ebm-papst Landshut GmbH Hofmark-Aich-Str. 5 D-8 Landshut Phone +9 87 77- Fax +9 87 77-65 info@de.ebmpapst.com www.ebmpapst.com Nominal data Type Motor GG5-GN9- MG8-FA Phase ~ Nominal voltage VAC Nominal voltage range VAC.. Frequency Hz 5/6 Type of data definition ml Speed min - 8 Power input W Current draw A Min. ambient temperature C - Max. ambient temperature C 6 Min. temp. of flow medium C Max. temp. of flow medium C 6 ml = max. load me = max. efficiency rfa = running at free air cs = customer specs cu = customer unit Subject to alterations Item no.: 5-5-998 Revision: 66688 Print-out 7// K. Boruzki (VI-I) Page of 5
Technical features Mass Size Surface of rotor Material of protective cover Material of impeller Housing material Number of blades 7 Direction of rotation. kg 5 mm Type of protection IP Insulation class Max. permissible ambient motor temp. (transp./ storage) Min. permissible ambient motor temp. (transp./storage) Mounting position Condensate discharge holes Operation mode Motor bearing Technical features EMC interference immunity EMC interference emission Leakage current Electrical leads Motor protection Protection class Coated in black Polyflam RPP 7-ND CS (UL 97-V) Aluminium sheet Die-cast aluminium Clockwise, seen on rotor "B" +8 C - C Any Rotor-side S Ball bearing - PFC, passive - Tach output - Over-temperature protected electronics / motor - Line undervoltage detection - Motor current limit - PWM control input - Control input - V Acc. to EN 6-6- (industrial environment) Acc. to EN 6-6- (industrial environment) <=.5 ma With plug Locked-rotor protection Approval CSA C. Nr.; UL 57 I Item no.: 5-5-998 Revision: 66688 Print-out 7// K. Boruzki (VI-I) Page of 5
Product drawing -pole strip to fit mating connector (not included in standard scope of delivery) tyco No. 5766-, female connector tyco No. 9688-. L. N. PE 5-pole strip to fit mating connector (not included in standard scope of delivery) Molex No. 9--5, female connector Molex No. 9--59. +. Speed monitoring. - VDC control input. PWM input.5 - Pressure tap optionally available Y Z Detail Y View Z / plug assignment Item no.: 5-5-998 Revision: 66688 Print-out 7// K. Boruzki (VI-I) Page of 5
Connection screen No. Pin Signal Function / assignment ST ; ; L; N; PE Power supply VAC, 5-6 Hz, phase, neutral, protective earth ST UB External voltage 6-5 VDC, residual ripple +/-.5%, SELV ST DUE Speed monitoring, pulses per revolution, SELV ST - V Control input - V, impedance k, SELV ST PWM Control input PWM, - 6 khz, SELV ST 5 GND Power supply VAC, 5-6 Hz, phase, neutral, protective earth Item no.: 5-5-998 Revision: 66688 Print-out 7// K. Boruzki (VI-I) Page of 5
Charts: Air flow 5 Hz Druck psf [Pa]für Rho=,kg/m^ psf [Pa].6.5......9.8.7.6.5......9.8.7.6.5..... 9 8 7 6 5 6 8 qv[cfm] 6. qv[m^/h]. 8.. psf [Pa].6.8,5,5,5,5 9,5 9 8,5 8 7,5 7 6,5 6 5,5 5,5,5,5,5,5. psf_e[in HO] Measurement: LU-7 Air performance measured as per ISO 58 Installation category A. For detailed information on the measuring set-up, please contact ebm-papst. Suction-side noise levels: LwA measured as per ISO 7 / LpA measured with m distance to fan axis. The values given are valid under the measuring conditions mentioned above and may vary according to the actual installation situation. With any deviation from the standard set-up, the specific values have to be checked and reviewed with the unit installed. Measured values U f n P e I LpA in qv p sf V Hz min - W A db(a) m /h Pa 5 95. 9 75 5 77. 89 5 5 8 8.76 8 5 59 56. 79 695 Item no.: 5-5-998 Revision: 66688 Print-out 7// K. Boruzki (VI-I) Page 5 of 5