VDE PACT PC BOARD POWER RELAY JW RELAYS.... Compliance with RoHS Directive FEATURES Miniature package with universal terminal footprint High dielectric withstanding for transient protection:, V surge in µs between coil and contact Sealed construction Class B coil insulation types available TV rated (TV-) types available (only for Form A type) VDE, TÜV, SEMKO, SEV, FIMKO, TV- also approved About Cd-free contacts We have introduced Cadmium free type products to reduce Environmental Hazardous Substances. (The suffix F should be added to the part number) (Note : The Suffix F is required only for Form A contact type. The Form C and Form A and Form C contact type is originally Cadmium free, the suffix F is not required.) Please replace parts containing Cadmium with Cadmium-free products and evaluate them with your actual application before use because the life of a relay depends on the contact material and load. SPECIFICATIONS Contact Arrangement Initial contact resistance, max. (By drop V DC A) Contact material Rating (resistive load) Expected life (min. ope.) Nominal switching capacity Coil Nominal operating power Standard type Form A, Form C, Form A, Form C A V AC, A 3 V DC mω a: AgSnO type c, a, c: AgNi type High capacity type Form A, Form C A V AC, A 3 V DC switching power, VA, W, VA, 3 W switching V AC, 3 V DC switching current A A switching capacity # (Reference value) ma, V DC Mechanical (at cpm) Electrical (at cpm) (Resistive load) 3 mw # This value can change due to the switching frequency, environmental conditions, and desired reliability level, therefore it is recommended to check this with the actual load. Remarks * Specifications will vary with foreign standards certification ratings. * Detection current: ma * Wave is standard shock of ±. µs according to JEC--9 * 3 Excluding contact bounce time * Half-wave pulse of sine wave: ms; detection time: µs * Half-wave pulse of sine wave: ms * Detection time: µs * Refer to. Conditions for operation, transport and storage mentioned in AMBIENT ENVIRONMENT. * The pick-up and drop out s rise approximately.% for every C 33. F given a standard ambient temperature of C F. Therefore, when using relays where the ambient temperature is high, please take into consideration the rise in pick-up and drop out s and keep the coil applied within the maximum allowable. Characteristics operating speed (at rated load) Initial insulation resistance Initial breakdown * Between open contacts Between contacts and coil Between contact sets Initial surge between contacts and coil* * 3 (at nominal ) (without diode)* 3 (at nominal ) Temperature rise (at C) (at nominal ) (with nominal coil and at nominal switching capacity) Shock resistance Vibration resistance Conditions for operation, transport and storage* (Not freezing and condensing at low temperature) Unit weight Standard type cpm High capacity type, MΩ at V DC, Vrms for min., Vrms for min. 3, Vrms for min. ( Form A, Form C) a: max. C c, a, c: max. C (resistance method), V ms ms a: max. C c: max. C (resistance method) Functional* 9 m/s { G} Destructive* 9 m/s { G} Functional* to Hz at double amplitude of. mm Destructive to Hz at double amplitude of. mm Ambient temp.* Humidity C to + C F to F (Class E), (Class B: C to + C F to F) to % R.H. Approx. 3 g. oz
TYPICAL APPLICATIONS. Home appliances TV sets, VCR, Microwave ovens. Office machines Photocopiers, Vending machines ORDERING INFORMATION 3. Industrial equipment NC machines, Robots, Temperature controllers JW Ex. JW F S N B DCV Contact arrangement Contact capacity : Form C Nil: Standard a: Form A ( A) : Form C F: High capacity a: Form A ( A)* *Only for Form A and Form C type Protective construction Pick-up Coil insulation class S: Sealed type N: % of Nil: Class E insulation nominal B: Class B insulation UL/CSA, VDE, SEMKO, FIMKO, SEV approved type is standard. Notes:. When ordering TV rated (TV-) types, add suffix-tv (available only for Form A type).. Standard packing: Carton: pcs. Case: pcs. 3. Please inquire about the previous products (Cadmium containing parts). Coil DC,, 9,,,, V Contact material F: AgSnO type (a) Nil: AgNi type (c, a, c) TYPES Standard (A) types Contact arrangement Coil, V DC Part No. Contact arrangement Coil, V DC Part No. Form A Form C High capacity ( A) types Contact arrangement Coil, V DC Part No. Contact arrangement Coil, V DC Part No. JWaFSN-DCV-F JWFSN-DCV JWaFSN-DCV-F JWFSN-DCV 9 JWaFSN-DC9V-F 9 JWFSN-DC9V Form A JWaFSN-DCV-F Form C JWFSN-DCV JWaFSN-DCV-F JWFSN-DCV JWaFSN-DCV-F JWFSN-DCV JWaFSN-DCV-F JWFSN-DCV DATA (at C F) Nominal, V DC Pick-up, V DC (max.) (Initial) JWaSN-DCV-F JWaSN-DCV JWaSN-DCV-F JWaSN-DCV 9 JWaSN-DC9V-F 9 JWaSN-DC9V JWaSN-DCV-F Form A JWaSN-DCV JWaSN-DCV-F JWaSN-DCV JWaSN-DCV-F JWaSN-DCV JWaSN-DCV-F JWaSN-DCV JWSN-DCV JWSN-DCV JWSN-DCV JWSN-DCV 9 JWSN-DC9V 9 JWSN-DC9V JWSN-DCV Form C JWSN-DCV JWSN-DCV JWSN-DCV JWSN-DCV JWSN-DCV JWSN-DCV JWSN-DCV Drop-out, V DC (min.) (Initial) Nominal operating current, ma (±%) Coil resistance, W (±%) 3.... 9.3.9.... 9.., 3., Nominal operating power, mw 3 allowable 3% V of Nominal Voltage (at C F) % V of Nominal Voltage (at C F)*
DIMENSIONS Form A Form C....9 3..3....9 3. 3..3.3.. -.3 dia. -. dia..3...3..3.....9 3..3..... -.3 dia. -. dia. Tolerance: ±. ±..3...9 3..3 3..3....3.....3... Tolerance: ±. ±. N.C. Stand-off.9.3 Dimension : General tolerance mm.39 inch ±. ±. to 3mm.39 to. inch ±. ±. 3mm. inch ±.3 ±.....3 Form A Form C...3..9 -.3 dia. -. dia....3..9.9.9 -.3 dia. -. dia..3..3..9..3...3.....9 Tolerance: ±. ±..3...3....3.3..9.9..9.....9 Tolerance: ±. ±. N.C......3 Dimension : General tolerance mm.39 inch ±. ±. to 3mm.39 to. inch ±. ±. 3mm. inch ±.3 ±...9....3 REFERENCE DATA -(). Maximum operating power Form A Standard ( A) type -(). Maximum operating power Form A High Capacity ( A) type -(3). Maximum operating power Form C Standard ( A) type DC resistive AC resistive load load DC resistive load AC resistive load AC resistive load (cosϕ =.),,,
-(). Maximum operating power Form C High Capacity ( A) type -(). Maximum operating power Form A Standard ( A) type -(). Maximum operating power Form C Standard ( A) type AC resistive load (cosϕ =.) AC resistive load (cosϕ =.) AC resistive load (cosϕ =.),,, -(). Life curve Form A Standard ( A) type -(). Life curve Form A High Capacity ( A) type 3-(). Operate/release time Sample: JWaSN-DCV-F, pcs. Ambient temperature: C F Life, V AC resistive load (cosϕ =.) 3 V DC resistive load Life, V AC resistive load (cosϕ =.) 3 V DC resistive load 9 3-(). Operate/release time Sample: JWaFSN-DCV, pcs. Ambient temperature: C F 3-(3). Operate/release time Sample: JWSN-DCV-F, pcs. Ambient temperature: C F 3-(). Operate/release time Sample: JWaSN-DCV-F, pcs. Ambient temperature: C F 9 3 9 3 9 3 3 9 3-(). Operate/release time Sample: JWSN-DCV-F, pcs. Ambient temperature: C F -(). Coil temperature rise (Contact carrying current: A) Sample JWaFSN-DCV-F, pcs. Point measured: Inside the coil -(). Coil temperature rise (Contact carrying current: A) Sample: JWaFSN-DCV-F, pcs. Point measured: Inside the coil 9 3 Temperature rise, C 3 C C C Temperature rise, C 3 C C C 9 3
ACCESSORIES FEATURES. Space saving design. Wiring can be done with ease (DIN terminal) For poles For poles N.C. contact raw contact raw N.C. contact raw contact raw TYPES Product name SPECIFICATIONS DIN terminal Number of poles Socket Part No. JW PC board socket JW-PS contact raw Coil terminal raw Applicable relay type contact raw Coil terminal raw Standard packing Form A Form C Form A Form C Inner carton Outer case JW PC board socket JW-PS Item Type PC board socket/plug-in socket DIN terminal socket pcs. pcs. pole poles pole poles Breakdown, vrms for minute, Vrms for minute, Vrms for minute Insulation resistance MΩ MΩ DIMENSIONS. DIN terminal socket ±.3.9±. ±.3.9±..3±.3.9±. 3.±..9±. ±.3±.39. dia.. dia... ±.3.9±. 3. dia..3 dia. 3±.3.±..±..±. ±..±..±..±. 3.±..39±. 3..3. PC board socket 3±..±..±..±..±.3.±. ±..±. Pre-soldering 3±..±..3±..±..3±..±..±..3±. (Bottom view) Form A Form C (.) (.3) () (.) -.3 dia. -. dia.. 3.. 3..3.3 Form A Form C -.3 dia. -. dia..9.9.9..9 Tolerance: ±. ±. 3. Plug-in socket 3±..±. Panel cut-out (Thickness:. to..39 to.9) 3±..±. 3.±..33±. ±.3.39±..9.9 3.9.3.±..±..±.3.339±. ±..3±. ±.3.9±. ±.3.9±..9±.3.±. Details of terminal portion Tolerance: ±. ±. For Cautions for Use, see Relay Technical Information.