KEEP IN MIND Compare SWISSTRAX with any other tile on the market and you should notice: weighs in heavier per sq. ft. then any other tile of its kind. has 20 locks per tile compared to 12-16. locks so tight together that even a slotted screwdriver is difficult to squeeze between the joints. The end result is a tight tile join with no or little shifting should a heavy vehicle turn its tires on the surface. offers a much more appealing design and durability. is designed and produced by the SWISS and looks, feels and lasts like the Swiss produced it. This is part of our tradition. is not as noisy as the competition. support system does not have more than 3/8" gap anywhere on the underside which will support the weight of jacks. Will not mark up on the surface with tires or dirt. The surface cleans up like new. (A good cleaner is SIMPLE GREEN) 77-770 Country Club Drive, Palm Desert, CA 92211 Tel. (760) 360-1441 / Fax (760) 360-0215 Toll Free: 1-866-748-7940 / E-mail: sales@swisstrax.com / www.swisstrax.com
77-770 Country Club Drive, Unit C, Palm Desert, CA 92211 Tel. (760) 360-1441/ Toll Free 1-866-748-7940 Fax (760) 360-0215 / E-mail: sales@swisstrax.com / www.swisstrax.com
77-770 Country Club Drive, Unit C, Palm Desert, CA 92211 Tel. (760) 360-1441/ Toll Free 1-866-748-7940 Fax (760) 360-0215 / E-mail: sales@swisstrax.com / www.swisstrax.com
versus Epoxy Coatings Epoxy 12 Year limited warranty YES NO No Hazardous materials Toxic fumes YES NO No acid washing or surface preparation YES NO Installed in hours YES NO Easily installed and moved by homeowner YES NO Not affected by moisture or automotive YES NO Chemicals Unaffected by new or existing foundation YES NO Concrete cracks Excellent slip resistance when wet YES NO Not affected by hot tires YES NO Easy to repair if damaged YES NO
***WARNING: Do not step on loose tiles as these may slip and cause injury*** Installing The SWISSTRAX Tile Floor. 1.) must be site conditioned at around room temperature (72 F) for a period of 24 hours prior to installation. 2.) Begin at the top left hand corner of the space to be covered. 3.) An expansion gap of ¼ (6mm) should be left at the walls and any other obstacle such as beams, cabinets and heavy equipment. Tiles should be laid around heavy equipment and not under them to allow for expansion and contraction. 3 1 4 2 5 4.) Set the first tile down, taking care to place the smooth edges left and top (wall sides). Place the next tile to the right of that, smooth edges left and top, interlocking the pegs under the second tile with the loops on the edge of the first tile. A tap with the palm of your hand should be sufficient to seat the tile tightly. 5.) Continue working towards the right until the first 3 rows are complete. Go back to the left side and install the first 3 rows towards the Garage Door opening. Now install the edging on the 3 front tiles and close the Garage Door. The edges should sit behind the closed door. (If the gap between the edge and the door is too large then pull the floor forward to where it should finish and cut-in the tiles to the back of the Garage) 6.) All products can be cut with the use of a wood cutting saw such as a Circular Saw, Jig Saw, Table Saw or even a hand saw for detailed areas. 7.) Continue to work from left to right and back to front. 8.) Be sure to check alignment along the top and the left side as you progress. Add edging and corners, if necessary, to finish the installation. 9.) A underlay is available to reduce noise and soften up the floor. This is only recommended where excessive moisture is not present. If the floor will be exposed to excessive water or liquids then the underlay should not be used. NOTE: For high moisture environments please consider using our Ribtrax products or incorporate our Sportrax tiles together with our Diamondtrax tiles to allow moisture to escape thus maintaining a dry sub-surface. In some applications, direct sunlight can cause expansion in the tiles and special installation measures may need to be taken. Questions? Call us toll free on 1-866-748-7940 THANK YOU FOR YOUR BUSINESS!!! www.swisstrax.com
SWISSTRAX Color Chart Pearl Silver Pantone 877C Slate Grey Pantone 431C Arctic White Jet Black Pantone Black C Racing Red Pantone 485C Turf Green Island Blue Pantone Reflex Blue Citrus Yellow Pantone 109 Tropical Orange RAL 2003 Midnight Blue RAL 5022 Chocolate Brown Pantone 469C Terra Cotta RAL 8004 Ivory RAL 1015 Mocha Java RAL 1014 77-770 Country Club Drive, Palm Desert, CA 92211 Tel. (760) 360-1441 / Toll Free 1-866-748-7940 Fax (760) 360-0215 / E-mail: sales@swisstrax.com / www.swisstrax.com