UNISONIC TECHNOLOGIES CO., LTD SENSITIVE GATE SILICON CONTROLLED RECTIFIERS REVERSE BLOCKING THYRISTORS SOT-89 3 2 SOT-23 DEIPTION PNPN devices designed for high volume, line-powered consumer applications such as relay and lamp drivers, small motor controls, gate drivers for larger thyristors, and sensing and detection circuits. FEATURES * Sensitive gate allows triggering by micro controllers and other logic circuits * Blocking voltage to 600V * On-state current rating of 0.8A RMS at 80 C * High surge current capability 0A * Minimum and maximum values of I GT, V GT and I H specified for ease of design * Immunity to dv/dt 20V/μsec minimum at 0 C * Glass-passivated surface for reliability and uniformity ORDERING INFORMATION TO-92 Lead-free: MCR00L Halogen-free:MCR00GG Ordering Number Pin assignment Package Normal Lead Free Plating Halogen Free 2 3 Packing MCR00-4-x-AB3-R MCR00L-4-x-AB3-R MCR00G-4-x-AB3-R SOT-89 G A K Tape Reel MCR00-4-x-AE3-R MCR00L-4-x-AE3-R MCR00G-4-x-AE3-R SOT-23 G K A Tape Reel MCR00-4-x-T92-B MCR00L-4-x-T92-B MCR00G-4-x-T92-B TO-92 K G A Tape Box MCR00-4-x-T92-K MCR00L-4-x-T92-K MCR00G-4-x-T92-K TO-92 K G A Bulk MCR00-6-x-AB3-R MCR00L-6-x-AB3-R MCR00G-6-x-AB3-R SOT-89 G A K Tape Reel MCR00-6-x-AE3-R MCR00L-6-x-AE3-R MCR00G-6-x-AE3-R SOT-23 G K A Tape Reel MCR00-6-x-T92-B MCR00L-6-x-T92-B MCR00G-6-x-T92-B TO-92 K G A Tape Box MCR00-6-x-T92-K MCR00L-6-x-T92-K MCR00G-6-x-T92-K TO-92 K G A Bulk MCR00-8-x-AB3-R MCR00L-8-x-AB3-R MCR00G-8-x-AB3-R SOT-89 G A K Tape Reel MCR00-8-x-AE3-R MCR00L-8-x-AE3-R MCR00G-8-x-AE3-R SOT-23 G K A Tape Reel MCR00-8-x-T92-B MCR00L-8-x-T92-B MCR00G-8-x-T92-B TO-92 K G A Tape Box MCR00-8-x-T92-K MCR00L-8-x-T92-K MCR00G-8-x-T92-K TO-92 K G A Bulk Note: Pin assignment: G: Gate K: Cathode A: Anode MCR00L-4-x-AB3-R () Packing Type (2) Package Type (3) Rank (4) Lead Plating () B: Tape Box, K: Bulk, R: Tape Reel (2) AB3: SOT-89, AE3: SOT-23, T92: TO-92 (3) x: Refer to CLASSIFICATION OF I GT (4) G: Halogen Free, L: Lead Free, Blank: Pb/Sn www.unisonic.com.tw of 6 Copyright 2009 Unisonic Technologies Co., Ltd
MARKING FOR SOT-23 MCR00L-4 MCR00L-6 MCR00L-8 R4 L: Lead Free L: Halogen Free R6 L: Lead Free L: Halogen Free R8 L: Lead Free L: Halogen Free UNISONIC TECHNOLOGIES CO., LTD 2 of 6 www.unisonic.com.tw
UNISONIC TECHNOLOGIES CO., LTD ABSOLUTE MAXIMUM RATINGS PARAMETER SYMBOL RATINGS UNIT Peak Repetitive Off-State Voltage(Note ) MCR00-4 200 V (T J =-40 ~ 0 С, Sine Wave, 50 ~ 60Hz; MCR00-6 V DRM,V RRM 400 V Gate Open) MCR00-8 600 V On-Sate RMS Current (Tc=80 С) 80 С Condition Angles I T(RMS) 0.8 A Peak Non-Repetitive Surge Current (/2 cycle, Sine Wave, 60Hz, T J =25 С) I TSM 0 A Circuit Fusing Considerations (t=8.3 ms) I 2 t 0.45 A 2 s Forward Peak Gate Power (T A =25 С, Pulse Width.0µs) P GM 0. W Forward Average Gate Power (T A =25 С, t=8.3ms) P G(AV) 0. W Peak Gate Current Forward (T A =25 С, Pulse Width.0μs) I GM A Peak Gate Voltage Reverse (T A =25 С, Pulse Width.0μs) V GRM 5 V Operating Junction Temperature Range (Rated V RRM and V DRM ) T J -40 ~ +0 С Storage Temperature Range T STG -40 ~ +50 С Note: Absolute maximum ratings are those values beyond which the device could be permanently damaged. Absolute maximum ratings are stress ratings only and functional device operation is not implied. THERMAL DATA Junction to Ambient PARAMETER SYMBOL MAX UNIT TO-92 200 С/W θ JA SOT-23/SOT-89 400 С/W ELECTRICAL CHARACTERISTICS (T J =25 С, unless otherwise stated) PARAMETER SYMBOL TEST CONDITIONS MIN TYP MAX UNIT OFF CHARACTERISTICS Peak Forward or Reverse Blocking T C =25 С 0 μa Current T C =25 С I V D =Rated V DRM and V RRM ; DRM, I RRM R GK =kω 00 μa ON CHARACTERISTICS Peak Forward On-State Voltage (Note 2) V TM I TM =A Peak @ T A =25 С.7 V Gate Trigger Current (Continuous DC)(Note3) I GT V AK =7Vdc, R L =00Ω, T C =25 С 40 200 μa Holding Current (Note 4) T C =25 С V AK =7Vdc, initiating 0.5 5 ma I H T C =-40 С current=20ma 0 ma Latch Current T C =25 С 0.6 0 ma I L V AK =7V, Ig=200μA T C =-40 С 5 ma Gate Trigger Voltage (continuous T C =25 С 0.62 0.8 V V GT V AK =7Vdc, R L =00Ω dc) (Note 3) T C =-40 С.2 V DYNAMIC CHARACTERISTICS V D =Rated V DRM, Exponential Critical Rate of Rise of Off-State Voltage d V /dt Waveform, R GK =000Ω, T J =0 С 20 35 V/μs Critical Rate of Rise of On-State Current di/dt I PK =20A; Pw=0μsec; dig/dt=a/μsec, Igt=20mA 50 A/μs Notes:. V DRM and V RRM for all types can be applied on a continuous basis. Ratings apply for zero or negative gate voltage; however, positive gate voltage shall not be applied concurrent with negative potential on the anode. Blocking voltages shall not be tested with a constant current source such that the voltage ratings of the devices are exceeded. 2. Indicates Pulse Test Width.0ms, duty cycle % 3. R GK =000Ω included in measurement. 4. Does not include R GK in measurement www.unisonic.com.tw 3 of 6 Copyright 2009 Unisonic Technologies Co., Ltd
UNISONIC TECHNOLOGIES CO., LTD VOLTAGE CURRENT CHARACTERISTIC OF PARAMETER Peak Repetitive Off Stat Forward Voltage Peak Forward Blocking Current Peak Repetitive Off State Reverse Voltage Peak Reverse Blocking Current Peak On State Voltage Holding Current SYMBOL V DRM I DRM V RRM I RRM V TM I H +Current Anode+ V TM On State I RRM at V RRM I H +Voltage Reverse Blocking Region (off state) Reverse Avalanche Region Anode- Forward Blocking Region (off state) I DRM at V DRM CLASSIFICATION OF I GT RANK B C AA AB AC AD RANGE 48~05μA 95~200μA 8~6μA 4~2μA 9~25μA 23~52μA www.unisonic.com.tw 4 of 6 Copyright 2009 Unisonic Technologies Co., Ltd
TYPICAL CHARACTERISTICS Gate Trigger Current (µa) 00 90 80 70 60 50 40 30 20 Typical Gate Trigger Current vs. Junction Temperature 0 0.2-40-25-0 5 20 35 50 65 80 95 0-40-25-0 5 20 35 50 65 80 95 0 Junction Temperature, T J ( ) Junction Temperature, T J ( ) Gate Trigger Voltage (V).0 0.9 0.8 0.7 0.6 0.5 0.4 0.3 Typical Gate Trigger Voltage vs. Junction Temperature Typical RMS Curent Derating 20 0 00 90 80 80 70 60 20 50 30 60 90 40 0 0. 0.2 0.3 0.4 0.5 RMS On-State Current, I T(RMS) (A) 0 Typical On-State Characteristics MAXIMUM@T J=25 MAXIMUM@T J =0 0. 0.5 0.8..4.7 2.0 2.3 2.6 2.9 3.2 3.5 Instantaneous On-State Voltage, V T (V) UNISONIC TECHNOLOGIES CO., LTD 5 of 6 www.unisonic.com.tw
UTC assumes no responsibility for equipment failures that result from using products at values that exceed, even momentarily, rated values (such as maximum ratings, operating condition ranges, or other parameters) listed in products specifications of any and all UTC products described or contained herein. UTC products are not designed for use in life support appliances, devices or systems where malfunction of these products can be reasonably expected to result in personal injury. Reproduction in whole or in part is prohibited without the prior written consent of the copyright owner. The information presented in this document does not form part of any quotation or contract, is believed to be accurate and reliable and may be changed without notice. UNISONIC TECHNOLOGIES CO., LTD 6 of 6 www.unisonic.com.tw