Nemko Canada Inc., 303 River Road, R.R. 5, Ottawa, Ontario, Canada, K1V 1H2

Transcription

1 Nemko Canada Inc., 303 River Road, R.R. 5, Ottawa, Ontario, Canada, K1V 1H2 Report Number: Product Marketing Name: TRFEMC Paycheck 4 Thermal Ticket Printer Test Specification: FCC 47 CFR Part 15, Subpart B Verification (USA) ICES-003 Issue 4 February 2004 (Canada) EN 55022: 2006 (European Union) Reviewed by: March 11, 2009 Signature Date Daniel Hynes, Senior EMC Specialist Tested by: David Duchesne, Senior EMC Specialist Nemko Canada Inc. authorizes the applicant to reproduce this report provided it is reproduced in its entirety and for use by the company s employees only. Any use which a third party makes of this report, or any reliance on or decisions to be made based on it, are the responsibility of such third parties. Nemko Canada Inc. accepts no responsibility for damages, if any suffered by any third party as a result of decisions made or actions based on this report. This report shall not be reproduced except in full without the written approval of the testing laboratory. Nemko Canada Inc., a testing laboratory, is accredited by the Standards Council of Canada. The tests included in this report are within the scope of this accreditation. EN22-CISPR22-FCC-ICES-AS-EN EN doc - Date: November 18, 2008

2 Table of Contents Declaratory Statements...3 Statement of Compliance...4 Measurement Uncertainty...5 Lab Environmental Conditions...5 Engineering Considerations...6 General Information Regarding the Equipment Under Test (EUT)...7 Equipment Configuration...7 Radiated Disturbance...8 Conducted Disturbance at Mains Port...14 Page 2 of 19

3 Declaratory Statements Product Marketing Name: Paycheck 4 Thermal Ticket Printer Model #: Trademark: Serial #: P Applicant: Nanoptix Inc 699 Champlain Street Dieppe, NB, Canada E1A1P6 Manufacturer: Nanoptix Inc 699 Champlain Street Dieppe, NB, Canada E1A1P6 Product Background details New Product Configuration Change Other Test Specification: FCC 47 CFR Part 15, Subpart B Verification (USA) ICES-003 Issue 4 February 2004 (Canada) EN 55022: 2006 (European Union) Engineering Changes Product Audit Test Location: 303 River Road, R.R. 5, Ottawa, Ontario, Canada, K1V 1H2 Limits of Responsibility: The results included in this test report apply only to the equipment listed within this report as being the Equipment Under Test (EUT). Equipment listed as support equipment is not considered to be part of the EUT. In some instances, the EUT may consist of multiple devices, and will be so indicated in the report. Page 3 of 19

4 Statement of Compliance EN 55022: 2006: Class B Radiated Disturbance Conducted Disturbance at Mains Port Conducted Common mode (asymmetric mode) Disturbance at Telecommunication Ports Test Method Used: CISPR 22 System Power: 230 VAC / 50 Hz All tests were performed using measurement apparatus defined in CISPR TEST RESULT PASS/FAIL/NA PASS PASS N/A TEST RESULT FCC 47 CFR Part 15, Subpart B for Digital Devices: Class B PASS/FAIL/NA Radiated Disturbance PASS Conducted Disturbance at Mains Port PASS Test Method Used: ANSI C System Power: 120 VAC / 60 Hz The equipment was tested for conducted emissions from 0.15 MHz to 30 MHz using a 50 µh line impedance stabilization network (L.I.S.N.) as described in ANSI C Peripheral equipment was also operated through a 50 µh L.I.S.N. ICES-003 Issue 4 February 2004: Class B Radiated Disturbance Conducted Disturbance at Mains Port Test Method Used: CISPR 22 System Power: 120 VAC / 60 Hz All tests were performed using measurement apparatus defined in CISPR TEST RESULT PASS/FAIL/NA PASS PASS Page 4 of 19

5 Measurement Uncertainty Measurement Test Specification Ulab 9 khz 150 khz 4.0 db Conducted disturbance 150 khz 30 MHz 3.6 db 30 MHz 200 MHz Horizontal polarization 4.7 db 200 MHz 1000 MHz Horizontal polarization 4.7 db Radiated disturbance 30 MHz 200 MHz Vertical polarization 4.9 db 200 MHz 1000 MHz Vertical polarization 4.9 db Accuracy of Measurement Measurement uncertainty was calculated using the methods described in CISPR 16-4 Specification for radio disturbance and immunity measuring apparatus and methods Part 4: Uncertainty in EMC measurements and Nemko Canada Inc. procedure EMC/MUC/001 Uncertainty in EMC Measurements. Lab Environmental Conditions Ambient Temperature: 15 C to 35 C, Relative Humidity: 30 % to 60 %, Atmospheric Pressure: 86 kpa (860 mbar) to 106 kpa (1 060 mbar) Page 5 of 19

6 Engineering Considerations Product Modification Required for Compliance None Justification None Deviations from Standard Test Procedure None Test Report Revision History Revision # Details of changes made to test report - Original Report Issued N/A N/A Page 6 of 19

7 General Information Regarding the Equipment Under Test (EUT) Date Received In Laboratory: March 2, 2009 Nemko Identification Number: Item # 7 Description & Theory of Operation: The EUT is a thermal printer for ticket application. EUT Clock and Operational Frequencies: 12MHz, 200MHz Exercise/Monitoring method: Continuous print state. Tickets were visually inspected to ensure no corruption. Firmware Version: 2.91V (Testing Continuous Print) Equipment Configuration Equipment Configuration List Description Identification: (MN#, SN#, PN#, Rev.) Paycheck 4 Thermal Ticket Printer MN# , SN# P Nanoptix ITE Power Supply PN# GS-1110, SN# IBM Think Pad FA IIBM AC Adapter FA Configuration of the Equipment Under Test (EUT) Page 7 of 19

8 Radiated Disturbance Test Date: March 9, 2009 Engineer s Name: David Duchesne Configuration: Table Top Enclosure Investigation Data Result: Refer to spectral plots and tables of this section. Facility: 3m Semi Anechoic Chamber Measuring Distance: = 3 m Antenna Height: 1-4 m Preview measurements: Final measurement: 30 MHz to 1 GHz 30 MHz to 1 GHz Receiver settings: Receiver settings: Peak Detector, Max Hold Q-Peak Detector 120 khz RBW 120 khz RBW 1 GHz to 40 GHz 1 GHz to 40 GHz Spectrum analyzer settings: Receiver settings: Peak Detector, Max Hold Average Detector 1 MHz RBW/3MHz VBW 1 MHz RBW The spectral plot is a combined vertical and horizontal scan. Spectral plots have been corrected with transducer factors for antennas, cable loss, amplifiers, and attenuators. Limits have been adjusted to reflect 3 m measurements. The preview measurement was generated with receiver in continuous scan mode while the EUT was rotated and antenna adjusted for maximized radiated emission. Emissions detected within 6 db of limit were remeasured with a quasi peak or average detector for a final measurement. Notes None Deviations Refer to Engineering Considerations. Test Result Final Test Result: Pass (Class B) Page 8 of 19

9 Radiated Disturbance, continued Test Equipment Used Equipment Manufacturer Model No. Asset/Serial No. Next Cal. 3 m EMI Test Chamber TDK SAC-3 FA May 06/09 Bilog Sunol JB3 FA Jan. 27/10 Flush Mount Turntable Sunol FM2022 FA NCR Controller Sunol SC104V FA NCR Mast Sunol TLT2 FA NCR Horn Antenna #2 EMCO 3115 FA Jan. 21/ GHz Amplifier JCA JCA FA Oct 2/09 50 Coax cable HUBER + SUHNER None FA Aug. 05/09 50 Coax cable HUBER + SUHNER None FA July 07/09 Receiver/Spectrum Analyzer Rohde & Schwarz ESU 26 FA Dec. 16/09 Note: N/A = Not Applicable, NCR = No Cal Required, COU = CAL On Use Page 9 of 19

10 Radiated Disturbance, continued Setup Photos Page 10 of 19

11 Radiated Disturbance, continued Spectral Plots FCC Part 15 Class B Electric Field Strength 3m QP+AV 50 CISPR 22 Electric Field Strength 3 m QP Class B 45 Level in dbµv/m M M G Frequency in Hz Vertical and Horizontal (Paycheck 4 Ticket Printer) CISPR 22 QP Class B 3m Limit FCC Part 15 Class B 3m Limit Preview Peak Detector Final Q-Peak Detector Page 11 of 19

12 Radiated Disturbance, continued Spectral Plots, continued FCC Part 15 Class B Electric Field Strength 3m QP+AV Level in dbµv/m G 2G 3G 4G 5G 6G Frequency in Hz Vertical and Horizontal (Paycheck 4 Ticket Printer) Preview Peak Detector (Max Hold) FCC Part 15 Class B AV 3m limit Page 12 of 19

13 Radiated Disturbance, continued Tabular Data ICES-003 and EN Q-Peak Field Antenna Turn Freq. (MHz) Strength (dbµv/m) Meas. Time (ms) Bandwidth (khz) Height (cm) Pol. Table Position Correction (db) Margin (db) Limit (dbµv/m) V V V V V V V H V V V V V V H H FCC 47 CFR Part 15, Subpart B Q-Peak Field Strength (dbµv/m) Antenna Height (cm) Turn Table Position Limit (dbµv/m) Freq. (MHz) Meas. Time (ms) Bandwidth (khz) Pol. Correction (db) Margin (db) V V V V V V V H V V V V V V H H Note: Correction factor includes antenna, cable loss, amplifier, and attenuators. Page 13 of 19

14 Conducted Disturbance at Mains Port Test Date: March 9, 2009 Engineer s Name: David Duchesne Configuration: Table Top Port Investigation Data Port under test: AC input Result: Refer to spectral plots and tables of this section. Preview measurements: Final measurement: 0.15 MHz to 30 MHz 0.15 MHz to 30 MHz Receiver settings: Receiver settings: Peak Detector, Max Hold and Average Q-Peak Detector and Average 9 khz RBW 9 khz RBW Spectral plots have been corrected for transducer factors; cable loss, LISN, and attenuator. Emissions detected within 6 db of limit were re-measured with a quasi peak or average detector for a final measurement. Notes None Deviations Refer to Engineering Considerations. Test Result Final Test Result: Pass (Class B) Test Equipment Used Equipment Manufacturer Model No. Asset/Serial No. Next Cal. 3 m EMI Test Chamber TDK SAC-3 FA May 06/09 International Power Supply California Inst. 3001i FA Jan. 13/10 50 Coax cable HUBER + SUHNER None FA Aug. 05/09 LISN Rohde & Schwarz ENV216 FA Sept. 02/09 Receiver/Spectrum Analyzer Rohde & Schwarz ESU 26 FA Dec. 16/09 Note: N/A = Not Applicable, NCR = No Cal Required, COU = CAL On Use Page 14 of 19

15 Conducted Disturbance at Mains, continued Setup Photos Page 15 of 19

16 Conducted Disturbance at Mains, continued Spectral Plots Level in dbµv CISPR 22 Voltage on Mains QP Class B CISPR 22 Voltage on Mains AV Class B 0 150k M 2M 3M 4M 5M M 20M 30M Frequency in Hz 120VAC/60Hz, Phase (Paycheck 4 Ticket Printer) CISPR 22 QP Class B Limit CISPR 22 AV Class B Limit Preview Peak Detector Preview Average Detector Page 16 of 19

17 Conducted Disturbance at Mains, continued Spectral Plots, continued Level in dbµv CISPR 22 Voltage on Mains QP Class B CISPR 22 Voltage on Mains AV Class B 0 150k M 2M 3M 4M 5M M 20M 30M Frequency in Hz 120VAC/60Hz, Neutral (Paycheck 4 Ticket Printer) CISPR 22 QP Class B Limit CISPR 22 AV Class B Limit Preview Peak Detector Preview Average Detector Page 17 of 19

18 Conducted Disturbance at Mains, continued Spectral Plots, continued Level in dbµv CISPR 22 Voltage on Mains QP Class B CISPR 22 Voltage on Mains AV Class B 0 150k M 2M 3M 4M 5M M 20M 30M Frequency in Hz 230VAC/50Hz, Phase (Paycheck 4 Ticket Printer) CISPR 22 QP Class B Limit CISPR 22 AV Class B Limit Preview Peak Detector Preview Average Detector Final Q-Peak Detector Final Average Detector Tabular Data Frequency Q-Peak Meas. Time Bandwidth Correction Margin Limit Filter Conductor (MHz) Result (dbµv) (ms) (khz) (db) (db) (dbµv) On L On L Frequency Average Meas. Time Bandwidth Correction Margin Limit Filter Conductor (MHz) Result (dbµv) (ms) (khz) (db) (db) (dbµv) On L On L Note: Correction factor includes cable loss, LISN, and attenuator. Page 18 of 19

19 Conducted Disturbance at Mains, continued Spectral Plots, continued Level in dbµv CISPR 22 Voltage on Mains QP Class B CISPR 22 Voltage on Mains AV Class B 0 150k M 2M 3M 4M 5M M 20M 30M Frequency in Hz 230VAC/50Hz, Neutral (Paycheck 4 Ticket Printer) CISPR 22 QP Class B Limit CISPR 22 AV Class B Limit Preview Peak Detector Preview Average Detector Final Q-Peak Detector Final Average Detector Tabular Data Frequency Q-Peak Meas. Time Bandwidth Correction Margin Limit Filter Conductor (MHz) Result (dbµv) (ms) (khz) (db) (db) (dbµv) On N On N Frequency Average Meas. Time Bandwidth Correction Margin Limit Filter Conductor (MHz) Result (dbµv) (ms) (khz) (db) (db) (dbµv) On N On N On N Note: Correction factor includes cable loss, LISN, and attenuator. Page 19 of 19