TESTING LOW-PROFILE SURFACE-MOUNT RELAY RELAYS 5.6. mm inch FEATURES Low-profile: 6 mm.36 inch in height comforming to EIA standards (Tape height: max. 6.5 mm.56 inch ) Tape and reel package is available as standard packing style Surge withstand between contacts and coil: 5 V Breakdown voltage between contacts and coil: 5 V High capacity: A High sensitivity: Form C; power consumption (Single side stable type) SPECIFICATIS Contact Arrangement Initial contact resistance max. (By voltage drop 6 A) Contact material Rating power Expected life (min. operations) switching capacity ( load) switching power ( load) switching voltage switching current switching capacity Single side stable coil latching coil latching Form C 75 mω Gold-clad silver alloy A 3.5 A 5 V AC 6 W 6.5 VA 5 V AC A µa m (.5 to ) (4 ) 3 (48 ) 7 (.5 to ) (4 ) (.5 to ) (4 ) Mechanical (at 8 cpm) 8 Electrical (at cpm) A 3 A 3.5 A 5 V AC Note: This value can change due to the switching frequency environmental conditions and desired reliability level therefore it is recommended to check this with the actual load. Remarks * Specifications will vary with foreign standards certification ratings. * Measurement at same location as "Initial breakdown voltage" section. * By method nominal voltage applied to the coil; contact carrying current: A. * 3 voltage applied to the coil excluding contact bounce time. * 4 voltage applied to the coil excluding contact bounce time without diode. * 5 Half-wave pulse of sine wave: 6 ms; detection time: µs * 6 Half-wave pulse of sine wave: 6 ms * 7 Detection time: µs * 8 Refer to 4. Conditions for operation transport and storage mentioned in Cautions for use (Page 78). 5 5 5 Characteristics Initial insulation resistance* Initial breakdown voltage Initial surge voltage Between open contacts Between contact sets Between contact and coil Between open contacts ( 6 µs) Between contacts and coil ( µs) MΩ (at 5 ) Vrms for min. (Detection current: ma) 5 Vrms for min. (Detection current: ma) 5 Vrms for min. (Detection current: ma) 5 V (FCC Part 68) 5 V (Bellcore) Temperature rise* (at C) 5 C Operate time [Set time]* 3 (at C) Release time [Reset time]* 4 (at C) Shock resistance Vibration resistance Conditions for operation transport and storage* 8 (Not freezing and condensing at low temperature) Unit weight 4 ms (Approx. ms) [ 4 ms (Approx. ms)] 4 ms (Approx. ms) [ 4 ms (Approx. ms)] Functional* 5 75 m/s {75 G} Destructive* 6 m/s { G} Functional* 7 Destructive Ambient temperature Humidity m/s {G} to 55 Hz at double amplitude of 3.3 mm 4 m/s {3G} to 55 Hz at double amplitude of 5 mm 4 C to 85 C* 3 4 F to 85 F 5 to 85% R.H. Approx. g.7 oz
ORDERING INFORMATI Ex. TQ SA L 3V Z Contact arrangement Surface-mount availability Operating function Coil voltage (DC) Packing style : Form C SA: Standard surface-mount Nil: Single side stable.5 3 4.5 5 6 Nil: Tube packing SA: terminal type L: coil latching 4 48* V Z: Tape and reel packing (picked from the 6/7/8//-pin side) SL: High connection reliability L: coil latching SA: surface-mount terminal type SS: Space saving surface- SA: mount terminal type *48 V coil type: Single side stable only Notes:. Tape and reel (picked from //3/4/5-pin side) is also available by request. suffix -X is needed when ordering. (ex.) TQSA-3V-X. Tape and reel packing symbol -Z or -X are not marked on the relay. Surface-mount terminal variation Variation Terminal style Normal environments (indoor) Ambient environment Drastic temperature fluctuations (outdoor) (Standard surface-mount terminal type) 7.6.3.5±.5.453±..5. (Highly connection reliability surface-mount terminal type) 7.6.3.5±.5.453±..5. (Space saving surface-mount terminal type) 7.6.3.3±.5 ±..5. TYPES. Single side stable. coil latching (max.) Drop-out (min.) current ma (±%) Coil resistance Ω (±%) power allowable TQS -.5 V.5.3.5 3.8 6. TQS -3 V 3.5.3 46.7 64.3 4.5 TQS -4.5 V 4.5 3.38.45 3 5 6.7 TQS -5 V 5 3.75.5 8. 78 7.5 TQS -6 V 6 4.5.6 3.3 57 TQS - V 6.75. 5.5 57 3.5 TQS - V..7 8 8 TQS -4 V 4 8.4 8.3 88 36 TQS -48 V 48 36 4.8 6.3 768 3 57.6 Set (max.) Reset (max.) current ma (±%) Coil resistance Ω (±%) power allowable TQS -L-.5 V.5.3.3 46. 3 7. TQS -L-3 V 3.5.5 3.3 8.6 7 4.5 TQS -L-4.5 V 4.5 3.38 3.38 5.6 8.3 7 6.7 TQS -L-5 V 5 3.75 3.75 357 7 7.5 TQS -L-6 V 6 4.5 4.5.7 5 7 TQS -L- V 6.75 6.75 7.8 57 7 3.5 TQS -L- V 5.8 57 7 8 TQS -L-4 V 4 8 8 4. 576 36
3. coil latching Set (max.) Reset (max.) current ma (±%) Coil resistance Ω (±%) : For each surface-mounted terminal variation input the following letter. : A : L : S Notes:. Specified value of the pick-up drop-out set and reset voltage is with the condition of square wave coil pulse.. Standard packing: Tube: 5 pcs.; Case; pcs.; Tape and reel: 5 pcs./reel 3. In case of 5 V transistor drive circuit it is recommended to use 4.5 V type relay. power allowable TQS -L-.5 V.5.3.3 3.8 6. TQS -L-3 V 3.5.5 46.7 64.3 4.5 TQS -L-4.5 V 4.5 3.38 3.38 3 5 6.7 TQS -L-5 V 5 3.75 3.75 8. 78 7.5 TQS -L-6 V 6 4.5 4.5 3.3 57 TQS -L- V 6.75 6.75 5.5 57 3.5 TQS -L- V.7 8 8 TQS -L-4 V 4 8 8 8.3 88 36 DIMENSIS.54..54..5..5. 5.6...8 7.5.5 7.6.3.5±.5.453±. 7.6.3.5±.5.453±..5..5. Recommendable mounting pad (Top view).4.6.3..3.3.54..54..7.56.376 For glue-pad mm inch Schematic (Top view) Single side stable (Deenergized condition) 8 7 6 3 4 5 -coil latching (Reset condition) 8 7 6 3 4 5.54..5. 7.5.5 7.6.3.3±.5 ±..5. General tolerance: ±.3 ±..4.6.84.7.3.54..56.376 8.46.333 -coil latching (Reset condition) 8 7 6 3 4 5 REFERENCE DATA Tolerance: ±. ±.4. Maximum switching capacity. Life curve 3. Mechanical life Tested sample: TQSA-V pcs. Switching current A 3....5.4.3. AC load DC load No. of operations 4 5 3 5V AC load 3 load Ratio against the rated %V 8 7 6 5 4 3 3 5 3 Contact V.. Switching current A IRS No. of operations 4
4.-() Electrical life ( A 3 load) Tested sample: TQSA-V 6 pcs. Operating frequency: cpm 4.-() Electrical life (.5 A 5 V AC load) Tested sample: TQSA-V 6 pcs Operating frequency: cpm Ratio against the rated %V 8 7 6 5 4 3 Contact resistance mω 8 7 6 5 4 3 Ratio against the rated %V 8 7 6 5 4 3 IRS 3 4 5 6 7 8 No. of operations 4 IRS 3 4 5 6 7 8 No. of operations 4 IRS 3 4 5 6 7 8 No. of operations 4 5. Coil temperature rise Tested sample: TQSA-V 6 pcs. Point measured: Inside the coil Ambient temperature: 5 C 77 F 6. Operate/release time Tested sample: TQSA-V 6 pcs. Contact resistance mω 8 7 6 5 4 3 Temperature rise C 7 6 5 4 3 Coil voltage DC V type DC 48V type A A A A Operate and release time ms 5 4 3 Operate time Release time IRS 3 4 5 6 7 8 No. of operations 4 3 5 Coil applied %V 7 8 Coil applied %V 7. Distribution of pick-up and drop out voltage Tested sample: TQSA-V 5 pcs. @ À @@ ÀÀ @@ ÀÀ 3 @@ ÀÀ @@ ÀÀ @ À 3 4 5 6 7 8 Ratio against the rated %V 8. Distribution of set and reset voltage Tested sample: TQSA-L-V 3 pcs. 3 5 5 5 Set voltage Reset voltage 3 4 5 6 7 8 Ratio against the rated %V. Ambient temperature characteristics Tested sample: TQSA-V 5 pcs. 4 Rate of change % 4 4 6 8 Ambient temperature C 4 x. Distribution of contact resistance Tested sample: TQSA-5V 3 pcs. (3 4 contacts).-() High-frequency characteristics Isolation characteristics.-() High-frequency characteristics Insertion loss characteristics 5 4 3 Terminal Nos. 3-4 7-8 8 7 3 4 5 (TOP VIEW) Terminal Nos. -3 8-3 4 5 Contact resistance mω 6 Isolation db 5 Frequency MHz Insertion loass db..8.6.4. Frequency MHz 3
.-() Malfunctional shock (single side stable) Tested sample: TQSA-V 6 pcs.-() Malfunctional shock (latching) Tested sample: TQSA-L-V 6 pcs. Y X m/s Z X X' Y m/s Deenergized condition Energized condition m/s Y X m/s Z X X' Y m/s Reset condition Set condition m/s m/s Z m/s X' m/s Z m/s X' m/s m/s 3.-() Influence of adjacent mounting Tested sample: TQSA-V 5 pcs. 3.-() Influence of adjacent mounting Tested sample: TQSA-V 6 pcs. 3.-(3) Influence of adjacent mounting Tested sample: TQSA-V 6 pcs. Rate of change % Rate of change % 3 5.3 4 6.7.8.57.7.36 Inter-relay distance mm inch Rate of change % Rate of change % 3 5.3.7 4 6.8.57.7.36 Inter-relay distance mm inch Rate of change % Rate of change % 3 5.3 4 6.7.8.57.7.36 Inter-relay distance mm inch. Pulse dialing test Tested sample: TQSA-V 6 pcs. (35 ma 48 wire spring relay load) Circuit 458 Ω.8.8 µf µf 48 458 Ω Wire spring relay 3 relay Ratio against the rated %V 8 7 6 5 4 3 Contact resistance mω 8 7 6 5 4 3 IRS 3 4 No. of operations 4 5 IRS 3 4 No. of operations 4 5 For Cautions for Use see Relay Technical Information // 4 All Rights Reserved Copyright Matsushita Electric Works Ltd.