BTA6-600CW3G, BTA6-800CW3G Triacs Silicon Bidirectional Thyristors Designed for high performance fullwave ac control applications where high noise immunity and high commutating di/dt are required. Features Blocking oltage to 800 On-State Current Rating of 6 A RMS at 5 C Uniform Gate Trigger Currents in Three Quadrants High Immunity to d/dt 000 / s minimum at 5 C Minimizes Snubber Networks for Protection Industry Standard TO-0AB Package High Commutating di/dt 8.5 A/ms minimum at 5 C Internally Isolated (500 RMS ) These Devices are PbFree and are RoHS Compliant MAXIMUM RATINGS (T J = 5 C unless otherwise noted) Rating Symbol alue Unit Peak Repetitive OffState oltage (Note ) (T J = 40 to 5 C, Sine Wave, 50 to 60 Hz, Gate Open) BTA6600CW3G BTA6800CW3G On-State RMS Current (Full Cycle Sine Wave, 60 Hz, T C = 5 C) Peak Non-Repetitive Surge Current (One Full Cycle Sine Wave, 60 Hz, T C = 5 C) DRM, RRM 600 800 I T(RMS) 6 A I TSM 70 A Circuit Fusing Consideration (t = 0 ms) I t 44 A sec NonRepetitive Surge Peak OffState oltage (T J = 5 C, t = 0ms) DSM/ RSM DSM/ RSM +00 Peak Gate Current (T J = 5 C, t = 0 s) I GM 4.0 A Peak Gate Power (Pulse Width.0 s, T C = 80 C) P GM 0 W Average Gate Power (T J = 5 C) P G(A).0 W Operating Junction Temperature Range T J 40 to +5 C Storage Temperature Range T stg 40 to +50 C RMS Isolation oltage iso 500 (t = 300 ms, R.H. 30%, T A = 5 C) Stresses exceeding Maximum Ratings may damage the device. Maximum Ratings are stress ratings only. Functional operation above the Recommended Operating Conditions is not implied. Extended exposure to stresses above the Recommended Operating Conditions may affect device reliability.. DRM and RRM for all types can be applied on a continuous basis. Blocking voltages shall not be tested with a constant current source such that the voltage ratings of the devices are exceeded. 3 TRIACS 6 AMPERES RMS 600 thru 800 OLTS MT 4 TO0AB CASE A STYLE MARKING DIAGRAM PIN ASSIGNMENT Main Terminal Main Terminal 3 Gate 4 No Connection BTA6xCWG AYWW ORDERING INFORMATION Device Package Shipping BTA6600CW3G Littelfuse.com TO0AB (PbFree) G x = 6 or 8 A = Assembly Location (Optional)* Y = Year WW = Work Week G = PbFree Package * The Assembly Location code (A) is optional. In cases where the Assembly Location is stamped on the package the assembly code may be blank. 50 Units / Rail BTA6800CW3G TO0AB (PbFree) 50 Units / Rail September 9, 06 Rev. 3 Publication Order Number: BTA6600CW3/D
BTA6600CW3G, BTA6800CW3G THERMAL CHARACTERISTICS Thermal Resistance, Characteristic Symbol alue Unit JunctiontoCase (AC) JunctiontoAmbient R JC.3 R JA 60 Maximum Lead Temperature for Soldering Purposes /8 from Case for 0 seconds T L 60 C C/W ELECTRICAL CHARACTERISTICS (T J = 5 C unless otherwise noted; Electricals apply in both directions) OFF CHARACTERISTICS Characteristic Symbol Min Typ Max Unit Peak Repetitive Blocking Current ( D = Rated DRM, RRM ; Gate Open) T J = 5 C T J = 5 C ON CHARACTERISTICS Peak On-State oltage (Note ) (I TM = ±.5 A Peak) I DRM, I RRM 0.005.0 ma TM.55 Gate Trigger Current (Continuous dc) ( D =, R L = 30 ) MT(+), G(+) MT(+), G() MT(), G() I GT.0.0.0 ma Holding Current ( D =, Gate Open, Initiating Current = ±500 ma) I H 50 ma Latching Current ( D =, I G =. x I GT ) MT(+), G(+) MT(+), G() MT(), G() I L 60 65 60 ma Gate Trigger oltage ( D =, R L = 30 ) MT(+), G(+) MT(+), G() MT(), G() GT 0.5 0.5 0.5.7.. Gate NonTrigger oltage (T J = 5 C) MT(+), G(+) MT(+), G() MT(), G() DYNAMIC CHARACTERISTICS Rate of Change of Commutating Current, See Figure 0. (Gate Open, T J = 5 C, No Snubber) Critical Rate of Rise of OnState Current (T J = 5 C, f = 0 Hz, I G = x I GT, tr 00 ns) Critical Rate of Rise of Off-State oltage ( D = 0.66 x DRM, Exponential Waveform, Gate Open, T J = 5 C) GD 0. 0. 0. (di/dt) c 8.5 A/ms di/dt 50 A/ s d/dt 000 / s. Indicates Pulse Test: Pulse Width.0 ms, Duty Cycle %. September 9, 06 Rev. 3 Publication Order Number: BTA6600CW3/D
BTA6600CW3G, BTA6800CW3G oltage Current Characteristic of Triacs (Bidirectional Device) + Current Symbol DRM I DRM RRM I RRM Parameter Peak Repetitive Forward Off State oltage Peak Forward Blocking Current Peak Repetitive Reverse Off State oltage Peak Reverse Blocking Current I RRM at RRM on state I H TM Quadrant MainTerminal + TM I H Maximum On State oltage Holding Current I H off state I DRM at DRM + oltage Quadrant 3 MainTerminal TM Quadrant Definitions for a Triac MT POSITIE (Positive Half Cycle) + (+) MT (+) MT Quadrant II () I GT (+) I GT Quadrant I I GT + I GT () MT () MT Quadrant III () I GT (+) I GT Quadrant I MT NEGATIE (Negative Half Cycle) All polarities are referenced to. With inphase signals (using standard AC lines) quadrants I and III are used. September 9, 06 Rev. 3 3 Publication Order Number: BTA6600CW3/D
BTA6600CW3G, BTA6800CW3G TC, CASE TEMPERATURE ( C) 5 0 5 0 05 00 95 90 85 = 80 DC = 30 and 60 = 90 = 0 P A, AERAGE POWER (WATTS) 0 8 6 4 0 8 6 4 DC 80 0 90 60 = 30 80 0 4 6 8 0 I T(RMS), RMS ON STATE CURRENT (AMP) 4 6 0 0 4 6 8 0 I T(RMS), ON STATE CURRENT (AMP) 4 6 Figure. RMS Current Derating Figure. On-State Power Dissipation I T, INSTANTANEOUS ON STATE CURRENT (AMP) 000 00 0 Typical @ T J = 40 C Typical @ T J = 5 C Typical @ T J = 40 C Typical @ T J = 5 C Typical @ T J = 5 C Typical @ T J = 5 C r(t), TRANSIENT THERMAL RESISTANCE (NORMALIZED) 0. 0.0 0. 40 I H, HOLD CURRENT (ma) 30 5 0 5 0 0 00 000 t, TIME (ms) Figure 4. Thermal Response MT POSITIE MT NEGATIE 0 4 0. 0.5.5.5 3 T, INSTANTANEOUS ON-STATE OLTAGE () Figure 3. On-State Characteristics 5 40 5 0 5 0 50 65 80 95 0 5 T J, JUNCTION TEMPERATURE ( C) Figure 5. Hold Current ariation September 9, 06 Rev. 3 4 Publication Order Number: BTA6600CW3/D
BTA6600CW3G, BTA6800CW3G I GT, TRIGGER OLTAGE (ma) 00 0 Q Q3 Q D = R L = 30 40 5 0 5 0 50 65 80 95 0 5 T J, JUNCTION TEMPERATURE ( C) Figure 6. Gate Trigger Current ariation GT, TRIGGER OLTAGE ().6.4. 0.8 0.6 0.4 Q3 Q Q D = R L = 30 40 5 0 5 0 50 65 80 95 0 5 T J, JUNCTION TEMPERATURE ( C) Figure 7. Gate Trigger oltage ariation L L N4007 00 RMS ADJUST FOR I TM, 60 Hz AC MEASURE I CHARGE TRIGGER CHARGE CONTROL NON POLAR C L TRIGGER CONTROL MT N94 5 G - + 00 Note: Component values are for verification of rated (di/dt) c. See AN048 for additional information. Figure 8. Simplified Test Circuit to Measure the Critical Rate of Rise of Commutating Current (di/dt) c September 9, 06 Rev. 3 5 Publication Order Number: BTA6600CW3/D
BTA6600CW3G, BTA6800CW3G PACKAGE DIMENSIONS TO0 CASE A07 ISSUE AA H Q Z L G B 4 3 N D A K F T U C T SEATING PLANE J S R NOTES:. DIMENSIONING AND TOLERANCING PER ANSI Y4.5M, 98.. CONTROLLING DIMENSION: INCH. 3. DIMENSION Z DEFINES A ZONE WHERE ALL BODY AND LEAD IRREGULARITIES ARE ALLOWED. INCHES MILLIMETERS DIM MIN MAX MIN MAX A 0.570 0.60 4.48 5.75 B 0.380 0.405 9.66 0.8 C 0.60 0.90 4.07 4.8 D 0.05 0.0 0.64 0.88 F 0.4 0.47 3.6 3.73 G 0.095 0.05.4.66 H 0.0 0.55.80 3.93 J 0.04 0.0 0.36 0.55 K 0.500 0.56.70 4.7 L 0.045 0.060.5.5 N 0.90 0.0 4.83 5.33 Q 0.00 0.0.54 3.04 R 0.080 0.0.04.79 S 0.045 0.055.5.39 T 0. 0.55 5.97 6.47 U 0.000 0.050 0.00.7 0.045 ---.5 --- Z --- 0.080 ---.04 STYLE : PIN. MAIN TERMINAL. MAIN TERMINAL 3. 4. NOT CONNECTED Littelfuse products are not designed for, and shall not be used for, any purpose (including, without limitation, automotive, military, aerospace, medical, life-saving, life-sustaining or nuclear facility applications, devices intended for surgical implant into the body, or any other application in which the failure or lack of desired operation of the product may result in personal injury, death, or property damage) other than those expressly set forth in applicable Littelfuse product documentation. Warranties granted by Littelfuse shall be deemed void for products used for any purpose not expressly set forth in applicable Littelfuse documentation. Littelfuse shall not be liable for any claims or damages arising out of products used in applications not expressly intended by Littelfuse as set forth in applicable Littelfuse documentation. The sale and use of Littelfuse products is subject to Littelfuse Terms and Conditions of Sale, unless otherwise agreed by Littelfuse. Littelfuse.com September 9, 06 Rev. 3 6 Publication Order Number: BTA6600CW3/D