Date: ESPOO Page: 1 ( 10) Appendices - Transceiver. SATELLINE-EASy Pro 35W SATEL-TA18 SATEL Oy, Finland

Size: px

Start display at page:

Download "Date: ESPOO Page: 1 ( 10) Appendices - Transceiver. SATELLINE-EASy Pro 35W SATEL-TA18 SATEL Oy, Finland"

Henry Bond
5 years ago
Views:

1 Version R TEST REPORT Date: ESPOO Page: 1 ( 10) Appendices - Number: No. 1 / 1 Date of handing in: Tested by: Timo Hietala, Test Engineer Reviewed by: Timo Leismala, Test Manager SORT OF EQUIPMENT: Transceiver MARKETING NAME: TYPE: MANUFACTURER: SATELLINE-EASy Pro 35W SATEL-TA18 SATEL Oy, Finland SERIAL NUMBER: - CLIENT: ADDRESS: TELEPHONE: SATEL Oy Meriniitynkatu 17, FI Salo, Finland / Marita Latovehmas TEST LABORATORY Nemko Oy FCC REG. NO November 26, 2008 IC FILE NO. 2040F-1 December 15, 2008 REMARKS: Tested to FCC Part 90 and RSS-119 Issue 9. The test results are valid for the tested unit only. Without a written permission of Nemko Oy it is allowed to copy this report as a whole, but not partially. Nemko Oy P.O.Bo 19, FI Espoo, Finland Street address: Perkkaantie 11, FI Espoo Telephone Telefa

2 Contents 1. General Summary of performed tests and test results Transmitter Spurious Emissions (Radiated) Receiver Spurious Emissions (Radiated) List of measuring equipment:... 9 Page 2 ( 10)

3 1. General Type: Alignment range: Switching range: SATEL-TA MHz MHz Equipment 1 Equipment 2 Equipment 3 Measurement Serial no. - Serial no. - Serial no. Frequencies: 1) MHz 4) ) 2) MHz 5) 3) MHz 6) Normal Minimum Maimum Voltages: 13.2 VDC 11.2 VDC 15.2 VDC Temperatures: +23,0 C -30,0 C +60,0 C Humidity: 35 % Effective radiated power: 35 W Antenna: 50 ohm Production model: Pre-production model Number of channels: Modulation: Multilevel State FM (4FSK) Channel separation: 12.5 and 25 khz (12,5 khz: 9600 bps 25 khz: bps) The transmitter was tested in a standalone configuration. 2. Summary of performed tests and test results (This interpretation of the test report s results does not belong to the scope of our accreditation.) Section in CFR 47 Section in RSS- Result 119, Issue & Transmitter power (conducted) NT , & Spurious emissions (conducted) NT , & Spurious emissions (radiated) PASS & Frequency stability NT & % Occupied bandwidth NT & Spectrum emission mask NT Transient frequency behavior NT (a) RSS-Gen Conducted emissions at mains ports N.A (a) RSS-Gen 6 Spurious radiations (radiated) PASS According to the standard the measurement results have been compared directly with the limits without considering measurement uncertainties. Eplanations: PASS FAIL NT NA The EUT passed that particular test. The EUT failed that particular test. Not tested Not applicable Page 3 ( 10)

4 3. Transmitter Spurious Emissions (Radiated) NAME OF TEST: Field Strength of Spurious Emissions PARA.NO.:, RSS119: 5.8 TESTED BY: Timo Hietala DATE: 29/09/2010 Test Results: Requirement: Complies log (P) db, (-13 dbm) Transmitter tuned at 406.1, 428 and 468 MHz Test Data: Channel MHz Channel MHz Channel MHz Frequency Level Frequency Level Frequency Level (MHz) (dbm) (MHz) (dbm) (MHz) (dbm) Equipment used: 566, 564, 571, 525, 417, 544, 145 Measurement Uncertainty: Temperature: ± 5.2 db. 22 C. Relative Humidity: 35 %. Page 4 ( 10)

5 The spectrum was searched from 30 MHz to the 10th harmonic of the carrier (5GHz). The test was performed in a semi-anechoic shielded room. The EUT was placed on a nonconductive 0.8 m high table standing on the turntable. During the test in the frequency range MHz the distance from the EUT to the measuring antenna was 3 m. In order to find the maimum levels of the disturbance radiation the angle of the turntable, the height of the measuring antenna were varied during the tests. The test was performed with the measuring antenna being both in horizontal and vertical polarizations. Spectrum analyzer settings were: 30MHz-1000MHz RBW 100kHz,VBW 1MHz, MHz RBW 1MHz, VBW 3MHz. Vertical and horizontal polarizations in the frequency range MHz was first measured by using the peak detector. During the peak detector scan the turntable was rotated from 0 to 360 with 30 steps with the antenna heights 1.0 m and 2.5 m. The limit of -13 dbm has been calculated to correspond 84.4 db(µv/m). Spurious emissions closer than 20 db to the limit were measured with average detector. The antenna substitution method was used to determine the equivalent radiated power at spurious frequencies. The EUT was replaced with a reference substitution antenna with a known gain referenced to an isotropic radiator G Antenna[dBi]. This antenna was fed with a signal at the spurious frequency P Gen[dBm]. The level of the signal was adjusted to repeat the previously measured level. The resulting EIRP is the signal level fed to the reference antenna corrected for gain referenced to an isotropic. The formula below was used to calculate the EIRP of the EUT. P EIRP[dbm] = P Gen[dBm] - L Cable[dB] + G Antenna[dBi] Page 5 ( 10)

6 4. Receiver Spurious Emissions (Radiated) NAME OF TEST: Radiated disturbance emission test PARA.NO.:, RSS-Gen: 6 TESTED BY: Timo Hietala DATE: 29/09/2010 Test Results: Complies. The test was performed as a compliance test. The test parameters concerned were as follows: Parameter Specification Test method CISPR 22, ANSI C63.4 (2009) Frequency range MHz Site name Nemko Oy / Perkkaa Test equipment 319, 350, 544, 525, 566, 564 Test uncertainty U95 ±4.6 db Test conditions 22 C, 35 % RH The test was performed in a semi-anechoic shielded room. For the duration of the test the EUT was placed on a non-conductive support 0.8 m above the metallic ground plane (see photograph 1). During the test the distance from the EUT to the measuring antenna was 3 meters. In order to find the maimum levels of the disturbance radiation the angle of the turntable, the height of the measuring antenna and the lay-out of the EUT cables were varied during the tests. The test was performed with the measuring antenna being both in horizontal and vertical polarizations. Spectrum was searched from 30MHz to 2GHz. Spectrum analyzer settings were: 30MHz- 1000MHz RBW 100kHz, VBW 1MHz, MHz RBW 1MHz, VBW 1MHz. Page 6 ( 10)

7 Test results radiated disturbance emission test L e v e l [ d Bµ V/ m ] M 50M 70M 100M 200M 300M 500M 700M 1G F r e q u e n c y [ Hz ] M ES _ 0 1 _ f in Q P M ES _ 0 1 _ p r e PK L I M EN F Q P F ie ld St r e n g t h Q P L im it Horizontal and vertical polarisations in the frequency range MHz measured by using the peak detector. During the peak detector scan, the turntable was rotated from 0 to 360 with 30 steps with the antenna heights 1.0 m and 3.0 m. The highest levels of the radiated interference field strength measured by using the quasi-peak detector were recorded. Measurement results (QP): Frequency Level Limit Margin Eceed MHz db V/m db V/m db Page 7 ( 10)

8 Horizontal and vertical polarizations in the frequency range MHz measured by using the peak detector. During the peak detector scan, the turntable was rotated from 0 to 360 with 15 steps with the antenna heights 1.0, 1.5m, 2.0m, 2.5m and 3.0m. The highest levels of the radiated interference field strength measured by using the peak and average detectors were recorded. The FCC 47 CFR Part 15, Subpart B, Class B limit of 500 µv/m has been calculated to correspond 54.0 db(µv/m) as follows: [db(µv/m)]=20log[µv/m]. Page 8 ( 10)

9 5. List of measuring equipment: No. Equipment Type Manufacturer Serial Number 5 Test receiver ESH-3 Rohde & Schwarz / Oscilloscope 9400A LeCroy Spectrum analyzer 8566B Hewlett Packard 2637A Spectrum analyzer 8568B Hewlett Packard 2039A Audio amplifier PRL Self made 89 Antenna 3147 EMCO Hybrid H 9 Anzac 133 Termination BNM Narda 145 Notch Filter TTR EE Telonic Dual directional coupler 778D Hewlett Packard 1144A Temp. test chamber VMT 04/240 Vötch Artificial Mains NSLK 8127 Schwartzbeck Anechoic chamber 888 cm 585 cm 416 cm length of absorber 66 cm 185 Antenna PRL LogPer Self made 1A RF-Generator 2042 Marconi / RF-Amplifier ZHL-1042J Mini-Circuits Power supply HP 6032A Hewlett Packard 2517A Antenna CBL6112 Chase Power attenuator Narda IF-filter 10.7MHz/25kHz Ultracom Oy IF-filter 10.7MHz/12.5kHz Ultracom Oy Mier ZFM-150 Mini-Circuits Modulation analyzer HP 8901B Hewlett Packard 3538A Multimeter Fluke 87 Fluke Semianechoic shielded room RFD-F-100 Euroshield Oy RF attenuator PAD WA2-3 Weinschel RF attenuator PAD WA2-10 Weinschel RF attenuator PAD 1A (6dB) Weinschel 394 RF attenuator PAD 1A (20dB) Weinschel 417 Antenna, bilog CBL 6141 Chase Double-Ridged Horn 3115 Emco RF-amplifier ZFL-1000VH2 Mini-Circuits D Thermometer 52 II Fluke RF amplifier CA CIAO Wireless Spectrum analyzer E4448A Agilent US RF generator E8257C Agilent MY High Pass Filter WHK0.6/13G-10SS Wainwright Instruments Power sensor 8482A Hewlett Packard 1925A Power meter 438A Hewlett Packard 2517U Counter 5351B Hewlett Packard 2844U00220 Page 9 ( 10)

10 Photograph 1, Radiated spurious emissions test. Page 10 ( 10)

REMARKS The customer has ordered two measurements mentioned above according to the standard EN

REMARKS The customer has ordered two measurements mentioned above according to the standard EN Type: Alignment range: Switching range: SATELLINE-3ASm/250/LC 380,000-470,000 MHz One channel Equipment 1 and 2 Equipment Equipment Measurement Serial no. 033322036 and 033322037 Serial no. Serial no.