8 and June 30, 1914, in cooperation with the U.S. Department of Agriculture and the Pennsylvania Legislature. T. R. Alter, Director of Cooperative Extension, The Pennsylvania State University. This publication is available in alternative media on request. The Pennsylvania State University is committed to the policy that all persons shall have equal access to programs, facilities, admission, and employment without regard to personal characteristics not related to ability, performance, or qualifications as determined by University policy or by state or federal authorities. It is the policy of the University to maintain an academic and work environment free of discrimination, including harassment. The Pennsylvania State University prohibits discrimination and harassment against any person because of age, ancestry, color, disability or handicap, national origin, race, religious creed, sex, sexual orientation, or veteran status. Discrimination or harassment against faculty, staff, or students will not be tolerated at The Pennsylvania State University. Direct all inquiries regarding the nondiscrimination policy to the Affirmative Action Director, The Pennsylvania State University, 328 Boucke Building, University Park, PA , Tel /V, /TTY. The Pennsylvania State University 2003