DREXELBROOK. Universal Lite Series. RF Level Transmitter

Transcription

1 DREXELBROOK A Leader In Level Measurement Solutions Universal Lite 09-1 Series RF Level Transmitter The DREXELBROOK Universal Lite RF Level indicating transmitter provides a low-cost solution to most level applications and is superi in reliability and perfmance. Drexelbrook's 09-1 Series two-wire RF Level transmitter provides dependable, low-cost level indication and control that is suitable f all liquid, and interface applications that do not leave a severe build-up on the sensing elment. F applications where heavy build-up is expected, Drexelbrook offers the Universal Admittance transmitter. Easy Calibration Saves Time Push button calibration is menu-driven through a full 4-digit LCD display that resides integral to the electronic unit. No hand-held calibration/ configuration terminals are required f a fast basic setup. Consistent Accuracy Microprocess-based circuitry means precise level indication along the entire sensing element. Internal circuitry provides ambient temperature compensation. Reliability Drexelbrook s exclusive circuitry ensures dependable level indication in applications with light moderate coatings. Eliminate Routine Maintenance No moving parts to break wear out. No need f routine maintenance recalibration. A convenient integrally mounted package ( remote up to 0 feet) comes with optional local indication through a full 4-digit LCD display. Calibration and configuration is quick and easy through menu-driven push button selection. Each system is available with: User definable display. (percent engineering units). Easy 2-point calibration. Adjustable time delay provides signal damping. Meter trim to adjust the output signal to a known plant standard. Real-time View of input capacitance values. Optional display/keypad f quick and easy setup and local indication. The Universal Lite can also be configured with the HART Model 27 Communicat optional AMETEK Drexelbrook PC software f me detailed setup and diagnostics. Digital Display An optional full 4-digit LCD display can be set up to read in percent engineering units.

2 Universal Lite 09-1 Series Specifications Power Requirement 18 to 30 Vdc, HART 13 to 30 Vdc, Analog Output 4-20mA Analog, 4-20mA HART Protocol, Digital HART Protocol Maximum Load Resistance 0 ohms, HART with modem/gateway Vdc, Analog Minimum Resistance 20 ohms f HART protocol Supply Voltage Effect 0.0% / 10Vdc Linearity 0.2% of span Response Time: Less than 1 second with no damping time 1-90 seconds programmable damping time Spark Protection 10A standard (100A optional) Fail Safe Direct Acting/Reverse Acting Electronic Housing: Meets NEMA 1- and 12 including NEMA 4X. Suitable f Class I, Groups A, B, C, D; Class II, Groups E, F & G; Class III; Div. 1 & 2. The housing is suitable f Explosion Proof installations in Div. 1 hazardous locations when the electronics are powered from an approved source. Refer to system Control Drawings f proper and safe installation and wiring. Ambient Temperature Limits -40 F to 18 F (-40 C to 8 C) Maximum 0 feet (1 m) (remote systems) Span Range (Typical) 3" (76 mm) to 100' (30 m) on waterbased materials. 3' (914 mm) to 100' (30 m) on ganic materials 140 feet maximum span range f a system Calibration Three button keypad, PC-based software, Model 27 Calibrat Area Classifications: Cables and Senss are intrinsically safe f all Groups, Division 1 & 2 when the electronics are powered from an approved source. The electronics are intrinsically safe f Groups C, D, E, F & G, Division 1 when powered from an approved source. The system (electronic unit, cable and sens) is designed to be non-incendive and nonsparking and suitable f all Groups, Div. 2 without intrinsic safety barriers. Display Integral 4-digit LCD Minimum Resistance to Ground 100,000 ohms (with less than a 1.0% effect on output signal) Temperature Stability 0.1% per 30 F (17 C) Approvals CE Mark, KEMA (CENELEC), FM, CSA of Electronics Top View 2 7/8 (7) Agency Approvals 0 = None F = FM C = CSA K = KEMA Electronic Unit Display/Keypad Option ( ) 0 = Without display/keypad 1 = With display/keypad 3/8 (137) 7/8 (149) 4 13/16 (122) Typical 1 1/8 (29) in inches (mm) Frequency 0 = 100 khz 1 = 1 khz 2 = 400 khz (Integral Only) 9 3/8 (238) Power In Housing options 1 = Chassis only 4 = Remote Nema 4X Explosionproof with 3 4-inch NPT = Integral Nema 4X Explosionproof with viewpt and 1-inch NPT 6 = Remote Nema 4X with Drexelcote and 3 4-inch NPT 8 = Integral Nema 4X with Drexelcote and 3 4-inch NPT Nema 4X Explosionproof with 3 4-inch NPT C = Integral Nema 4X Explosionproof with 1-inch NPT D = Integral Nema 4X Explosionproof with Drexelcote and 1-inch NPT E = Remote Nema 4X Explosionproof with viewpt and 3 4-inch NPT F = Integral Nema 4X Explosionproof with viewpt and 3 4-inch NPT Standard Housing 4 13/16 (122) Typical Optional Display 10 7/32 Power In Optional High Dome Housing with Viewpt U.S.A. Sales: Hour Service: International Suppt: Fax: AMETEK Nihon Drexelbrook AMETEK Singape Pte. Ltd. AMETEK Precision Instruments Europe 2 Chome 12-7 Minami Gyotoku 10 Ang Mo Kio Street 6 Rudolf-Diesel-Strasse 16 DREXELBROOK Ichikawa City Chiba Japan #0-12 Techpoint 6909 Singape D Meerbusch Germany Phone: Phone: Phone: Fax: Fax: Fax: Keith Valley Road nd@nihon-drexelbrook.co.jp aspl@ametek.com.sg Web: Hsham PA U.S.A. - drexelbrook.info@ametek.com Web , by AMETEK, Inc. All rights reserved. Printed in the U.S.A A Issue#

3 09-1-X09 Universal Lite Smart Level Transmitter featuring Dilute Caustic (< 2%) Water Inganic Acids (Reagents) Do not use with: Hydofluic Acid Sludge Ferric Chlide Slurries psi BAR psi BAR Less than two hsepower (greater if suppted) Power In I _. : 316 SS and TFE (bonded) ¾-inch NPT (standard) Flange 3/8 OD Rod (9.7) TFE Insulation in inches (mm) 20 Feet maximum (6.1m) CD. in inches = (example 48 inches = 048.0) Maximum recommended insertion length = 240 inches F longer lengths, consult facty. BGB = 0 mm 40 bar 316SS Condulet (F Remote Package Only) 09-1-X09-MN

4 09-1-X2 Universal Lite Smart Level Transmitter featuring Water Acids Alcohols I _. in inches = (example 48 inches = Maximum = ) 1000 psi ( F (38 C) 00 psi ( F (10 C) Less than 1/3 hsepower TFE, 316 SS and PFA (bonded) to Power In ¾-inch NPT Flange Insertion Length 140 feet (43 m) maximum span 1½ (38) 6 (12) in inches (mm) TFE Sheath.093 OD (2.36) Flexible Cable ¾ (19) PFA Insulation TFE Bottom Termination CD ½-20 UNC TFE Weight BGB = 0 mm 40 bar 316SS Condulet (F Remote Package Only) 09-1-X2-MN

5 09-1-X38 CheckWell Lite Smart Water Level Monit featuring Production Wells Moniting Wells Observation Wells Remediation Wells Artesian Wells Level Drawdown 00 psi ( F (148 C) PVC, 316 SS and PFA 2¾ (69) ¾-inch NPT 10 inches maximum (24) F _._ BAO in inches = (example 48 inches = Maximum 060.0) CheckWell Lite TM Smart Level Transmitter ¾-inch NPT Flange mounting optional Flexible PVC Boot Polypropylene Spacer.687 (17.44) OD f ¾-inch (19.0) ID larger space Inactive Weight Assembly 26 (660) standard 0 (1270) optional in inches (mm) Insertion Length CD Condulet (F Remote Package Only) 09-1-X38-MN

6 09-16-X02 Universal Lite TM Smart Level Transmitter featuring Fuel/Water Interface Organic Acids MEK/Water Interface Do not use with: Hydrofluic Acid Slurries Ferric Chlide 1000 psi ( F (38 C) 00 psi ( F (38 C) Less than four hsepower (greater if suppted) Power In 10¼ I _. TFE, 316 SS and FEP (bonded) ¾-inch NPT (standard) Flange.6 OD Rod (14) FEP Insulation in inches (mm) 19 Feet maximum (.8 m) CD. in inches = (example 48 inches = 048.0) Maximum recommended insertion length = 228 inches F longer lengths, consult facty. BGB = 0 mm 40 bar 316SS Condulet (F Remote Package Only) X02-MN

7 09-16-X06 Universal Lite TM Smart Level Transmitter featuring Oil/Water Interface Inganic Acids Do not use with: Caustic Sulfuric Acid (over 20%) Nitric Acid (over 30%) Acetone MEK and other Ketones I _. in inches = (example 48 inches = 048.0) Maximum recommended insertion length = 240 inches F longer lengths, consult facty psi ( F (38 C) 00 psi (34 20 F (121 C) Less than two hsepower (greater if suppted) 316 SS and Kynar (bonded) insulation Power In 1-inch NPT (standard) Flange.84 OD Rod (21) PVDF Insulation BGB = 0 mm 40 bar 316SS in inches (mm) 10¼ CD. 20 Feet maximum (6.1m) Condulet (F Remote Package Only) X06-MN

8 09-17-X16 Universal Lite TM Smart Level Transmitter featuring Transmitter can be precalibrated and its output is linear regardless of tank geometry. Vegetable Oils Fuel Oils MEK and other Solvents Organic Acids Do not use with: Hydroflouric Acid Styrene Monomer Butydiene Monomer Acetone Material crosive to CS ( 316SS) I _. W = Insertion length in inches DIN mounting in inches = (example 48 inches = 048.0) Maximum recommended insertion length = 240 inches F longer lengths, consult facty psi (34 20 F (121 C) 1000 psi ( F (38 C) Less than four hsepower CS 316 SS - Optional TFE (bonded) to Power In 1½-inch NPT (standard) Flange 3/8 OD Rod (9.7) TFE Insulation 1.66 OD Concentric Shield (42) CD. BGB = 0 mm 40 bar 316SS in inches (mm) 20 Feet maximum (6.1m) Condulet (F Remote Package Only) X16-MN