E Series. Electric Actuators. Approved. On-Off and Modulating Electric Actuators Torques to 30,000 in. lbs. Weatherproof Construction

Transcription

1 pproved ONTROLS ivision of -T ontrols Series lectric ctuators On-Off and Modulating lectric ctuators Torques to 0,000 in. lbs. Weatherproof onstruction

2 Triac ontrols line of electric actuators offers a broad range of torques from 00 to 0,000 in. lbs. and numerous features including manual overrides, auxiliary switches, -0ma modulating control, several voltage options including -phase /0V/0V and V, -phase 0v, 80v, and 0v. The units feature PI-YLIL gear trains and a unique manual override with handwheel. ll actuators are NM x and are designed for maximum cycle life due to our rugged motors and gear trains. s with all Triac actuators, our Series electrics are available with mounting kits on most ball, butterfly and plug valves. The actuators are ideal for use on butterfly and louver dampers with the increased benefit of self-locking PI-YLIL gears, eliminating the need for unreliable solenoid brakes. eatures orrosion resistant NM,x construction ie cast aluminum housing and cover Powder polyurethane coated Stainless steel fasteners S and pproved S certification No. 80 regulation No. N980 Self-locking PI-YLIL gear train No brake required TI-00/TI-00 features self-locking motor with spur gears. manual override with handwheel Not available on TI-00/TI-00 Manual override can be operated without any lever, clutch or brake upon power outage. When actuator is operating, handwheel is stationary assuring safety to personnel. Visual position indicator two auxiliary limit switches (0amp at 0V) Torque switches () standard on models TI-800 and larger Optional on models TI-00 through TI-00 Optional servo card for modulating service -0m, -m, -vdc, 0-0vdc, command signal potentiometer inputs Optional -0m transmitter haracterized output linear, quick opening, equal percent ISO mounting patterns liminates mounting kits to direct mount valves Mounting kits available for ISO and other valve mounting patterns uilt-in thermal protection to prevent overheating motor windings Heater and thermostat to prevent condensation buildup

3 Series Torque and Performance ata S MOL TI-00 TI-00 TI-00 TI-00 TI-00 TI-00 TI-00 TI-800 TI-000 TI-000 TI-000 TI-000 TI-0000 TORQU (in lbs) (nm) SP (sec.) (per 90 degrees) LOK ROTOR MPS PHS MOTORS PHS MOTORS MOTORS V.8.8 V V V V V V V.8.8 T:. Operating speeds is nominal at rated torques. inal operating speed may vary depending on actual service.. ctuators with Vdc motors will have an operating speed of approximately 0% longer (slower) than that shown.. uty ycle= ffective uninterrupted motor run period versus cool down period 0% uty ycle=one period of motor run followed by one period at rest to cool down. all factory for extended duty applications UTY YL 0% 0% 0% 0% 0% 0% 0% 0% 0% 0% 0% 0% 0% MNUL OVRRI Options Speed ontrol The Triac Speed ontrol is a compact module that extends the operating time of the Series powered actuator by pulsing the motor on and off. xtending the cycle time of an actuator can avoid problems associated with water hammer and control system instabilities. ontrol oxes ontrol boxes are available for a variety of local control options, such as local/remote open-offclose and jogging control. NM housings are used as standard, but other housings are available upon request. Potentiometer n optional potentiometer can provide a resistance (0-ohm, 0-Kohm, 0-Kohm, 0-0Kohm) signal proportional to the actuator s position. The potentiometer can give continuous feedback to control panels and other closed loop devices. Two Wire ontrol When using the optional two wire control, the Series () position electric actuator can be controlled with a low voltage signal. When the voltage is present, the spring loaded relay will trip, energizing the actuator to rotate clockwise or counterclockwise. When the voltage is removed, the spring will untrip the relay, energizing the actuator to rotate in the opposite direction.

4 TM lectronic Modulating ard eatures and enefits 0 bit Microprocessor ontroller for precise positioning - eliminates the need for an external deadband control. Programming of the controller is accomplished by a combination of push buttons and seven position IP switch without the need for a command signal. Input signals can be -0m, 0-0V, -V, or command signal potentiometer. The TM can be programmed to fail in place, fail clockwise or fail counter clockwise on loss of command signal. haracterize control - Linear, Quick opening (square root) or equal percentage (square) relationship between the actuator position and the command signal. W/W L RIV INITORS On oard - -0m Transmitter (Optional) or other voltages (V, V, 0V) consult factory. IP SWITH SLT IRT/RVRS TING IP SWITH SLT HRTRIZ ONTROL LINR QUIK OPNING QUL PRNTG L L L SW SW SW SW P JP T T JUMPR SLT INPUT -0m -m 0-0Vd OMMN SNSITIVITY TUTOR WIRING USTOMR ONNTIONS (STNR INPUTS) USTOMR ONNTIONS (OMMN POTNTIOMTR) W LS TS T T T NUTRL V NUTRL V NUTRL T 0 9 W LS TS GN W WIPR +V K POTNTIOMTR T SH. OPTIONL + 0 M OUTPUT SIGNL 0 0V + 0M M + V INPUT SIGNL T SH. OPTIONL + 0 M OUTPUT SIGNL W OMMN POTNTIOMTR LS- LS- TS:. IL WIRING IS SHOWN OR RR ONLY N IS T SUPLI WITH TUTOR.. SWITHS R ROM OTTOM TO TOP. (i.e. switch is on the bottom, switch is the next one up, etc.). ROTTION IS VIW ROM TH MOTOR SI.. THRML OVRLO RSTS UTOMTILLY.. TS- N TS- R TORQU SWITHS. (optional on models 00 00) (standard on models ). TH OMMONS ROM SWITH LS- N LS- R ONNT TO TRMINL ON MOLS 00 N 00.. OR OMPLT INSTLLTION INSTRUTIONS RR TO IOM00.

5 imensional ata TI-00/00 On-Off MI-00/00 Modulating.00 IS TH MINIMUM LR OR SS. [08mm] I. WIGHTS (LS.) TI-00. TI [8mm] TI-00. [0mm] TI-00.0 [8mm] LOSUR ILU ON MI-00 & MI-00 MOLS ONLY. [0mm] I. OLT IRL /" NPT ONUIT ONNTION MNUL OVRRI (MOL 00 ONLY) M8 THR 0.0 P () PLS M x THR 0.8 P () PLS.00 [mm] M x 0.8 THR 0.8 P () PLS /" NPT ONUIT ONNTION () PLS MOUNTING OR TI-00 & MI [mm] ML SQ. 0. [mm] P. [mm] I..9 [0mm] I. OLT IRL OLT IRL MOUNTING OR TI-00 & MI [mm] ML SQ. 0.9 [mm] P TI-00/00 On-Off MI-00/00 Modulating TUTOR SHOWN IN TH ULL OUNTR-LOKWIS POSITION WHN VIW ROM TH MOTOR SI. K I OLT IRL WIGHTS (LS.) TI-00 0 TI-00 0 TI-00 9 TI-00 9 TI-00 9 L THR M P () PLS VIW H SQ J P POSITION INITOR "" IS TH MINIMUM LR OR SS I. MNUL OVRRI I. () /" NPT ONUIT ONNTION VIW - MHNIL TRVL STOPS TUTOR G H J K L M 00 / M M0 0.

6 imensional ata TI-800/000 On-Off MI-800/000 Modulating TUTOR SHOWN IN TH ULL OUNTR-LOKWIS POSITION WHN VIW ROM TH MOTOR SI. M x 0.8 [mm] P () PLS. [88mm] WIGHTS (LS.) TI TI [0mm] I.. [mm] SQ. 0MM P VIW 8. [0mm] I.. [0mm] 0. [0mm].0 [9mm] I.. [90mm] /" NPT ONUIT ONNTION VIW - TI On-Off MI Modulating TUTOR SHOWN IN TH ULL OUNTR-LOKWIS POSITION WHN VIW ROM TH MOTOR SI. M0 x.. [mm] P () PLS. [80mm] 9. [mm] WIGHTS (LS.) TI-000 TI-000 TI-000 TI [mm] I. VIW 0. [mm].9 [mm] I..9 [00mm] P. [mm]. [0mm] 0. [0mm] I.. [mm] /" NPT ONUIT ONNTION.09 [mm]. [00mm] I. VIW -

7 Wiring iagrams RWING TO Reversible V ctuator 0V/ph/0-0Hz IL WIRING RR ONLY T SUPPLI TUTOR WIRING RWING TO9 -Position ontrol 0V/ph/0-0Hz IL WIRING RR ONLY T SUPPLI TUTOR WIRING POWR LMP LMP W W LS- LS- HTR TS- TS- M THRML OVRLO POWR LMP LMP W W MI LS- LS- HTR TS- TS- M THRML OVRLO RWING TO -Wire ontrol 0V/ph/0-0Hz POWR ONTROL VOLTG IL WIRING RR ONLY T SUPPLI LMP LMP LS- LS- TUTOR WIRING LS- LS- HTR TS- TS- M THRML OVRLO JUMPR LS- LS- TS:. IL WIRING IS SHOWN OR RR ONLY N IS T SUPPLI WITH TUTOR. SWITHS R ROM OTTOM TO TOP (i.e. switch is on the bottom, switch is the next one up, etc.). ROTTION IS VIW ROM TH MOTOR SI.. THRML OVRLO RSTS UTOMTILLY.. TS- N TS- R TORQU SWITHS (optional on models 00 ~ 00) (standard on models 800 ~ 0000). UTION: LTRIL OPRTION O TH TUTOR MUST M THROUGH N INIVIUL SINGL POL ONTROL SWITH IN ORR TO ISOLT TH UNUS MOTOR WININGS.. TH OMMONS ROM SWITH LS- N LS- R ONNT TO TRMINL ON MOLS 00 N 00. LS- LS- RWING TO Reversible V ctuator V/V RWING TO8 Reversible Phase ctuator 0V/80V/0V ( phase/0-0hz) NGTIV POSITIV IL WIRING RR ONLY T SUPPLI POWR TUTOR WIRING HTR LS- LS- LS- LS- M TS:. IL WIRING IS SHOWN OR RR ONLY N IS T SUPPLI WITH TUTOR. SWITHS R ROM OTTOM TO TOP (i.e. switch is on the bottom, switch is the next one up, etc.). ROTTION IS VIW ROM TH MOTOR SI.. THRML OVRLO RSTS UTOMTILLY.. UTION: LTRIL OPRTION O TH TUTOR MUST M THROUGH N INIVIUL SINGL POL ONTROL SWITH IN ORR TO ISOLT TH UNUS MOTOR WININGS.. TH OMMONS ROM SWITH LS- N LS- R ONNT TO TRMINL ON MOLS 00 N 00. TUTOR WIRING HTR LS LS MOTOR LS TS LS TS U V W TS:. IL WIRING IS SHOWN OR RR ONLY N IS T SUPLI WITH TUTOR.. SWITHS R ROM OTTOM TO TOP. (i.e. switch is on the bottom, switch is the next one up, etc.). ROTTION IS VIW ROM TH MOTOR SI.. THRML OVRLO RSTS UTOMTILLY.. TS- N TS- R TORQU SWITHS. (optional on models 0 00) (standard on models ) O.L. R R R R LOS OPN NUTRL LIN Ø Ø Ø 0/80/0V PHS for complete wiring diagrams and IOM s

8 Order ode Triac Series lectric ctuators nclosures & ontrol Size Motor Voltages TI - luminum (S pproved) MI - -0m Modulating Service in-lbs in-lbs in-lbs in-lbs in-lbs in-lbs in-lbs in-lbs in-lbs in-lbs in-lbs in-lbs in-lbs lank - V/PH* - V - V - V/PH* - 0V/PH* - 0V/PH* G - 80V/PH* H - 0V/PH* *0HZ and 0HZ Switch Options lank - Two auxiliary limit switches ( on 00-00) T - Two auxiliary limit switches with torque switch ( on ) N - Three auxiliary limit switches T - Three auxiliary limit switches with torque switch eedback Options lank - No option T - -0m output Transmitter P Ohm Potentiometer P - 0-K Ohm Potentiometer P - 0-0K Ohm Potentiometer P - 0- Ohm Potentiometer ccessories lank - Manual Wormgear Overrride (standard on ) (No manual override avavilable for model 00 & 00) R - Wire Relay (V ontrol Voltage) R - Wire Relay (V ontrol Voltage R - Wire Relay (V ontrol Voltage) R - Wire Relay (V ontrol Voltage) S - lectronic Speed ontrol Module - Time elay (Same delay in both directions) - Time elay (different delay on both directions) XMPL: MI-00-T Triac lectric Modulating ctuator, 00 in-lbs., -0m, 0-0V or -V input signal, 0V/ Phase, () auxiliary limit switches, -0m transmitter, manual override with handwheel Other -T ontrols products include Rack & Pinion Pneumatic ctuators lectric ail-safe ctuators -T ontrols Gear Operators utomated all Valve Packages ISTRIUT Y 00 -T ontrols Group Y.K -T ontrols Group eerfield Rd. incinnati, Ohio X sales@a-tcontrols.com See our website!