Installation Instructions for Bosca Models BOS-XX-C-XX, & BOS-XX-S-XX Page of 5 BOSCA clip-in mount or BOSCA magnetic BOSCA -in mount Instruction page index: Clip-in installation Screw-in installation Magnetic installation Power feed layout guide 5
Models BOS-XX-C-XX Clip-in installation mounting channel lead wires. Page of 5 mounting channel Note: Prior to installation all VDC wires must be present near. Refer to the installation instruction Carefully remove the mounting channel from the back of the. Mounting channel is /" shorter per wire lead /or for easy wire management. Fe end. Follow or dimensions below and drill hole through surface. Insert wire lead/or through surface & snap into the mounting channel to secure in place.. Determine the location of the. Then secure the mounting channel to the surface with the provided mounting s. When installing the mounting channel take into consideration the /" shorter per wire lead/or.. Install mounting s every 6 inches to the center of the mounting channel.. Follow one of the two options to the to the. Option - Secure fe to. Feed wire through conduit to. to Male quick end Lead wire end 0.5" 0.8" mounting channel.. Option - Feed wire whip to the. fe 0.0" Female/male adapter 0.5"... Connect + VDC red wire from the to the + VDC red wire with a wire nut. Connect -VDC black wire from the to -VDC black wire with a wire nut. - VDC BLACK - VDC BLACK 0 VAC VDC to
Models BOS-XX-S-XX Screw-in installation set mounting bracket Page of 5 mounting bracket completely installed Line up mounting bracket to the back on the. Slightly insert the edge of the clip into the extrusion. Then rotate and push clip in until you feel a click. Follow by tightening each mounting bracket set using the Allen wrench (provided). Make sure the mounting clips are evenly distributed throughout the complete... Note: Prior to installation all VDC wires must be present near. Refer to the installation instruction. Determine the location of the. Then secure the to the surface using the provided mounting s.. Follow one of the two options to the to the. Option - Secure fe to. Feed wire through conduit to. Option - Feed wire whip to the. to fe. 0 VAC. Connect + VDC red wire from the to the + VDC red wire with a wire nut. Connect -VDC black wire from the to -VDC black wire with a wire nut. VDC to - VDC BLACK - VDC BLACK
Models BOS-XX-M-XX Magnetic installation Page of 5 metal backing metal backing Note: Prior to installation all VDC wires must be present near. Refer to the installation instruction Determine the location of the. Snap the onto the metal surface. If necessary can easily be removed by rotating off the surface and repositioning correctly.. Follow one of the two options to the to the. Option - Secure fe to. Feed wire through conduit to. Option - Feed wire whip to the. to fe. 0 VAC. Connect + VDC red wire from the to the + VDC red wire with a wire nut. Connect -VDC black wire from the to -VDC black wire with a wire nut. VDC to - VDC BLACK - VDC BLACK
Models BOS-XX-M-XX multiple feed layouts Page 5 of 5 supplies at the end of the run supplies in the middle of the run consecutive layout, NOT RECOMMENDED