SECTION 6 SHELVING SHELVING. SHELVING Multi-function Shelves

Transcription

1 SECTION 6 Multi-function Shelves Center Shelves - Adjustable Angle Corner Shelves - Laminate with Brackets Storage Shelves - igh and Low Shelving Roll-out Shelves Shelf ividers Shelf Add-on Lip

2 MULTI-FUNCTION SELVES MFS (flat) MFS (sloped) ESCRIPTION Shelves provide general storage in workstations. Assemblies each include two steel support brackets and one shelf with a 1 /2" raised edge that can be positioned in the front or back. No hardware or tools are needed for assembly. Shelves mount flat or in a sloped position. issipative shelves each include an ES Cable Kit Assembly for grounding. Load capacity 200 lbs. evenly distributed. Shelf epth Shelf Slope " 17 18" 21 24" 15 hen mounted on Fabric or Laminate Panels in the flat position, there is a 3 /8" gap between the back of each shelf and the Panel limiting the amount of space for cord drops. Greenlee Manual Round Knockout Punches can be purchased for field installation of shelf grommets. Contact them at for a distributor near you. Shelf Add-on Lip sold separately; see page 6.9. TOP Top TO ORER, SPECIFY: 2) Finish Standard or issipative issipative Finish: G issipative Grey Light Smooth SIE Side PROUCT IMENSIONS Product eight idth epth eight MFS1124 MFS1130 MFS1136 MFS1148 MFS1160 MFS1172 MFS1524 MFS1530 MFS1536 MFS1548 MFS1560 MFS1572 MFS1824 MFS1830 MFS1836 MFS1848 MFS1860 MFS1872 MFS2424 MFS2430 MFS2436 MFS2448 MFS [1829] 72 [1829] 72 [1829] 15 [7] 17 [8] 19 [9] 21 [10] 25 [11] 30 [14] 17 [8] 20 [9] 23 [10] 27 [12] 32 [15] 37 [17] 18 [8] 22 [10] 24 [11] 35 [16] 41 [29] 20 [19] 24 [11] 36 [16] 46 [20] 6.2 Rev

3 CENTER SELVES - A JUSTABLE ANGLE CSA TOP Top SIE Side ESCRIPTION Shelves provide general storage in workstations. Shelves mount within the openings of Ultra Frames and can be center mounted or offset 4" to the front or back of the frames. Assemblies each include two steel support brackets and one shelf with a 1 /2" raised edge that can be positioned in the front or back. Positioning of the brackets provides raised edges on the left and right sides when mounted. Shelves mount flat or in one of two sloping positions, 8 or 16. Slopes are set with threaded fasteners. issipative shelves each include an ES Cable Kit Assembly for grounding. Load capacity 200 lbs. evenly distributed. TO ORER, SPECIFY: 2) Finish Standard or issipative issipative Finish: G issipative Grey Light Smooth Center Shelves cannot be mounted on ErgoStat Riser Spines. PROUCT IMENSIONS Product eight idth epth eight CSA24 CSA30 CSA36 CSA48 CSA60 18 [457] 42 [1067] 54 [1372] 19 [9] 23 [10] 25 [11] 30 [14] 37 [17] 6.3

4 CORNER SELVES - LAMINATE IT BRACKETS SIE ESCRIPTION Shelves provide general storage in corner workstation configurations. The 1" double-sided laminate shelves include matching vinyl Edgeband. Assemblies each include three steel support brackets which are notched to al for the routing of cables. Symbiote surfaces are manufactured with Nevamar Static issipative Laminates (SL). Nevamar SL is manufactured to have a point to point and point to ground resistance of 1 x 10 6 to 1 x % relative humidity. Nevamar Static issipative Laminates conform to ES Association Standard ES-S4.1. issipative shelves are manufactured using laminate on the top side with matching non- laminate on the underside and each include a Laminate Grounding Terminal Kit. Load capacity 200 lbs. evenly distributed. To order, specify laminate finish first, support finish second. For example, CSL1548GLGT specifies Grey Light laminate shelf with Grey Light Texture supports. Corner Shelves are predrilled for attachment of Universal Cable Trays; see page " and 48" wide shelves are predrilled for Shelf Mount Light Brackets for 32" wide igh Performance Task Lights; see page Other laminates available upon request; consult factory for ordering information. Customers are responsible for specifying ES surface requirements; corporate ES s must be consulted prior to ordering. PROUCT IMENSIONS TO ORER, SPECIFY: 2) Laminate Standard or issipative Standard Laminates: GF Grey Fleck GL Grey Light SA Sand SF Sand Fleck F hite Fleck issipative Laminates: G issipative Grey Light N issipative Neutral hite S issipative Sand BK issipative Black 3) Support Finish Standard or issipative issipative Finish: G issipative Grey Light Smooth Product eight idth epth eight Number escription in. [mm] in. [mm] in. [mm] lb. [kg] CSL1524 CSL1530 CSL1536 CSL [9] 41 [19] 70 [32] CSL [10] CSL [14] CSL [20] CSL [33] CS1524 CS1530 CS1536 CS [9] 41 [19] 70 [32] CS [10] CS [14] CS [20] CS [33] TOP 6.4 Rev

5 STORAGE SELVES - IG AN LO SL S S FRONT Front SIE Side ESCRIPTION Shelves provide general storage in workstations. Assemblies each include two steel shelf ends and one bottom shelf with a 1 /2" raised edge that can be positioned in the front or back. Shelves mount flat or in one of two sloping positions, 8 or 16. Slopes are set with threaded fasteners. issipative shelves each include an ES Cable Kit Assembly for grounding. Load capacity 200 lbs. evenly distributed. TO ORER, SPECIFY: 2) Finish Standard or issipative issipative Finish: G issipative Grey Light Smooth hen mounted on closed Fabric or Laminate Panels in the flat position, there is a 3 /8" gap between the back of each shelf and the panel limiting the amount of space for cord drops. PROUCT IMENSIONS Product eight idth epth eight SL1524 SL1530 SL1536 SL1548 SL1560 S1524 S1530 S1536 S1548 S [9] 21 [10] 22 [10] 25 [11] 26 [12] 29 [13] 32 [15] 35 [16] 6.5

6 IG ENSITY SELVES L FRONT SIE TOP SIE ESCRIPTION igh density shelves mount on a frame, panel or wall strips. Shelves are vertically adjustable in 2 1 /2" increments and can be installed in three positions (flat, 11 and 22 degrees). Available as a three shelf or five shelf unit. Load capacity is 200 lbs. per unit (both three and five shelf units). Add-on shelves and front shelf s also available. TO ORER, SPECIFY: 2) Finish End panels are constructed of MF board and are powder coated. Mounting brackets and shelves are metal and color matched. PROUCT IMENSIONS Product eight idth epth eight Number escription in. [mm] in. [mm] in. [mm] lb. [kg] B1524 B1530 B1536 B1548 B1560 C1524 C1530 C1536 C1548 C [17] 42 [19] 48 [22] 59 [27] 71 [32] 60 [27] 69 [31] 79 [36] 98 [44] 117 [53] [25] 22 1 /2 [572] 15 1 /4 [387] 8 [4] [25] 28 1 /2 [724] 15 1 /4 [387] 10 [5] [25] 34 1 /2 [876] 15 1 /4 [387] 12 [6] [25] 46 1 /2 [1181] 15 1 /4 [387] 15 [7] [25] 58 1 /2 [1486] 15 1 /4 [387] 19 [9] L24 1 /2 [38] 22 1 /2 [572] 1 [25] 1 1 /2 [1] L30 1 /2 [38] 28 1 /2 [724] 1 [25] 2 [1] L36 1 /2 [38] 34 1 /2 [876] 1 [25] 2 1 /2 [1] L48 1 /2 [38] 46 1 /2 [1181] 1 [25] 3 [2] L60 1 /2 [38] 58 1 /2 [1486] 1 [25] 4 [2] 6.6 Rev

7 ROLL-OUT SELVES TOP SIE ESCRIPTION Shelves provide general storage in workstations. Shelves roll out for easy access to the backside of the shelf and lock in the closed position using the push-button release adjacent to the handle of the front of the shelf. Assemblies each include full-extension ball-bearing slides, two steel support brackets, a stretcher and a shelf with a single handle and pushbutton release aling one-handed operation of the shelf lock. Shelves extend from the front of the 21 7 /8" brackets when fully extended. andle extends 1 1 /4" from the front of the shelf. Load capacity 150 lbs. evenly distributed. TO ORER, SPECIFY: 2) Finish Standard or issipative issipative Finish: G issipative Grey Light Smooth Roll-out Shelves cannot be mounted next to C Legs that are attached to the same Ultra Frames; Connector Posts with C Legs or return frames must be used for support. No more than one loaded Roll-out Shelf should be extended at the same time. Extended C Legs or 30" wide return frames are recommended for use with Roll-out Shelves. Consult factory for design uses. PROUCT IMENSIONS Product eight idth epth eight Number escription in. [mm] in. [mm] in. [mm] lb. [kg] RSM2424 RSM2430 roll-out shelf roll-out shelf 9 3 /4 [248] 9 3 /4 [248] 22 1 /2 [572] 28 1 /2 [724] 24 1 /4 [616] 24 1 /4 [616] 46 [21] 53 [24] 6.7

8 SELF IVIERS Side SIE FRONT Front ESCRIPTION ividers vertically separate paper, folders, books and binders on shelves. ividers mount to Multi-function, Low Profile, General Purpose, Center and Storage Shelves in the flat position only. Scored mounting tabs al for easy bending to hold Shelf ividers in place once installed on shelves. ividers are sold in packages of 5. TO ORER, SPECIFY: 2) Finish Standard or issipative issipative Finish: G issipative Grey Light Smooth Shelf ividers will not mount on Corner, ire, Roll-out Shelves or Storage Cabinets. PROUCT IMENSIONS Product eight idth epth eight SV /4 [45] 11 [279] 6 [3] 6.8 Rev

9 SELF A-ON LIP FRONT SIE ESCRIPTION Shelf add-on mounts to the front of Multi-Function Shelves. One-piece steel assembly provides a to secure contents. TO ORER, SPECIFY: 2) Finish Standard or issipative issipative Finish: G issipative Grey Light Smooth Multi-Function Shelf sold separately; see page 6.2. PROUCT IMENSIONS Product eight idth epth eight MFSL24 MFSL30 MFSL36 MFSL48 MFSL60 MFSL72 72 [1829] 2 [1] 2 [1] 3 [1] 3 [1] 4 [2] 5 [2] 6.9 Rev