6MBP15RA6 IGBTIPM R series 6 / 15A 6 in onepackage Features Temperature protection provided by directly detecting the junction temperature of the IGBTs Low power loss and soft switching High performance and high reliability IGBT with overheating protection Higher reliability because of a big decrease in number of parts in builtin control circuit Maximum ratings and characteristics Absolute maximum ratings(at Tc=25 unless otherwise specified) Item DC bus voltage DC bus voltage (surge) DC bus voltage (short operating) CollectorEmitter voltage IN Collector current DC 1ms Duty=58.8% Collector power dissipation One transistor Junction temperature Input voltage of power supply for PreDriver Input signal voltage Input signal current Alarm signal voltage Alarm signal current Storage temperature Operating case temperature Isolating voltage (CaseTerminal) Screw torque Mounting (M5) Terminal (M5) Symbol Rating Unit Min. Max. DC 45 DC(surge) 5 SC 2 4 CES 6 IC 15 A ICP 3 A IC 15 A PC 595 W Tj 15 CC *1 2 in *2 z Iin 1 ma ALM *3 cc IALM *4 15 ma Tstg 4 125 Top 2 1 iso *5 AC2.5 k 3.5 *6 N m 3.5 *6 N m Fig.1 Measurement of case temperature *1 Apply cc between terminal No. 3 and 1, 6 and 4, 9 and 7, 11 and 1. *2 Apply in between terminal No. 2 and 1, 5 and 4, 8 and 7, 13,14,15 and 1. *3 Apply ALM between terminal No. 16 and 1. *4 Apply IALM to terminal No. 16. *5 5Hz/6Hz sine wave 1 minute. *6 Recommendable alue : 2.5 to 3. N m Electrical characteristics of power circuit (at Tc=Tj=25, cc=15) Item Symbol Condition Min. Typ. Max. Unit IN Collector current at off signal input ICES CE=6 input terminal open 1. ma CollectorEmitter saturation voltage CE(sat) Ic=15A 2.8 Forward voltage of FWD F Ic=15A 3.
6MBP15RA6 IGBTIPM Electrical characteristics of control circuit(at Tc=Tj=25, cc=15) Item Symbol Condition Min. Typ. Max. Unit Power supply current of Pline side Predriver(one unit) Power supply current of Nline side three Predriver Input signal threshold voltage (on/off) Input zener voltage Over heating protection temperature level Hysteresis IGBT chips over heating protection temperature level Hysteresis Iccp ICCN in(th) Z TCOH TCH TjOH TjH fsw= to 15kHz Tc=2 to 1 *7 fsw= to 15kHz Tc=2 to 1 *7 ON OFF Rin=2k ohm DC=, Ic=A, Case temperature, Fig.1 surface of IGBT chips 3 1 1. 1.25 11 15 1.35 1.6 8. 2 2 18 65 1.7 1.95 125 ma ma Collector current protection level IN IOC Tj=125 225 A Over current protection delay time Under voltage protection level Hysteresis Alarm signal hold time SC protection delay time Limiting resistor for alarm tdoc U H talm tsc RALM Tj=25 Fig.2 Tj=25 Fig.3 11..2 1.5 1425 1 2 15 12.5 12 1575 µs ms µs ohm *7 Switching frequency of IPM Dynamic characteristics(at Tc=Tj=125, cc=15) Item Symbol Condition Min. Typ. Max. Unit Switching time (IGBT) ton IC=15A, DC=3.3 µs toff 3.6 µs Switching time (FWD) trr IF=15A, DC=3.4 µs Definition of tsc Thermal characteristics( Tc=25) Item Symbol Typ. Max. Unit Junction to Case thermal resistance IN IGBT Rth(jc).21 /W FWD Rth(jc).47 /W Case to fin thermal resistance with compound Rth(cf).5 /W Recommendable value Item Symbol Min. Typ. Max. Unit DC bus voltage DC 2 4 Operating power supply voltage range of Predriver CC 13.5 15 16.5 Switching frequency of IPM fsw 1 2 khz Screw torque Mounting (M5) 2.5 3. N m Terminal (M5) 2.5 3. N m
6MBP15RA6 IGBTIPM Block diagram Predrivers include following functions a) Amplifier for driver b) Short circuit protection c) Undervoltage lockout circuit d) Over current protection e) IGBT chip over heating protection Outline drawings, mm Mass : 44g
6MBP15RA6 IGBTIPM Characteristics (Representative) Control circuit 4 Power supply current vs. Switching frequency Input signal threshold voltage Nside Tj=25 vs. Power supply voltage Tj=1 Pside Tj=125 2.5 Power supply current Icc (ma) 35 3 25 2 15 1 5 Input signal threshold voltage in (ON), in (OFF), () 2. 1.5 1..5 5 1 15 2 25 Switching frequency fsw (khz) 12 13 14 15 16 17 18 Power supply voltage cc () 14 Undervoltage vs. Junction temperature 1. Undervoltage hysterisis vs. Junction temperature Undervoltage UT () 12 1 8 6 4 2 Undervoltage hysterisis H ().8.6.4.2 2 4 6 8 1 12 14 2 4 6 8 1 12 14 Junction temperature Tj () Junction temperature Tj () 3. Alarm hold time vs. Power supply voltage 2 Overheating characteristics TCOH,TjOH,TCH,TjH vs. CC Alarm hold time talm (msec.) 2.5 2. 1.5 1..5 Overheating protection TCOH,TjOH () OH hysterisis TCH,TjH () 15 1 5 12 13 14 15 16 17 18 Power supply voltage cc () 12 13 14 15 16 17 18 Power supply voltage cc ()
6MBP15RA6 IGBTIPM Inverter 3 Collector current vs. CollectorEmitter voltage Tj=25 3 Collector current vs. CollectorEmitter voltage Tj=125 25 25 2 15 1 5 2 15 1 5 1 2 3 4 1 2 3 4 CollectorEmitter voltage CE () CollectorEmitter voltage CE () Switching time vs. Collector current Edc=3, cc=15, Tj=25 Switching time vs. Collector current Edc=3, cc=15, Tj=125 Switching time ton, toff (nsec.) 1 Switching time ton, toff (nsec.) 1 1 1 5 1 15 2 25 5 1 15 2 25 Collector current IC (A) Collector current IC (A) 3 Forward current vs. Forward voltage Reverse recovery characteristics trr, Irr, vs. IF Forward current IF (A) 25 2 15 1 5 Reverse recovery current Irr (A) Reverse recovery time trr (nsec.) 1 1 1 2 3 4 Foeward voltage F () 5 1 15 2 25 Foeward current IF (A)
6MBP15RA6 IGBTIPM Inverter Transient thermal resistance 15 Reverse biased safe operating area cc=15, Tj < = 125 Thermal resistance Rth(jc) (/W) 1.1.1.1.1.1 1 Pulse width Pw (sec.) 135 12 15 9 75 6 45 3 15 1 2 3 4 5 6 7 CollectorEmitter voltage CE () 7 Power derating for IGBT (per device) 3 Power derating for FWD (per device) Collector power dissipation Pc (W) 6 5 4 3 2 1 Collector power dissipation Pc (W) 25 2 15 1 5 2 4 6 8 1 12 14 16 Case temperature Tc () 2 4 6 8 1 12 14 16 Case temperature Tc () 3 Switching loss vs. Collector current Edc=3, cc=15, Tj=25 3 Switching loss vs. Collector current Edc=3, cc=15, Tj=125 Switching loss Eon,Eoff,Err (mj/cycle) 25 2 15 1 5 Switching loss Eon,Eoff,Err (mj/cycle) 25 2 15 1 5 5 1 15 2 25 5 1 15 2 25
6MBP15RA6 IGBTIPM Overcurrent protection vs. Junction temperature cc=15 42 Overcurrent protection level Ioc (A) 36 3 24 18 12 6 2 4 6 8 1 12 14 Junction temperature Tj ()