Digital Power Amplifier DPA-O SERIES
SUMMARY The DPA- O Series offers both low impedance and High impedance outputs in one package Ideal for applications where high power and large quantity of long-line speaker installation is required. The superior efficiency of a Class-D amplifier means higher power output and greater compactness than an analog amplifier offers. OVERVIEW The DPA-O Series is a amplifier operate in 4 8 ohm/ 70v/ 00v modes and are capable of delivering a total 00 watts of Power. Respectively housed in RU compact chassis, these Class D amplifiers offer High power in reduced size and weight. The combination Class D topology amplification circuitry combined with SMPS (Switch mode Power Supplies) creates a high efficiency amplifier offering reduced power consumption and low heat dissipation. The DPA-O Series offers both low impedance and High impedance outputs in one package Ideal for applications where high power and large quantity of long-line speaker installation is required such as Airports Arena, shopping malls, transportation stadiums or any large scale facilities. Inter-M, PA AMPLIFIER CLASS D Class D audio amplifier offer greater power efficiency over traditional amplifiers. Among their advantages is their reduced physical size and lower heat dissipation. They offer less than 0.% THD, total harmonic distortion with an increased signal to noise ratio to 0dB and a widened frequency response from 50Hz ~ 0kHz Class D audio amplifier offers greater than 90% power efficiency over traditional amplifiers. SMPS - Switch mode power supply provides high efficiency and low weigh. Among their advantages is their reduced physical size and lower heat dissipation. The DPA-O series is fully equipped with a protection circuit against short circuit, overload, power and DC output. Same Powerful Output from a More Compact Amp The superior efficiency of a Class-D amplifier means higher power output and greater compactness than an analog amplifier offers. Only rack units in size, the DPA-O Class D audio amplifier with ECO Digital design offers greater than 90% power efficiency and lower heat dissipation over traditional low efficiency and noise from analog amplifier.
Efficiently Compact and Lots of Power Class-D amplifiers overcome the inefficiencies of traditional Class-A or AB amplifiers. The Inter- M DPA-O Class-D amplifiers transform very little power into heat so a higher percentage of the power supply is transformed into the load. This results in a very compact amplifier which needs less input power to produce very high output power. Why Use Class D-Amplifiers Class-D amplifiers deliver more output watts ratio to input AC power than conventional analogue amplifiers. How? The Class-D amplifier s PWM (Pulse Width Modulator) modulates the original audio input signal with a triangulated signal wave which has a much higher fixed frequency. The result is a digital signal which contains both the input signal and a band of frequency components around the modulation frequency. A LPF (Low Pass Filter) then filters out the high frequency pulses and the resulting amplified output signal is then sent to the speakers. Analog Amplifier Digital Amplifier 00% Power Trans. Amp. Out Put Trans. 00% SMPS Amp. 50% 86% 00% 80% 65% 50% EFFICIENCY 00% 94% 86% EFFICIENCY SMPS provides high efficiency and low weight SMPS - Switch mode power supply provides high efficiency and low weigh. Among their advantages is their reduced physical size and lower heat dissipation. SMPS offer power efficiency and reduced power consumption over traditional amplifiers. High Performance The DPA-O Series amplifier offers superior incomparable performance and hi-definition sound with better S/N and THD than any other class D power amplifier in the market. Inter-M DPA-600SO Other Brand A Other Brand B Rated Output 600W 600W 600W S/N 0dB 00dB 00dB THD 0.0% 0.0% 0.0% Power consumption(/8) 0W 56W 70W
THD : Total harmonic distortion THD: Total harmonic distortion stands. The lower THD means that the equipment produces a more accurate reproduction by reducing harmonics added by electronics and audio media. S/N : Signal to Noise Ratio S / N Ratio: stands for Signal to Noise Ratio expressed in db. It is a measurement that compares the level of a desired signal to the level of background noise. It is defined as the ratio of signal power to the noise power. The higher the ratio indicates more signal than noise. P = IR = V/R P : Amp Output Power (Watt) R : Speaker Impedance (Ohm : Ω) V : Amp Output Voltage I : Amp Output Current (Ampere) Amplifier Power Hi Z - Public Address Amplifier Lo Z - Professional (SR) 70.7V 00V 8 ohms 00W 6.6 ohms ohms 49V 600W 8. ohms 6 ohms 69.V 900W 5.5 ohms ohms 85V 00W 4 ohms 8. ohms 98V The relationship between the output of amplifiers and the impedance of speakers The DPA-O amplifier can be used in both low impedance and high impedance applications. This is possible because the amplifier operates in a constant voltage output hence delivering maximum power. The following mathematical formula based on Ohms Law demonstrates the relationship between speaker impedance, power and voltage. Wide Range of Selection CH (S) : 00W/900W/600W/00W (4 Models) CH (T) : 00+00+00W ( Model) CH (D) : 600+600W/00+00W ( Models) 4CH (Q) : 00+00+00+00W ( Model)
DPA-O Series DIGITAL POWER AMPLIFIER High Performance Class-D Power PA Amplifier High performance Class-D Power amplifiers produce 00 / 600 / 900 / 00W rated power each channel. Remote Power ON/OFF The remote power allows the amplifier to be turned on or off from a distance or other device via dry contact closure. Advanced Power Circuitry Design The combination Class-D type amplification circuitry combined with SMPS creates a high efficiency amplifier offering reduced power consumption and low heat dissipation and weight. PRIORITY Input PGM is interrupted and over ridden by the Priority input, when a contact closure is received on the PRI select terminal. This is Ideal for Emergency message broadcasting applications. High Quality Sound Design The total harmonic distortion is reduced to less than 0.0% THD, with a high signal to noise S /N ratio of over 0dB. A Variety of operation Indicators Signal, -0dB signal level, Clip, Protection and system power (AC, DC, STBY) indicators.
Front Panel SIGNAL INDICATORS VOLUME CONTROL POWER SWITCH Rear Panel 4 5 6 7 8 4 5 6 7 AC INLET 5 PRI VOLUME CONTROL AC POWER REMOTE 6 OUTPUT TERMINAL COOLING VENTS 7 OUTPUT VOLTAGE SELECTOR 4 PRIORITY INPUT AND CONTACT CLOSURE 8 PGM INPUT CONNECTOR 8
MEMO
SPECIFICATIONS Single Channel DPA-00SO DPA-600SO DPA-900SO DPA-00SO Rated Output Power (T.H.D 0.%, AES7) 00W 600W 900W 00W Peak Power 480W 680W 050W 60W Output Level/Impedance 00V/.Ω 00V/6.6Ω 00V/.Ω 00V/8.Ω 70V/6.Ω, 49V/8Ω 70V/8.Ω, 69.V/8Ω 70V/5.4Ω, 84.9V/8Ω 70V/4.Ω, 98V/8Ω Input Sensitivity V/0kΩ THD (AeS7) Rated Power Less than 0.% / Power Less than 0.0% S/N (0kHz LPF) More than 0dB Frequency Response (W, ±db) 50Hz ~ 0kHz 60Hz ~ 0kHz Operating Temperature -0 ~ +40 Operating Power 0VAC, 60Hz, 0-40VAC, 50/60Hz Power Consumption (/8 Power) 0W 50W Weight (SET) 6.kg /.5lb 6.kg /.5lb 6.kg /.7lb 6.kg /.7lb Dimensions (W x H x D) 48 x 88 x 97mm / 9 x.5 x 5.6in Dual Channel DPA-00DO DPA-600DO Rated Output Power (T.H.D 0.%, AES7) 00W x 600W x Peak Power 50W / CH 680W / CH Output Level/Impedance 00V/.Ω, 70V/6.Ω, 49V/8Ω 00V/6.6Ω, 70V/8.Ω, 69.V/8Ω Input Sensitivity V/0kΩ THD (AeS7) Rated Power Less than 0.% / Power Less than 0.0% S/N (0kHz LPF) More than 0dB Frequency Response (W, ±db) 50Hz ~ 0kHz Operating Temperature -0 ~ +40 Operating Power 0VAC, 60Hz, 0-40VAC, 50/60Hz Power Consumption (/8 Power) 0W 50W Weight (SET) 6.7kg / 4.8lb Dimensions (W x H x D) 48 x 88 x 97mm / 9 x.5 x 5.6in Triple / Quad Channel DPA-00TO DPA-00QO Rated Output Power (T.H.D 0.%, AES7) 00W x 00W x 4 Peak Power 50W / CH Output Level/Impedance 00V/.Ω, 70V/6.Ω, 49V/8Ω Input Sensitivity V/0kΩ THD (AeS7) Rated Power Less than 0.% / Power Less than 0.0% S/N (0kHz LPF) More than 0dB Frequency Response (W, ±db) 50Hz ~ 0kHz Operating Temperature -0 ~ +40 Operating Power 0VAC, 60Hz, 0-40VAC, 50/60Hz Power Consumption (/8 Power) 50W Weight (SET) 6.8kg / 5lb 7kg / 5.5lb Dimensions (W x H x D) 48 x 88 x 97mm / 9 x.5 x 5.6in Inter-M Corp. (IMK) 79, Dobong-ro, Dobong-gu, Seoul, Korea Overseas Sales Team Tel_ +8--89-84~7 Fax_ +8--89-849 E-mail_ overseas@inter-m.com www.inter-m.com Design and specification are subject to be changed for the improvement of product quality without pre notice. 05. 6. V