MIL STD 461F TEST REPORT. For. Rugged PDA. Model Number: P37B. Trade Name: N/A. Issued to

Transcription

1 MIL STD 461F TEST REPORT For Rugged PDA Model Number: P37B Trade Name: N/A Issued to ACA Digital Corporation 17F.,No 866-7, Zhongzheng Rd, Zhonghe City, Taipei County, 235, Taiwan, R,O,C Issued by Compliance Certification Services Inc. No. 11, Wugong 6 th Rd., Wugu Industrial Park Taipei Hsien 248, Taiwan service@tw.ccsemc.com Note: This report shall not be reproduced except in full, without the written approval of Compliance Certification Services Inc. This document may be altered or revised by Compliance Certification Services Inc. personnel only, and shall be noted in the revision section of the document. Page 1 Total Page: 14 Rev. 00

2 TABLE OF CONTENTS 1. TEST RESULT CERTIFICATION EUT DESCRIPTION TEST METHODOLOGY INSTRUMENT AND CALIBRATION MEASURING INSTRUMENT CALIBRATION MEASUREMENT EQUIPMENT USED FACILITIES AND ACCREDITATIONS FACILITIES SETUP OF EQUIPMENT UNDER TEST SETUP CONFIGURATION OF EUT PHOTOGRAPHS OF EUT SUPPORT EQUIPMENT TEST SETUP MIL STD 461F REQUIREMENTS CE102, CONDUCTED EMISSIONS, POWER LEADS, 10 KHZ TO 10MHZ APPENDIX I PHOTOGRAPHS OF TEST SETUP Page 2 Rev. 00

3

4 2. EUT DESCRIPTION Product Rugged PDA Trade Name N/A Model Number P37B Model Discrepancy N/A Remark: for more details, please refer to the User s manual of the EUT. Page 4 Rev. 00

5 3. TEST METHODOLOGY All tests were performed in accordance with the procedure documented in MIL STD 461F. 4. INSTRUMENT AND CALIBRATION 4.1 MEASURING INSTRUMENT CALIBRATION The measuring equipment, which was utilized in performing the tests documented herein, has been calibrated in accordance with the manufacturer s recommendations for utilizing calibration equipment, which is traceable to recognized national standards. 4.2 MEASUREMENT EQUIPMENT USED Equipment Used for Emissions Measurement CE102 (966 Chamber B) Name of Equipment Manufacturer Model Serial Number Calibration Due EMI Test Receiver R&S ESCI /24/2010 Spectrum Analyzer Agilent E4446A MY /24/2010 Pre-Amplifier Mini-Circuits ZKL-1R /01/2010 Coaxial Cable Huber Suhner SUCOFLEX /01/2010 Coaxial Cable Huber Suhne SUCOFLEX /01/2010 LISN R&S AT/A /27/2009 Site NSA CCS N/A N/A 12/28/2010 Software Turbo C++ Page 5 Rev. 00

6 5. FACILITIES AND ACCREDITATIONS 5.1 FACILITIES All measurement facilities used to collect the measurement data are located at No.199, Chunghsen Road, Hsintien City, Taipei Hsien, Taiwan, R.O.C. Tel: / Fax: No.11, Wugong 6th Rd., Wugu Industrial Park, Taipei Hsien 248, Taiwan Tel: / Fax: No.81-1, Lane 210, Bade 2nd Rd., Luchu Hsiang, Taoyuan Hsien 338, Taiwan Tel: / Fax: The sites are constructed in conformance with the requirements of ANSI C63.7, ANSI C63.4 and CISPR Publication 22. Page 6 Rev. 00

7 6. SETUP OF EQUIPMENT UNDER TEST 6.1 SETUP CONFIGURATION OF EUT See test photographs attached in Appendix 1 for the actual connections between EUT and support equipment. 6.2 PHOTOGRAPHS OF EUT See test photographs attached in Appendix 2 for the EUT s internal structure. 6.3 SUPPORT EQUIPMENT No. Device Type Brand Model Series No. FCC ID Data Cable Power Cord 1 N/A N/A N/A N/A N/A N/A N/A Remarks: 1. All the above equipment/cables were placed in worse case positions to maximize emission signals during emission test. 2. Grounding was established in accordance with the manufacturer s requirements and conditions for the intended use. 6.4 TEST SETUP The equipment under test was configured and connected to support unit in normal operation continuously. EUT tends to maximize its emission characteristics in a typical application for conducted emission measurement. The EUT was active during the conducted emission measurements. Page 7 Rev. 00

8 7. MIL STD 461F REQUIREMENTS 7.1 CE102, conducted emissions, power leads, 10 khz to 10MHz LIMIT Conducted emissions on power leads shall not exceed the applicable values shown on Figure CE FIGURE CE CE102 limit (EUT power leads, AC and DC) for all applications. Page 8 Rev. 00

9 TEST CONFIGURATION TEST PROCEDURE The magnetic emission of EUT representative of its type shall be tested by the method(s) according to MIL STD 461F. Page 9 Rev. 00

10 TEST RESULTS No non-compliance noted Test Data 0.01MHz-0.15MHz-L1 Job No.: Polarization: L1 Standard: MIL-STD-461F CE102 (AC&DC)-115V Power Source: AC 110V/60Hz Test item: Conduction Test Date: 2008/10/23 Temp.( )/Hum.(%): 22( )/51% Time: 上午 10:17:30 Company: ACA Digital Corporation Engineer Eric Signature: Trade Name: N/A Distance: Model: P37B RBW: 1kHz VBW: 1kHz Description: No. Frequency Reading Factor Result Limit Margin Detector P/F Remark (KHz) (dbuv) (db) (dbuv) (dbuv) (db) peak P peak P peak P peak P peak P peak P Page 10 Rev. 00

11 0.15MHz-10MHz-L1 Job No.: Polarization: L1 Standard: MIL-STD-461F CE102 (AC&DC)-115V Power Source: AC 110V/60Hz Test item: Conduction Test Date: 2008/10/23 Temp.( )/Hum.(%): 22( )/51% Time: 上午 10:19:51 Company: ACA Digital Corporation Engineer Eric Signature: Trade Name: N/A Distance: Model: P37B RBW: 10kHz VBW: 10kHz Description: No. Frequency Reading Factor Result Limit Margin Detector P/F Remark (MHz) (dbuv) (db) (dbuv) (dbuv) (db) peak P peak P peak P peak P peak P peak P peak P Page 11 Rev. 00

12 0.01MHz-0.15MHz-L2 Job No.: Polarization: L2 Standard: MIL-STD-461F CE102 (AC&DC)-115V Power Source: AC 110V/60Hz Test item: Conduction Test Date: 2008/10/23 Temp.( )/Hum.(%): 22( )/51% Time: 上午 10:23:01 Company: ACA Digital Corporation Engineer Eric Signature: Trade Name: N/A Distance: Model: P37B RBW: 1kHz VBW: 1kHz Description: No. Frequency Reading Factor Result Limit Margin Detector P/F Remark (KHz) (dbuv) (db) (dbuv) (dbuv) (db) peak P peak P peak P peak P peak P peak P Page 12 Rev. 00

13 0.15MHz-10MHz-L2 Job No.: Polarization: L2 Standard: MIL-STD-461F CE102 (AC&DC)-115V Power Source: AC 110V/60Hz Test item: Conduction Test Date: 2008/10/23 Temp.( )/Hum.(%): 22( )/51% Time: 上午 10:22:18 Company: ACA Digital Corporation Engineer Eric Signature: Trade Name: N/A Distance: Model: P37B RBW: 10kHz VBW: 10kHz Description: No. Frequency Reading Factor Result Limit Margin Detector P/F Remark (MHz) (dbuv) (db) (dbuv) (dbuv) (db) peak P peak P peak P peak P peak P peak P peak P Page 13 Rev. 00

14 8. APPENDIX I PHOTOGRAPHS OF TEST SETUP CE102, conducted emissions, power leads, 10 khz to 10 MHz. Page 14 Rev. 00