ZITARES LCS Non-SELV, Constant current control gear, 1-channel, non-dimmable

Transcription

1 ECG versions Order no. Output currents Output power LCS135-70FX-01/ ma max. 70 W LCS150-70FX-01/ ma max. 70 W LCS170-70FX-01/ ma max. 70 W Performance characteristics Non-dimmable 1-channel ECG for constant current operation of LED modules Non-SELV output voltage Very high efficiency of up to 93 % (100 % load) For use in luminaires of protection class I ECG extensively protected against abnormal operating conditions at the output e.g. short-circuit, open circuit or overload Suitable for direct current operation and application in combination with central battery installations Certified as thermally protected device Conformance with international regulations, regarding safety and operation, electromagnetic compatibility and immunity to interference Nominal service lifetime with a failure rate 10 %: 30,000 h at t c = t c,max 50,000 h at t c = t c,max - 10K Applications Office Industrial Shop Markings alternations in the interest of improving our products. 02/2016 1/5

2 General technical data Mains voltage supply Rated voltage range V Max. permanent voltage range (continuous) V Rated frequency 0 / Hz Battery operation Voltage range for continuous operation VDC Lowest limiting value for temporary operation 176 VDC / 0.5 h Mains overvoltage Overvoltage protection 350 VAC / 2 h Automatic switch-off of the LEDs at appr. 320 VAC Protection against voltage peaks Voltage peaks L - N 1 kv Voltage peaks L/N -PE 2 kv Starting time Time to 100% luminous fl ux < 0.5 s Total harmonic distortion (THD) At 100% load to ECG-output < 10 % Output data Tolerance of output current +/- 10 % Max. ripple of output current +/- 20 % Max. wire length to LED module 2 m Galvanic separation to mains input no Protection functions output side Overload operation yes; ECG switch-off, restart after mains interruption Short-circuit operation yes; limitation of the output current Open-circuit operation yes; ECG switch-off, restart after mains interruption Lifetime Operation at t c = t c,max 30,000 h; failure rate 10 % Operation at t c = t c,max - 10 K 50,000 h; failure rate 10 % Connection terminals Type Terminal with release hole Wire cross section 0.5 mm² mm² Wire stripping length 8 mm - 9 mm Thermal protected device Max. sureface temperature acc. to EN /C5e C Degree of protection Degree of protection of ECG housing IP 20 Terminals and ECG construction are designed for an automatic wiring with robots Order no. for release spike: /5 2/6 alternations in the interest of improving our products 02/2016

3 Temperatures (operation) Ambient (t a ) Case (t c ) LCS135-70FX C C max C LCS150-70FX C C max C LCS170-70FX C C max C Lifetime LCS135-70FX LCS150-70FX LCS170-70FX typ. I peak /Δt 30 A / 115 μs 30 A / 116 μs 37 A / 151 μs Number of ECG at one singlepole circuit breaker (CB) CB-Typ 10 A 16 A 20 A 25 A B C B C B C Typical current - time profile when switching on I[A] Ipeak ½ x Ipeak - Data for U supply = 230 VAC, mains impedance = 1 Ω - In case of multi-polar CB the maximum number is reduced by 20 % - The max. number may differ depending on CB manufacturer. Please consider the specifications of the manufacturer. - Basically, CB with C-characteristics are recommended to be used in lighting groups. t t Operating data Input current Input power W Power factor LCS135-70FX , , ,5 LCS150-70FX , , ,0 LCS170-70FX , , ,0 All specifications with 230 VAC nominal operation and 100 % ECG Output currents 4) Output voltage / efficiency channel A % ma V W Total output 2), 3) power alternations in the interest of improving our products. 02/2016 3/5

4 Operating data LCS135-70FX LCS150-70FX LCS170-70FX 140 Output voltage per channel [V] Output current per channel [ma] Efficiency and power factor Efficiency vs. output load 100 Power factor vs. output load ,95 Efficiency [%] Power factor 0,9 0,85 0,8 LCS LCS 0, Total load on ECG output [%] Total load on ECG output [%] 4/5 4/6 alternations in the interest of improving our products. 02/2016

5 Wiring diagrams ECG 1 Connection of ECG output side A Connection of ECG input side L N PE + CH1 LED - more ECG ECG dimensions X X M Y Z Z M mm mm mm mm mm LCS135-70FX LCS150-70FX LCS170-70FX Xm X Zm Z Y Logistic data Order no. EAN Weight ECG LCS135-70FX-01/ , x 285 x LCS150-70FX-01/ , x 285 x LCS170-70FX-01/ , x 285 x Packaging unit ECG PU Dimensions PU kg pcs. mm kg Weight PU Conformance with regulations EN EN EN EN EN IEC IEC General and safety requirements Particular requirements for d.c. or a.c. supplied electronic control gear for LED modules D.C. or A.C. supplied electronic control gear for LED modules - Performance requirements Equipment for general lighting purposes - EMC immunity requirements Limits and methods of measurement of radio disturbance characteristics of electrical lighting and similar equipment Environmental testing: Tests Test Fc: Vibration (sinusoidal) Environmental testing: Tests Test Ea and guidance: Shock 02/ alternations in the interest of improving our products. 02/2016 5/5