IP67 TRC ELECTRONICS, INC LED Driver Constant Voltage 45W MEAN WELL ODLV-45 Series

Transcription

1 IP67 A

2 SPECIFICATION MODEL OUTPUT INPUT PROTECTION OTHERS NOTE FREQUENCY RANGE POWER FACTOR (Typ.) EFFICIENCY (Typ.) AC CURRENT (Typ.) INRUSH CURRENT(Typ.) LEAKAGE CURRENT OVER CURRENT TEMP. COEFFICIENT VIBRATION SAFETY STANDARDS MTBF DIMENSION PACKING ODLV45 12 ODLV45 24 ODLV45 36 ODLV45 48 ODLV ~ 63Hz 105 ~ 115% WORKING HUMIDITY 20 ~ 90% RH noncondensing ENVIRONMENT STORAGE TEMP., HUMIDITY 40 ~ 80, 10 ~ 95% RH SAFETY & EMC DC VOLTAGE RATED CURRENT RATED POWER DIMMING RANGE VOLTAGE TOLERANCE PWM FREQUENCY (Typ.) SETUP TIME Note.3 AUXILIARY DC OUTPUT Note.4 VOLTAGE RANGE Note.2 TOTAL HARMONIC DISTORTION MAX. No. of PSUs on 16A CIRCUIT BREAKER NO LOAD POWER CONSUMPTION SHORT CIRCUIT WORKING TEMP. MAX. CASE TEMP. WITHSTAND VOLTAGE ISOLATION RESISTANCE EMC EMISSION EMC IMMUNITY 12V 24V 36V 48V 60V 3.0A 1.88A 1.25A 0.94A 36W 45.12W 45W 45.12W 0~% ±10% 1KHz(±20%) 500ms / 2VAC 84% 86% 88% 88% 90% 0.6A / 115VAC 0.4A / 2VAC 0.3A / 277VAC <0.75mA / 277VAC ±0.03%/ (0 ~ 50 ) 10 ~ 500Hz, 2G 10min./1cycle, period for 60min. each along X, Y, Z axes UL8750(type"HL"),CSA C22.2 NO ;ENEC EN & EN independent, EN62384,GB ,GB ; IP67 approved I/PO/P:3.75KVAC I/PO/P:M Ohms / 500VDC / 25 / 70% RH 111*77*28.5mm (L*W*H) 1200ms/115VAC Nominal 12V(deviation 11.4~12.6)@50mA for AType only 90 ~ 295VAC 127 ~ 417VDC (Please refer to "STATIC CHARACTERISTIC" section) PF>0.95/115VAC, PF>0.92/2VAC, PF>0.9/277VAC@full load (Please refer to "POWER FACTOR (PF) CHARACTERISTIC" section) THD< 20%(@load 75%/277VAC) (Please refer to TOTAL HARMONIC DISTORTION section) COLD START A(twidth=150μ s measured at 50% Ipeak) at 2VAC; Per NEMA units (circuit breaker of type B) / 32 units (circuit breaker of type C) at 2VAC <0.5W for BlankType, <1.2W for AType Shut down O/P voltage, repower on to recovery Protection type : Hiccup mode, recovers automatically after fault condition is removed Tcase=20 ~ 85 (Please refer to OUTPUT LOAD vs TEMPERATURE section) Tcase= Kg;24pcs/11Kg/ 0.72CUFT 0.75A Compliance to EN55015, EN6032 Class C (@load 60%) ; EN6033,GB17743,GB Compliance to EN6042,3,4,5,6,8,11; EN61547, light industry level(surge immunity:lineline:1kv) K hrs min. MILHDBK217F (25 ) 45W

3 DIMMING OPERATION AUX(Green) AUX(Yellow) V0(Black) V 0(Red) DIM(Gray) DIM(Purple) Dimming principle for PWM style output Dimming is achieved by varying the duty cycle of the output current. Output DC current ON TON Duty cycle(%) = T % Io=0A TON OFF Output PWM frequency : 1KHz(±20%) T 2 in 1 dimming function Applying additive 0 ~ 10VDC % 90% Vo Vo DIM DIM Additive Voltage Duty cycle of output current (%) 80% 70% 60% 50% 40% % 20% 10% DO NOT connect "DIM to Vo 0% 0V 1V 2V 3V 4V 5V 6V 7V 8V 9V 10V Dimming input: Additive voltage Applying additive 10V PWM signal (frequency range 0~00Hz): Vo Vo DIM Additive PWM signal DIM DO NOT connect "DIM to Vo Duty cycle of output current (%) % 90% 80% 70% 60% 50% 40% % 20% 10% 0% 0% 10% 20% % 40% 50% 60% 70% 80% 90% % Duty cycle of additive 10V PWM signal dimming input Note : 1. Min. duty cycle of output current is about 8% and the output current is not defined when 0%< Iout<8%. 2. The duty cycle of output current could drop down to 0% when dimming input is about 0Vdc or 10V PWM signal with 0% duty cycle

4 OUTPUT LOAD vs TEMPERATURE LOAD (%) LOAD (%) (HORIZONTAL) (HORIZONTAL) AMBIENT TEMPERATURE,Ta ( ) Tcase ( ) STATIC CHARACTERISTIC POWER FACTOR (PF) CHARACTERISTIC Tcase at for 12V model 1.00 LOAD (%) for others PF (45W) 2(45W) 115(36W) INPUT VOLTAGE (V) % 60% 70% 80% 90% % LOAD Derating is needed under low input voltage. TOTAL HARMONIC DISTORTION (THD) EFFICIENCY vs LOAD ODLV45 series possess superior working efficiency that up to 90% can be reached in field applications. 60V Model,Tcase at 75 60V Model,Tcase at 75 91% THD(%) 19.00% 17.00% 15.00% 13.00% 11.00% 9.00% 277(45W) 2(45W) 115(36W) EFFICIENCY(%) 90% 89% 88% 87% 277(45W) 2(45W) 115(36W) 7.00% 86% 5.00% 50% 60% 70% 80% 90% % LOAD 85% 50% 60% 70% 80% 90% % LOAD

5 BLOCK DIAGRAM fosc : 70~150KHz RECTIFIERS AUX(for AType) AUX(for AType) I/P EMI FILTER & RECTIFIERS POWER SWITCHING RECTIFIERS & FILTER CURRENT LIMIT Vo Vo DIM DIM O.L.P. PWM&PFC CONTROL DETECTION CIRCUIT DRIVING METHODS OF LED MODULE This series work in Constant Voltage mode to drive the LEDs. In the constant current region, the highest voltage at the output of the driver depends on the configuration of the end systems. Vo(%) 50 (min.) (A) Constant Voltage area (C) Hiccup Protection (B) Constant Current area Should there be any compatibility issues, please contact TRC MEAN Electronics WELL. for details. 50 Io(%) Typical output current normalized by rated current (%)

6 MECHANICAL SPECIFICATION Case No.ODL45A Unit:mm BlankType: 111 Vo(Black) Vo(Red) DIM(Gray) DIM(Purple) 150±10 tc 77 tc : Max. Case Temperature 2*ψ4.5 AC wire No. Assignment(AC IN) SVT 18AWG SVT 18AWG DC wire No. Assignment(DC OUT) Vo(Black) UL7 18AWG Vo(Red) UL7 18AWG DIM(Gray) UL7 22AWG DIM(Purple) UL7 22AWG 2.5 AType: 111 AUX(Green) AUX(Yellow) Vo(Black) Vo(Red) DIM(Gray) DIM(Purple) 150±10 150± tc tc : Max. Case Temperature 2*ψ4.5 AC wire No. Assignment(AC IN) SVT 18AWG SVT 18AWG INSTALLATION MANUAL Please refer to : DC wire No. Assignment(DC OUT) AUX(Green) UL7 22AWG AUX(Yellow) UL7 22AWG Vo(Black) UL7 18AWG Vo(Red) UL7 18AWG DIM(Gray) UL7 22AWG DIM(Purple) UL7 22AWG