Oven Controlled Crystal Oscillators

Similar documents
Oven Controlled Crystal Oscillators

Oven Controlled Crystal Oscillators

Oven Controlled Crystal Oscillators

Ultra Low Phase Noise VCXO

Key Electrical Specifications Parameters Minimum Typical Maximum Units Notes ppm

Excellent Integrated System Limited

Ultra Low Phase Noise XO / VCXO

SMD TCXO/VCTCXO ASTXR-12 OVERVIEW: ESD Sensitive. Revised: Moisture Sensitivity Level (MSL) 1

TEMPERATURE COMPENSATED/ VOLTAGE CONTROLLED CRYSTAL OSCILLATOR

2.0 Absolute Maximum Ratings 1 Parameter Min. Max. Unit.

Frequency Translator / Jitter Attenuator

PECL, LVDS, CMOS Output Low Jitter SMD Crystal Oscillator

Ultra-miniature, Low Power, kHz MEMS Oscillator

32.768kHz IoT Optimized SMD Crystal

Ultra-Low Phase Noise OCXO

RFPT Specifications. SMD Low Acceleration Sensitivity TCXO / TCVCXO. Product description. Applications

Frequency Divider Evaluation Board

Ultra-miniature, Low Power, kHz MEMS Oscillator

Pb RoHS. ASG-D Series; LVDS Output STANDARD SPECIFICATIONS: 7.0 x 5.0 x 1.9mm APPLICATIONS: FEATURES:

Low Power MEMS Jitter Attenuator

Ultra-miniature, Low Power, kHz SMD MEMS Oscillator

Ultra-miniature, Low Power, kHz MEMS Oscillator

OX-200 Oven Controlled Crystal Oscillator

PERFORMANCE PLASTIC PACKAGE ULTRA MINIATURE PURE SILICON TM CLOCK OSCILLATORS ASDMP Series

RFID Chip Antenna ACAJ-110- ACAJ-110-T Moisture Sensitivity Level (MSL) MSL = 1. SPECIFICATION Frequency Range. 868/915MHz VSWR

Ultra-Low Phase Jitter SMD Clock Oscillator

High Performance MEMS Jitter Attenuator

ClearClock Ultra-Low Jitter & Power Optimized 5.0 x 3.2 mm XO. (3): Stability over OTR. D: ±15ppm over -20 C to +70 C F: ±20ppm over -40 C to +85 C

TX-801 Temperature Compensated Crystal Oscillator

Model 149 Stratum 3E, 9x14 mm OCXO

Performance Specifications

TX-500 Temperature Compensated Crystal Oscillator

Parameter Conditions & Remarks Min Typical Max Unit. Warm up Steady 25 C Load Output to Ground pf

Performance Specifications

Performance Specifications

CLEARCLOCK POWER OPTIMIZED 0.12ps 5x7mm XO

Parameter Conditions & Remarks Min Typical Max Unit C 3.3V V Warm up 2.5 Steady 25 C 1.

STRATUM 3E High Stability Oven Stabilized Oscillator OH300 Series OCXO / VCOCXO

OX-171 Oven Controlled Crystal Oscillator

IQXT IQXT is a 2.0 x 1.6mm SMD Voltage Controlled Temperature Compensated Crystal Oscillator (VCTCXO) in a hermetically sealed package.

Performance Specifications. Frequency Stabilities 1 ( MHz) -20 to +70 C -40 to +85 C -40 to +95 C Residual error compare to fit curve

O C X O Oven Controlled Crystal Oscillators

Performance Specifications. Frequency Stabilities 1 ( 10 & 20 MHz)

HCMOS 7 x 5mm 1.8V Oscillator

Oven Controlled Crystal Oscillator OCXO SERIES 8100

ICS LOW EMI CLOCK GENERATOR. Description. Features. Block Diagram DATASHEET

CXOQ CXOQ 1.8V CXOQ 2.5V CXOQ 3.0V CXOQ 3.3V

IQXT IQXT-205-3

DTCXO Temperature Compensated Real-Time-Clock Module with SPI bus

DTCXO Temperature Compensated Real-Time-Clock Module with SPI bus

DS1091L Automotive Temperature Range Spread-Spectrum EconOscillator

IoT OPTIMIZED LOW PROFILE QUARTZ CRYSTAL

IoT OPTIMIZED LOW PROFILE QUARTZ CRYSTAL

Description. Block Diagram. Complementary Output. Output. Crystal. Oscillator. E/D or NC

QTCT220 SERIES 2.0 x 2.5mm MINIATURE SMD TEMPERATURE CONTROLLED CRYSTAL OSCILLATORS 2.8 to 3.3Vdc MHz to 52.

2.0 Absolute Maximum Ratings 1 Parameter Min. Max. Unit. a. Storage temperature C b. Supply voltage (VDD) V

IoT OPTIMIZED LOW PROFILE QUARTZ CRYSTAL

QTCT570 SERIES 5 x 7mm MINIATURE SMD TEMPERATURE CONTROLLED CRYSTAL OSCILLATORS 2.8 to 3.3Vdc MHz to MHz Description

Oven Controlled Crystal Oscillator OCXO SERIES IEEE 1100

OX-046 VHF low g-sensitivity Oven Controlled Crystal Oscillator

QTCT350 SERIES 3.2 x 5mm MINIATURE SMD TEMPERATURE CONTROLLED CRYSTAL OSCILLATORS 2.8 to 5.0Vdc MHz to 52.

HMC6380LC4B. WIDEBAND VCOs - SMT. Electrical Specifications, T A. Typical Applications. Features. General Description. Functional Diagram

2.0 FREQUENCY CHARACTERISTICS Line Parameter Test Condition Value Unit 2.1 Nominal frequency range

Features. o HCSL, LVPECL, or LVDS o HCSL/LVPECL, HCSL/LVDS, LVPECL/LVDS. o Ext. Industrial: -40 to 105 C o o. o 30% lower than competing devices

OX-221 Oven Controlled Crystal Oscillator

EX-421 Evacuated Miniature Crystal Oscillator

OX-304 at 10 MHz Ultra Low Phase Noise Oven Controlled Crystal Oscillator

PSE Technology Corporation

TX-700 Temperature Compensated Crystal Oscillator

MD-173 High Stability Coefficient Oscillator I C interface Oven Controlled Crystal Oscillator

OD100LP-Series Low Phase Noise

MX-600 Microprocessor Controlled Crystal Oscillator High Precision

TX-705 Temperature Compensated Crystal Oscillator

AMJD-SERIES. fout = 27MHz, VDD=1.8V,

OX-204 at 10 MHz Ultra Low Phase Noise Oven Controlled Crystal Oscillator

Analog Devices Welcomes Hittite Microwave Corporation NO CONTENT ON THE ATTACHED DOCUMENT HAS CHANGED

PSE Technology Corporation

VCC1 VCC1. CMOS Crystal Oscillator. Description. Features. Applications. Block Diagram. Output V DD GND E/D. Crystal. Oscillator

Preliminary. 2.0 FREQUENCY CHARACTERISTICS Line Parameter Test Condition Value Unit 2.1 Frequency 8 to 1500 MHz 2.2 Operating Temperature Range

VX-505 Voltage Controlled Crystal Oscillator Extended Temperature

LVPECL 5 x 3.2mm 1.8V Oscillator

MX-041 Oven Controlled Crystal Oscillator

C MHz 52 MHz

PS-701 SAW Oscillator

MEMS Oscillator, Low Power, LVCMOS, MHz to MHz

Solder Dip Option: T = Standard S = Solder Dip (*) Package

PSE Technology Corporation

LVDS 5 x 3.2mm 2.5V Oscillator

MD-403 I2C InterfaceOven Controlled Crystal Oscillator

PARAMETER SYMBOL CONDITIONS VALUE UNIT

DSC400. Configurable Four Output, Low Jitter Crystal-less Clock Generator. General Description. Block Diagram. Applications.

ICS722 LOW COST 27 MHZ 3.3 VOLT VCXO. Description. Features. Block Diagram DATASHEET

TS3004. A 1.55V to 5.25V, 1.9µA, 3.3µs to 233s Silicon Timer DESCRIPTION FEATURES APPLICATIONS TYPICAL APPLICATION CIRCUIT

Crystals Oscillators Filters Precision Timing Magnetics Engineered Solutions

OX-043 Low g-sensitivity Oven Controlled Crystal Oscillator

Solder Dip Option: T = Standard S = Solder Dip (*) G = Solder Dip (*) Package

Model: FXTC-HE73 Series Preliminary

PSE Technology Corporation

VVC4 Voltage Controlled Crystal Oscillator

OX-175 Ultra Low Noise Oven Controlled Crystal Oscillator

Transcription:

Moisture Sensitivity Level (MSL) 1 OVERVIEW: Abracon s AOCJYR series of World s Smallest Profile, Surface Mount- Ovenized Quartz Crystal Oscillators are based on Proprietary MercuryTM ASIC technology, patented by Rakon. This Advanced Technology coupled with Rakon s proprietary manufacturing techniques enable ±10 stability over -20 C to +70 C, with typical short-term aging of better than ±2 per day. Sophisticated Integrated Oven Control architecture ensures fast warm-up time, while minimizes initial power consumption to 350mW typical at 25 C. Further, the integration of critical functionality improves overall product reliability by reducing FIT rates 10x relative to traditional discrete OCXOs. The AOCJYR series is offered in Industry leading 9.7 x 7.5 x 4.3 mm SMT package, while AOCJYR-DIL is available in 21.7 x 13.08 x 8.6 mm leaded hermetic package. FEATURES: APPLICATIONS: Stratum 3 Small Cells Switches and Routers Time & Frequency References SyncE and IEEE 1588 Compact package size: 9.7 x 7.5 x 4.3mm Frequency stability over temperature as low as ±25 over -40 to +85 C Low power consumption High reliability STANDARD SPECIFICATIONS: Parameters Nominal Frequency Supply Voltage (Vdd) Input Power (warm-up) Input Power (steady-state) Operable Temperature Range Minimum Typical 3.135 24.576 3.3 1000 Maximum Units Notes -40 400 85 MHz V mw mw ºC -55 +125 ºC ±0.5 See Note 1 ±1 After 1hr recovery ±25 Ref. to (FMAX+FMIN)/2 Slope in Still Air ±2 / C Holdover Stability ±4 Free-run Accuracy ±4.6 Storage Temperature Range Initial Frequency Tolerance @25 C At time of shipment Reflow Shift Frequency Stability over Operating Temperature Range in Still Air 3.465 Stability vs. Supply Voltage Change ±10 Load Coefficient ±10 Frequency Aging (per day) ±2 @25 C still air Temperature ramp 1 C/minute max. 24hrs, temperature variation ±1 C. See Note 2 All causes, 20 years life, ref. to nominal frequency. ±5% variation in Vdd, ref. to freq. @Vdd=3.3V ±5pF variation in load, ref. to freq. @ 15pF load See Note 2

STANDARD SPECIFICATIONS CONTINUED: Frequency Aging (long-term stability) Warm-up Time Parameters Minimum Typical Maximum Units Notes First Year ±1 20 Years ±3 <3 minute See Note 3 Root Allan Variance <1x10-10 @25 C, τ=1.0s Acceleration Sensitivity <2 /g Gamma vector of all 3 axes from 30Hz to 1500Hz Output Type LVCMOS High-level Output Voltage (V OH ) 90%*Vdd V Low-level Output Voltage (V OL ) 10%*Vdd V Output Load 10 15 20 pf Rise and Fall Time (t r, t f ) 4 ns Duty Cycle 45 55 % Phase Noise @ 24.576MHz Carrier @ 1 Hz offset -55 dbc / Hz @ 10 Hz offset -83 dbc / Hz @ 100 Hz offset -109 dbc / Hz @ 1,000 Hz offset -130 dbc / Hz @ 10,000 Hz offset -146 dbc / Hz @ 100,000 Hz offset -149 dbc / Hz @ 1,000,000 Hz offset -150 dbc / Hz Note: 1. The characteristics of the component may be temporarily affected by the processes of assembly and soldering. The frequency specifications apply 48 hours after assembly. Nominal conditions apply unless otherwise stated. 2. After 30 days of continuous operation. 3. Time needed for frequency to be within ±20 reference to frequency after 1hour, at 25 C. Parameter is assembly and operating history dependent CROSS REFERENCE INFORMATION: AOCJYR-24.576MHZ-M5834LF is equivalent to Rakon P/N M5834LF. CERTIFIED tel 949-546-8000 fax 949-546-8001 www.abracon.com

PART IDENTIFICATION: AOCJYR- 24.576MHz -M5834LF Packing Blank: Bulk T: Tape & Reel (1k/reel) OUTLINE DIMENSION: Recommended Land Pattern Pin 1 2 3 4 Function NC Ground RF-output Supply Voltage Note: For correct operation, decouple the supply voltage with a 10µF capacitor close to the oscillator. Dimension: mm

REFLOW PROFILE: TAPE & REEL: Packaging: 1000pcs/reel Reel Size: Ø13 Dimension: mm ATTENTION: Abracon Corporation s products are COTS Commercial-Off-The-Shelf products; suitable for Commercial, Industrial and, where designated, Automotive Applications. Abracon s products are not specifically designed for Military, Aviation, Aerospace, Life-dependant Medical applications or any application requiring high reliability where component failure could result in loss of life and/or property. For applications requiring high reliability and/or presenting an extreme operating environment, written consent and authorization from Abracon Corporation is required. Please contact Abracon Corporation for more information.

Mouser Electronics Authorized Distributor Click to View Pricing, Inventory, Delivery & Lifecycle Information: ABRACON: -T