APPENDIX B - MOUNT SPECIFIC DATA For. Patriot 3.8m Mobile Antenna

Transcription

1 RC Antenna Controller Appendix B Mount Specific Data 1 APPENDIX B - MOUNT SPECIFIC DATA For Patriot.8m Mobile Antenna REVISION HISTORY 29 December 26, Software Version October 29, Software Version October 29, Software Version RC Features All basic features of the RC are utilized to provide the operations for this mount. Hardware Configuration. A RCB version of hardware is utilized for this mount. Software Configuration. The mount model will be designated as PJ. Software will be designated as RCK-PJ-xxx System Interface Requirements The PJ mount follows the standard RC interface requirements for mounts equipped with azimuth and elevation resolvers Inclinometer Orientation The inclinometer should be rigged with the face of the reflector vertical. In order to achieve linear operation for RF look angles from to 9 degrees, the inclinometer should be installed approximately 25 degrees from vertical Elevation Calibration Elevation Reference Position From the face vertical reflector position, the elevation reference voltage should be close to.8 V. The elevation displayed at this voltage will be 25. reflecting the RF offset of the antenna. Elevation Resolver Reference In order to characterize platform tilt, it is critical that the elevation resolver be calibrated with the mount level. With the face of the reflector horizontal, adjust the elevation resolver offset to yield a resolver derived angle of 25. shown on the Analog to Digital Voltage maintenance screen (.2.2.1) Reset Defaults The following pages list the default configuration item values for this model of the RC. NOTE: the list of default values is a convenient place to record installation specific changes to the configuration items. Note: recording of installation specific changes to defaults may prove valuable when trying to restore system configuration.

2 RC Antenna Controller Appendix B Mount Specific Data 2 SYSTEM DEFINITION SN: SERIAL NUMBER<1-9999> (=NOT ENTERED) GPS: 1 <1>GPS PRESENT <>NOT PRESENT COMPASS: MODE: 2 2 <>NONE <1>TRUCK MOUNT <2>ANTENNA MOUNT <1-LOCATE 2-MENU -MANUAL 4-VSAT 5-POS> ANT_SIZE: 8 ANTENNA SIZE < CM> WAVEGUIDE: WAVEGUIDE SWITCH <1>PRESENT <>NONE ELEVATION CALIBRATION REF_V: OFF:.8. SET ZERO VOLTAGE <.5-4.5> ELEVATION OFFSET <-25./+25. DEGREES> UP: 9 SET UP LIMIT <-9 DEGREES> DOWN: SF: 5. SET DOWN LIMIT <-9 DEGREES> SCALE FACTOR < mv/deg> LOOK: 1 ELEV LOOK CONFIGURATION <1>HIGH <>LOW RES: REV: ELEV RESOLVER OFFSET<+/-. DEGREES> ELEV RESOLVER<-NORMAL 1-REVERSED> EL_TIME: ELEV STOW TIMER<-DISABLE,1-99 SECONDS> AZIMUTH CALIBRATION FG:. FLUXGATE OFFSET <-18./+18. DEGREES> CCW: CW: SET CCW LIMIT < TO 6 DEGREES> SET CW LIMIT < TO 6 DEGREES> RES: -18. AZIM RESOLVER OFFSET<+/-. DEGREES> REV: AZIM RESOLVER<-NORMAL 1-REVERSED> POLARIZATION CALIBRATION REF_V: SF: SET REFERENCE VOLTAGE < > SCALE FACTOR < deg/volt> OFF:. POL OFFSET <-9./+9. DEGREES> CW: CCW: POL CW LIMIT< DEGREES> POL CCW LIMIT< DEGREES> TYPE: 2 <1>CIRCULAR <2>SINGLE <>DUAL REF: H:. <>HORIZONTAL <1>VERTICAL DEFAULT HORIZONTAL POS.<-18/+18 DEG.> V: 9. DEFAULT VERTICAL POS.<-18/+18 DEG.> AUTO: 1 LOCATE AUTOMOVE <>DISABLE <1>ENABLE SIG FACTORS RF LOCK: RF LOCK <-NONE 1-1HI 2-1LO -2HI 4-2LO> TIME:.1 RF DELAY TIME <.1-9.9> SECONDS SS1 LOCK: SS1 LOCK TYPE <>NONE <1>HI <2>LO TIME: TH:.1 1 SS1 DELAY TIME <.1-9.9> SECONDS SS1 MINIMUM SIGNAL THRESHOLD <-999> POL: 1 SS1 <>NEGATIVE <1>POSITIVE INPUT SENSE SS2 LOCK: TIME:.1 SS2 LOCK TYPE <>NONE <1>HI <2>LO SS2 DELAY TIME <.1-9.9> SECONDS TH: 1 SS2 MINIMUM SIGNAL THRESHOLD <-999> POL: 1 SS2 <>NEGATIVE <1>POSITIVE INPUT SENSE AUTOPEAK ON: SIG: 1 AUTOPEAK <>DISABLED <1>ENABLED <2>+PEAK SIGNAL SOURCE <1>RF <2)SS1 <>SS2 BAND: 1 BAND <-C 1-Ku 2-CK -L 4-X 5-Ka 6-S> SRCH_AZ: SRCH_EL: SPIRAL SEARCH AZIM LIMIT <1-2 DEGREES> SPIRAL SEARCH ELEV LIMIT <1-15 DEGREES> SRCH_TH: 2 SPIRAL SEARCH THRESHOLD <-999>

3 RC Antenna Controller Appendix B Mount Specific Data SCAN_RG: 8 SCAN RANGE <1-2 DEGREES> SCAN_TH: TILT: 2 SCAN THRESHOLD <-999> POL TILT COMPENSATION <>OFF <1>ON AZIMUTH POT DRIVE FAST/SLOW: 2.5 SET THRESHOLD <.-1. DEGREES> MAX ERROR:.2 SET MAXIMUM ERROR <.1-1. DEGREES> TRIES:.1 SET COAST RANGE < DEGREES> SET MAX NUMBER OF TRIES <-1> AZIMUTH PULSE DRIVE SCALE: 141 AZIM SCALE FACTOR< PULSES/RADIAN> CW: 64 AZIM CW PULSE LIMIT < > CCW: FAST/SLOW: 1 5 AZIM CCW PULSE LIMIT < > SET THRESHOLD < PULSES> MAX ERROR: 1 SET MAXIMUM ERROR < - 1 PULSES> TRIES: SET COAST RANGE < PULSES> SET MAX NUMBER OF TRIES < - 1> AZIMUTH DRIVE MONITORING JAM SLOP: 1 SET JAM SLOP < - 12> RUN SLOP: 2 SET RUNAWAY SLOP <-12> FAST DEADBAND: SLOW DEADBAND: 1 5 SET FAST DEADBAND < MSEC> SET SLOW DEADBAND < MSEC> ELEVATION POT DRIVE FAST/SLOW:. SET THRESHOLD <.-1. DEGREES> MAX ERROR:.2 SET MAXIMUM ERROR <.1-1. DEGREES> TRIES:.4 SET COAST RANGE <.-2. DEGREES> SET MAX NUMBER OF TRIES <-1> ELEVATION PULSE DRIVE SCALE: 141 ELEV SCALE FACTOR< PULSES/RADIAN> UP: 64 ELEV UP PULSE LIMIT <1-6555> DOWN: FAST/SLOW: 1 5 ELEV DOWN PULSE LIMIT <1-6555> SET THRESHOLD <-999 PULSES> MAX ERROR: 1 SET MAXIMUM ERROR <-1 PULSES> TRIES: SET COAST RANGE <-999 PULSES> SET MAX NUMBER OF TRIES <-1> ELEVATION DRIVE MONITORING JAM SLOP: 1 SET JAM SLOP < - 12> RUN SLOP: 2 SET RUNAWAY SLOP <-12> FAST DEADBAND: SLOW DEADBAND: 1 5 SET FAST DEADBAND < MSEC> SET SLOW DEADBAND < MSEC> POLARIZATION DRIVE FAST/SLOW: 2. SET THRESHOLD <.-1. DEGREES> MAX ERROR:.5. SET MAXIMUM ERROR <.1-1. DEGREES> SET COAST RANGE <.-2. DEGREES> TRIES: SET MAX NUMBER OF TRIES <-1> POL DRIVE MONITORING JAM SLOP: 1 SET JAM SLOP <-12> RUN SLOP: FAST DEADBAND: 2 1 SET RUNAWAY SLOP <-12> SET FAST DEADBAND <-9999 MSEC> SLOW DEADBAND: 5 SET SLOW DEADBAND <-9999 MSEC> STOW / DEPLOY AZ_STW:. AZIMUTH STOW <-18./18.>

4 RC Antenna Controller Appendix B Mount Specific Data 4 AZ_DEP:. AZIMUTH DEPLOY <-18./18.> EL_STW: EL_DEP: ELEVATION STOW <-9./12.> ELEVATION_DEPLOY <-9./9.> EL_TIME: ELEV STOW TIMER<-DISABLE,1-99 SECONDS> PL_STW: PL_DEP:.. POL STOW <-18./18.> POL DEPLOY <-18./18.> PL_ENABLE: 2 POL MOVE<-NONE 1-STOW 2-DEPLOY -BOTH> TRACK FACTORS SEARCH: <>MANUAL <1-NARROW,-NOMINAL,1-WIDE> MAX ERROR: HOLDOFF: 12 ENTER MAX ERROR IN TENTHS OF A db<1-> SET PEAKUP HOLDOFF TIME<1-999 SECONDS> SIG: 2 SIGNAL SOURCE <2>SS1 <>SS2 TIME: LOG: 2 SIGNAL SAMPLE TIME <2-99 SECONDS> <>DISABLE <1>ENABLE TRACK DATA LOGGING MODE: 1 <1>STEP/MEMORY <2>STEP ONLY AZDP: 1. AZ/EL DELTA FACTOR <.5-1.5> SHAKE AZ 1: EL 1: MOVE 1 AZIM <-18./18.> MOVE 1 ELEV <-9./9.> PL 1: -1. MOVE 1 POL <-18./18.> 2: 2: MOVE 2 AZIM <-18./18.> MOVE 2 ELEV <-9./9.> 2: 1. MOVE 2 POL <-18./18.> : :. 5. MOVE AZIM <-18./18.> MOVE ELEV <-9./9.> :. MOVE POL <-18./18.> CYCLE: DELAY: 5 1 NUMBER OF SHAKE CYCLES <1-9999> DELAY <-999 SECONDS> REMOTE CONTROL ENABLED: 1 REMOTE CONTROL <>DISABLED <1>ENABLED ADDRESS: 5 BUS ADDRESS <49-111> BAUD_RATE: JOG: 6 2 BAUD< >(*1) REMOTE JOG HOLD <1-4>

5 RC Antenna Controller Appendix B Mount Specific Data 5

6 RC Antenna Controller Appendix B Mount Specific Data 6

7 RC Antenna Controller Appendix B Mount Specific Data 7

8 RC Antenna Controller Appendix B Mount Specific Data 8

9 RC Antenna Controller Appendix B Mount Specific Data 9