P layful Cuties Quilt - Coral

Size: px

Start display at page:

Download "P layful Cuties Quilt - Coral"

Lawrence Barton
5 years ago
Views:

Finished Size: 40 ½" x 49" (1.03 meters x 1.

(68.58cm) - 12966-Lt. Coral for squares and binding 5 8 yd. (57.15cm) - 12962-White ½ yd. (45.72cm) - 12964-White ½ yd. (45.72cm) - 12969-Coral 1 ½ yds.

42m) Cotton batting Coordinating thread Rotary cutter (45mm) and cutting mat with lines Acrylic ruler 6" x 24" (15.24cm x 60.

before beginning project. Do not pre-wash fabrics. Press fabrics with a dry iron on cotton setting before cutting. Use a ¼" (6.

1 Finished Size: 40 ½" x 49" (1.03 meters x 1.24 meters) P layful Cuties Quilt - Coral Supp lies Needed 3 Wishes Fabric Playful Cuties - Coral Collection 1 yd. (91.44cm) Gray ¾ yd. (68.58cm) Lt. Coral for squares and binding 5 8 yd. (57.15cm) White ½ yd. (45.72cm) White ½ yd. (45.72cm) Coral 1 ½ yds. (1.37 meters) White for backing 48" x 56" (1.22m x 1.42m) Cotton batting Coordinating thread Rotary cutter (45mm) and cutting mat with lines Acrylic ruler 6" x 24" (15.24cm x 60.96cm) Basic sewing supplies Sewing machine Walking foot (for quilting) Iron and pressing surface B efore you begin Read all instructions before beginning project. Do not pre-wash fabrics. Press fabrics with a dry iron on cotton setting before cutting. Use a ¼" (6.35mm) seam allowance and sew fabrics with right sides together (RST) unless otherwise noted. Press seams in the directions of the arrows. Wof = width of fabric. Cutting 1. Use a rotary cutter and acrylic ruler to cut the number of pieces from each fabric as shown Fabric Editions, Inc. 3 Wishes Fabric is a trademark of Fabric Editions, Inc. page 1

2 12967-Gray 1 yd. (91.44cm) Lt Coral ¾ yd. (68.58cm) 2 ½" x wof (blocks) 2 ½" x wof (binding) Cut 12-2 ½" x wof (6.35cm x 1.07m) Cut 5-2 ½" x wof (6.35cm x 1.07m) Cut 8 - x (16.51cm x 16.51cm) White 5 8 yd. (57.15cm) White ½ yd. (45.72cm) Coral ½ yd. (45.72cm) 2 ½" x wof (blocks) Cut 18 - x (16.51cm x 16.51cm) Cut 6-2 ½" x wof (6.35cm x 1.07m) Cut 9 - x (16.51cm x 16.51cm) page 2

3 P iecing 2. Place two Gray strips (2 ½" x wof, 6.35cm x 1.07m) on opposite sides of one White strip (2 ½" x wof, 6.35cm x 1.07m). Pin, sew RST on the long sides and press to make one long strip set x wof (16.51cm x 1.07m). Trim one end square, removing the selvage. Cut six (16.51cm) segments. Repeat with the remaining strips to make five more strip sets and 36 x (16.51cm x 16.5cm) Blocks (Dia. A). Dia. A = = x wof (16.51cm x 1.07m) x (16.51cm x 16.51cm) Make 36 blocks 3. Refer to Diagram B to position the 36 Blocks (note orientation) with the 8 - Lt. Coral squares, 9 - Coral squares and 18 - White squares ( x, 16.51cm x 16.51cm) in eleven rows. Pin, sew RST and press toward the coral squares in each row. Pin, sew and press the rows together, nesting the seams. Dia. B Row 1 Row 2 Row 3 Row 4 Row 5 Row 6 Row 7 Row 8 Row 9 Row 10 Row 11 page 3

4 4. The sewn quilt top should measure approximately 42 ½" x 51" (1.08m x 1.30m) between the seam intersections around the outside edges. Trim all four sides 1" (2.54cm) inside the seam intersections for a finished size of 40 ½" x 49" (1.08m x 1.25m) as shown in Diagram C. Tip: Use 1" (2.54cm) painter's tape to provide a straight cutting edge and to keep the bias edges from stretching. Dia. C Trim 1" 40 ½" x 49" (1.03m x 1.24m) 42 ½" x 51" (1.08m x 1.30m) 40 ½" x 49" (1.03m x 1.24m) 5. The backing yardage is sufficient to cover the length and width of the top. If using a long arm to quilt, extra fabric basted onto backing edges might be necessary. Quilting 6. Press finished quilt top and backing fabric. Tape the backing wrong side up to a firm surface. Layer batting and quilt top (right side up). Baste the layers together with safety pins. Refer to quilting (Diagram D) for a simple yet creative quilting design. Quilt in the ditch (next to each seam), between the rows to anchor the quilt top to the backing. Quilt diagonal lines through the center of each row to complement the argyle look of this quilt. Use a removable marker (test first) or masking tape to mark lines for a stitching guide or a guide attachment for the presser foot. Tip: Sewing with an even-feed foot is helpful when quilting through layers. This feeds the fabric more evenly and prevents wrinkles on the back of the quilt. Once quilting is complete, square up corners and edges, trimming excess backing and batting even with the quilt top. Dia. D page 4

5 Finishing 7. To make the binding, remove selvages and sew the short ends of the 2 ½" x 42" (6.35cm x 1.07m) strips RST end to end at a 45 angle to make one continuous strip; press seams open. Press one short end ¼" (6.35mm) to the wrong side. Fold in half lengthwise with wrong sides together; press. Leaving a 2" (5.08cm) tail on the folded end, place cut edges of folded binding even with the edge of the quilt top and sew, mitering the corners. Overlap ends, trim any excess and finish sewing the binding. Fold binding over to back and hand stitch. Finished Care Instructions Machine wash in cold water; gentle cycle. Tip: Before drying, check for fabric dyes that may have run. If fabric dyes run, rewash and rinse using Shout Color Catcher. Lay flat to dry or tumble dry low. page 5

Little Forest Quilt. 1. Use a rotary cutter and acrylic ruler to cut the number of pieces from each fabric as shown.

Little Forest Quilt. 1. Use a rotary cutter and acrylic ruler to cut the number of pieces from each fabric as shown. Little Forest Quilt Finished Size: 40 ½" x 48 ½" (102.87cm x 123.19cm). Supplies Needed 3 Wishes Fabric Little Forest Collection 5 8 yd. (57.15 cm) - 12944-Gray 3 8 yd. (34.29cm) - 12949-Brown (binding)