light.augmented DRAN1HO The Photline DRAN1HO is a wideband RF amplifier module designed for analog applications at frequencies up to 1 GHz. The Photline DRAN1HO is characterized by a low Noise Figure and a linear transfer function whose 1 db compression point is above 23 dbm. It exhibits flat Group Delay and Gain curves with reduced ripple over the entire bandwidth. FEATURES Output voltage up to 12 V pp Linear amplifier Flat gain up to 1 GHz Single voltage power supply The Photline DRAN1HO operates from a single power supply for safety and ease of use, and offers gain control over 3 db. It comes in a compact 2 mm x 2.6 mm housing with K type RF connectors (compatible SMA) and with an optional heat sink. This amplifier module is ideally suited to drive optical modulators for analog applications. Low group delay variation APPLICATIONS LiNbO 3 modulators OFDM, RoF, Phase modulation Research & Development OPTIONS Heatsink Low output voltage version for EAM Performance Highlights Parameter Min Typ Max Unit Cutoff frequencies 8 k 11 G Hz Output voltage 12. V pp Gain 3 db Saturated output power 26 dbm Output power 1dB comp 24 2 dbm Harmonics 1 dbc Noise figure 3 db RELATED EQUIPMENTS Measurements for V bias MXIQLN, MXANLN modulators MBCAN Automatic Bias Controllers 1 /
DRAN1HO DC Electrical Characteristics Parameter Symbol Min Typ Max Unit Supply voltage (fixed) V bias 12 V Current consumption I bias ma Gain control voltage V amp 1. V Electrical Characteristics Parameter Symbol Condition Min Typ Max Unit Lower frequency f 3db, lower 3 db point 8 khz Upper frequency f 3db, upper 3 db point 11 GHz Gain S 21 Small signal 3 db Gain ripple < 1 GHz ±1. db Input return loss S 11 f < 1 GHz 1 db Output return loss S 22 f < 1 GHz 1 db Isolation S 12 f < 1 GHz 6 db Output power 1 db P 1dB 2 GHz < f < 1 GHz 24 2 dbm Saturated power P sat 2 GHz < f < 1 GHz 26 dbm Output voltage V out Linear 9 Maximum swing 12. V pp Noise figure NF 3 GHz < f < 1 GHz 2 3 db Harmonics Harm P1dB, f = GHz 1 dbc Power dissipation P Small signal 6 W Conditions: S parameters 3 dbm, T amb = 2 C, Ω system Absolute Maximum Ratings Stresses in excess of the absolute maximum ratings can cause permanent damage to the device. These are absolute stress ratings only. Functional operation of the device is not implied at these or any other conditions in excess of those given in the operational sections of the data sheet. Exposure to absolute maximum ratings for extended periods can adversely affect device reliability. Parameter Symbol Min Max Unit RF input voltage V in.9 V pp Supply Voltage V bias 11 13 V DC current I bias.6 ma Gain control voltage V amp 2 V Power dissipation P diss 7.3 W Temperature of operation T op +4 C Storage temperature T st 1 +7 C 2 /
DRAN1HO S 21 and Group Delay s S 12 S 21 (db) 4 3 3 2 2 1 1 S 21 Group delay 1 2 3 4 6 7 8 9 1 11 12 13 14 1,2 1,1 1,,9,8,7,6,,4,3,2,1, Group Delay (ns) S 12 (db) 1 2 3 4 6 7 8 9 1 2 3 4 6 7 8 9 1 11 12 13 14 S 22 S 11 1 1 1 S 22 (db) 1 2 S 11 (db) 2 2 3 2 3 1 2 3 4 6 7 8 9 1 11 12 13 14 3 4 4 1 2 3 4 6 7 8 9 1 11 12 13 14 Saturated Output Power Curve Noise Figure Curve 27 8 26 7 6 P1dB (dbm) 2 24 23 Noise figure (db) 4 3 2 1 22 2 4 6 8 1 12 14 2 4 6 8 1 12 14 3 /
DRAN1HO Electrical Schematic Diagram Mechanical Diagram and Pinout All measurements in mm 6 2.6 17 n2.3(x4) 11 6.4 4.4 26. 3x.8 4. 9.9 48.3 4.7 The heatsinking of the module is necessary. It s user responsability to use an adequate heatsink. Refer to page for ixblue recommended heatsink. PIN Function Unit IN RF In K connector female OUT RF Out K connector male V bias Power supply voltage Set 1 a typical operating specification CREATION IND. DESCRIPTION DE LA REVISION DESSINE V amp Output voltage amplitude adjustment Adjust for gain control tuning ECHELLE : TOL. GEN. : MATIERE : TRAITEMENT : 1:1 4 / Encombrement DRAN PL96MC1 16, rue Auguste Jouchoux 21 BESANCON FRANCE Tél. : +33 ()3 81 8 31 8 Fax : +33 ()3 81 81 1 7 Ce document est la proprieté de PHOTLINE Technologies et ne peut être reproduit ou communiqué sans SJ
DRAN1HO Mechanical Diagram And Pinout With HSHO1 Heatsink All measurements in mm 67 27 4 f 1 CREATION 1 INDD. ECHELLE : 1 :1 DDESCRIPTION DDE LA REVISION TOL. GEN. : MATIERE : 7_21_PT_SP_ED 3 1 48 3 f SJ D ESS D TRAITEMENT : Encombrement DDRA PL96MC1 16, rue Auguste Jouchoux 21 BESANCON FRANCE Tél. : +33 ()3 81 8 31 8 Fax : +33 ()3 81 81 1 7 Ce document est la proprieté de PHOTLINE Technologies et ne peut être reproduit ou communiqué s About us ixblue Photonics includes ixblue ixfiber brand that produces specialty optical fibers and Bragg gratings based fiber optics components and ixblue Photline brand that provides optical modulation solutions based on the company lithium niobate (LiNbO3) modulators and RF electronic modules. ixblue Photonics serves a wide range of industries: sensing and instruments, defense, telecommunications, space and fiber lasers as well as research laboratories all over the world. Ixblue reserves the right to change, at any time and without notice, the specifications, design, function or form of its products described herein. All statements, specification, technical information related to the products herein are given in good faith and based upon information believed to be reliable and accurate at the moment of printing. However the accuracy and completeness thereof is not guaranteed. No liability is assumed for any inaccuracies and as a result of use of the products. The user must validate all parameters for each application before use and he assumes all risks in connection with the use of the products 3, rue Sophie Germain 2 Besançon FRANCE Tel. : +33 () 381 83 18 Fax : + 33 () 381 811 7 /