YELLOW special. Light can do more. special lighting for photo lithography and printing industry

Transcription

1 YELLOW special Light can do more. special lighting for photo lithography and printing industry

2 Application areas: NARVA YELLOW special lamps have been designed specifically for industrial use where UV and blue spectrum components would otherwise disrupt or hinder the manufacturing process. Their use is not limited to manufacturing microchips you will also find these lamps used in the printing industry where printing plates need to be protected from exposure to blue and UV light. We use a specialised filter tube to achieve these excellent spectral properties. This filter tube ensures long life as well as excellent filter properties at the required wavelength limit of 500 nm. The YELLOW special product group includes the ideal lamp for any lighting system, allowing you to upgrade and maintain existing light installations using LT-T8 fluorescent lamps or LED DT-T8 II Retrofit lighting technology. You can also install new lighting systems using lamps such as state-of-the-art T5 fluorescent lamps or innovative and patented SL-T5 III LEDs.

3 LED-lamp SL-T5 III Generation of the spectrum by the LED without the use of a filter sleeve simple integration into a new lighting system switchable and dimmable, perfect for intelligent lighting control systems value-added safety compliance with SELV (safety extra low voltage) high-quality components replaceable - saves resources, protects your investment 25 C SL-T5 III YELLOW special 549mm ME G5L A + 1, G5L ,000 h 1L2R3SPYES_ SL-T5 III YELLOW special 1,149mm ME G5L A ++ 2, G5L 1,149 55,000 h 1L2R3SPYES_ SL-T5 III YELLOW special 1,449mm ME G5L A ++ 3,900 1, G5L 1,449 55,000 h 1L2R3SPYES_ SL-T5 III YELLOW special 1,200 mm ME G13L A ++ 2, G13L 1,200 55,000 h 1L1R3SPYES_ SL-T5 III YELLOW special 1,500 mm ME G13L A ++ 3,900 1, G13L 1,500 55,000 h 1L1R3SPYES_ ma kwh/1,000h useful lifetime LT-T5 fluorescent lamp wide range of types and levels lamp body and base are covered in an integral yellow filter tube standardised data in accordance with IEC/EN kwh/1,000h 25 C 35 C useful lifetime LT 8W T5 / YELLOW special 8 A G ,000 h 2) 17408SPYES_ LT 14W T5 EQ / YELLOW special 14 A ,025 G ,000 h 2) 17414SPYES_ LT 21W T5 EQ / YELLOW special 21 A 23 1,450 1,650 G ,000 h 2) 17421SPYES_ LT 28W T5 EQ / YELLOW special 28 A 31 2,000 2,275 G5 1,149 20,000 h 2) 17428SPYES_ LT 35W T5 EQ / YELLOW special 35 A 40 2,500 2,850 G5 1,149 20,000 h 2) 17435SPYES_ ) The filtering effect must be checked at the end of life time. Total lifetime for LT-T5: 35,000 h

4 DT-T8 II LED Retrofit lamp G13 socket turns through 90 for ideal lighting direction suitable for centralised emergency power systems DEKRA-certified basic lighting DT-T8 II LED Retrofit runs off the mains at 230V kwh/1,000h 25 C useful lifetime DT-T8 II 9,5W / YELLOW special 9,5 A G ,000 h 3) 35310T8R2SPYES_ DT-T8 II 18,5 W / YELLOW special 18,5 A ,850 G 13 1,200 30,000 h 3) 35319T8R2SPYES_ DT-T8 II 24,5W / YELLOW special 24,5 A ,550 G 13 1,500 30,000 h 3) 35325T8R2SPYES_ ) The filtering effect must be checked at the end of lifetime. Total lifetime for DT-T8 II: 50,000 h LT-T8 fluorescent lamps wide range of types and levels lamp body and base are covered in an integral yellow filter tube suitable for use on magnetic or electronic ballasts standardised data in accordance with IEC/EN kwh/1,000h 25 C useful lifetime LT 18W T8 / YELLOW special 18 B G ,000 h 4) 11018SPYES_ LT 36W T8 / YELLOW special 36 B 43 2,350 G 13 1,200 20,000 h 4) 11036SPYES_ LT 58W T8 / YELLOW special 58 B 68 3,600 G 13 1,500 20,000 h 4) 11058SPYES_ ) The filtering effect must be checked at the end of the lifetime. Total lifetime for LT-T8: 20,000 h

5 YELLOW special cut-off wavelength The cut-off effect on wavelengths less than 500 nm plays an essential role in a host of industrial processes such as in photolithography Wellenlänge / Wavelength (nm) NARVA YELLOW special products keep technically unavoidable residual radiation intensity at wavelengths below 500 nm to an extremly minimal level (< 0,5%), satisfying the most demanding of requirements in industry. YELLOW special transmission transmission in % nm nm ,1 15 0, wavelength in nm

6 DT-T8 II Retrofit operating instructions Simple upgrade for lamps using magnetic or low-loss ballasts Starter replacement included with every lamp Protect from the wet! DT-T8 II tubes are unsuitable for operation with electronic ballasts Refer to for retrofitting instructions SL-T5 III LED operating instructions Only one base side needed for operation safe installation and light replacement Continuous dimming (1 100%) with suitable ballasts Reverse polarity protection External DC ballast required for operation General operating instructions for YELLOW special products The T5 and T8 tubes as well as our DT-T8 II use a specialised yellow protection tube to achieve these excellent filtering properties for wavelengths below 500 nm throughout the entire YELLOW special product line. We guarantee the resulting cut-off effect for blue and ultraviolet light for each individual product group during its useful life on condition that the lamp is used as intended. The difference between useful life and product lifetime results from ageing in the filter tube, which depends heavily on actual operating conditions. The following safety instructions generally apply to the filtering effect: Ambient temperatures must lie between -10 and 80 C5) We do not recommend using these lamps beyond their useful life! Using the lamp beyond its useful life may speed up the ageing process of the filter material, leading to insufficient filtering properties. The material may become brittle, eventually causing partial detachment of the filter tube from the lamp. In any case, you must check the filter effect in lamps used beyond their useful life. Keep your lamps stored at temperatures between 0 and 30 C, and do not keep them for longer than five years after their manufacturing date. Monitoring: Depending on your actual operating conditions, you may already detect a slight increase in irradiance in the sub-500 nm wavelength range during the lamp s useful life. We always recommend monitoring for this reason. 5) Observe the ambient temperatures specified for your lamp. NARVA Lichtquellen GmbH + Co. KG Errors and omissions excepted. Art.-Nr. 6060_0002 NARVA Lichtquellen GmbH + Co. KG Industriegebiet Nord Erzstraße 22 D Brand-Erbisdorf Tel.: +49 (0) / Fax: +49 (0) / Internet: office@narva-bel.de