GV60 VALORSTAT PLUS OPERATING INSTRUCTIONS VALORSTAT PLUS GV60 Elctronic Ignition Rmot Control Valor modls using th ValorStat PLUS Rmot Control Portrait 530I Vogu 1300 Horizon 534I Linar L1 1500 Horizon 534J Linar L1 1600 H4 650 Linar L2 1700 H4 650J Madrona MF28I Lgnd f i G3 r 739I - Madrona p MF28J a r t s. c o m Lgnd G3 739J Rtrofi r RF24ID Vntana 1200 Rmot Control Initial St-up Th rcivr and th handst of th rmot control systm must b initially synchronizd bfor th fi rst us. 1. Insrt alkalin battris in th rmot control rcivr or battry box and handst. Th rcivr is locatd nar th control valv. 2. With a sharp objct, prss and hold th rcivr s rst button until you har on short and on long bps. Rlas th rst button aftr th scond bp. 3. Within th subsqunt 20 sconds, prss th small fl am button ( ) on th rmot handst until you har two short bps confi rming th sychronization is st. This is a on tim stting only and is not rquird whn changing th battris in th rmot rcivr. Th rmot control systm is now rady to us. Dcmbr 2014 1
Rmot Control Opration NOTE: Bfor using th rmot control systm for th first tim, th rcivr and th handst must b synchronizd. S th sction Rmot Control Initial St-up on th prvious pag of this manual. IMPORTANT: BEFORE YOU BEGIN, plas not that on this systm, th sttings of tim, tmpratur and automatic ON/OFF can only b programmd whn th function display is flashing. B patint whn programming as it can tak a fw sconds to st. Currnt tmpratur (F or C) Handst snsor Priod start or nd (Tmp, Timr) Currnt programmd priod (Timr) Display Ovrviw Battry status Currnt tim (12 or 24 hour clock) Mods (Manual, Tmpratur, Timr) St (scrolls through mods and sttings) OFF (rturns to st mod, turns th burnr and th pilot off) Not: In th TEMP or TIMER mods, th rmot handst f snss i r th room tmpratur - p and adjusts a th r t s. c o m fl am accordingly. To communicat, th handst should b within 15 ft (4.5 mtrs) of th fi rplac. Do not lav th handst on th mantl or harth. Handst Ovrviw Larg flam button (flams up, sts hours, tmpratur) Small flam button (flams down and off, sts minuts, tmpratur) TO TURN ON APPLIANCE CAUTION Whn pilot ignition is confi rmd, motor turns automatically to maximum fl am hight. On th valv, turn MAN knob on th ON, full countrclockwis position. Plac ON/OFF switch (if quippd) in I (ON position). Simultanously prss th OFF and (larg fl am) buttons until a short bp confi rms th start squnc has bgun; rlas buttons. Continuing bps confi rm th ignition is in procss. Onc pilot ignition is confi rmd, thr is main gas fl ow. Aftr main burnr ignition th handst will automatically go into manual (MAN) control mod. TO TURN OFF APPLIANCE Prss OFF button. FLAME HEIGHT ADJUSTMENT Whn th pilot is off, it will tak 2 minuts Whn th bfor pilot it is can off, b it will lit again. tak 2 minuts bfor it can b lit again. STANDBY MODE (Pilot Flam) Prss and hold (small fl am) to st applianc at pilot fl am. In standby mod: Prss and hold (larg fl am) button to incras fl am hight. 2
Prss and hold (small fl am) button to dcras fl am hight or to st th applianc at pilot fl am. For fi n adjustmnt tap th (larg fl am) or (small fl am) buttons. MODES OF OPERATION Brifl y prssing th SET button changs th mod of opration in th following ordr: MAN TEMP TEMP TIMER and back to MAN. Exprss Low and High Fir Doubl-click (small fl am) button. LO will b displayd. NOTE: Flam gos to high fi r fi rst bfor going to dsignatd low fi r. x 2 NOTE: Manual mod can also b rachd by prssing ithr th (larg fl am) or th (small fl am) buttons. MAN - Manual Mod - Manual Flam Hight Adjustmnt. Doubl-click (larg fl am) f i r button. Flam - automatically p a gos r t s. c o m to high fi r. HI will b displayd. TEMP - Daytim Tmpratur Mod (Applianc must b in x 2 standby mod; pilot ignitd) - Th room tmpratur is masurd and compard to th st tmpratur. Th fl am hight is thn automatically adjustd to achiv th Daytim St SETTING ºC/24-HOUR OR ºF/12-HOUR CLOCK In MAN mod, prss OFF and (small fl am) buttons until display changs from Farnhit/12-hour clock to Clsius/24-hour clock and vic vrsa. SETTING THE TIME Th tim display will fl ash aftr ithr: Installing th battry or Simultanously prssing th (larg fl am) and (small fl am) buttons. Prss (larg fl am) button to st th hour. Prss (small fl am) button to st th minut. Prss OFF or simply wait to rturn to MAN mod. TEMP - Nighttim Stback Tmpratur Mod (Applianc must b in standby mod; pilot ignitd) - Th room tmpratur is masurd and compard to th Nighttim Stback tmpratur. Th fl am hight is thn automatically adjustd to achiv th Nighttim Stback TIMER - Timr Mod (Applianc must b in standby mod; pilot ignitd) - Th timrs P1 and P2 (Program 1, Program 2) ach can b programmd to go ON and OFF at spcifi c tims. For instructions s Timr Programming Mod. NOTE: Th display shows th st tmpratur vry 30 sconds. 3
SETTING THE ON / OFF TEMPERATURES SETTING THE DAYTIME TEMPERATURE SETTING THE NIGHTTIME SETBACK TEMPERATURE Dfault Sttings: TEMP (sun), 23ºC / 74ºF Dfault Sttings: TEMP (moon), -- (OFF) Brifl y prss SET button to scroll to TEMP TEMP (sun) mod. Hold th SET button until th TEMP fl ashs. Brifl y prss SET button to scroll to TEMP TEMP (moon) mod. Hold th SET button until th TEMP fl ashs. Prss (larg fl am) button to incras th Daytim St Prss (larg fl am) button to incras Nighttim Stback f i r - p a r t s. c o m Prss (small flam) button to dcras Daytim St Prss (small fl am) button to dcras Nighttim Stback Prss OFF or simply wait to complt programming. Prss OFF or simply wait to complt programming. Tip St th diffrnt paramtrs whn thy ar fl ashing. 4
SETTING PROGRAM TIMERS You can program two priods of tim btwn 12:00 am and 11:50 pm in ach 24-hour cycl. Th Programs P1 and P2 must b st in th following ordr during a 24-hour cycl: P1, P1, P2 and P2. Th icon indicats th bginning of th priod (ON) and th icon indicats th nd of th priod (OFF). If P1 = P1 or P2 = P2, th programming is canclld. To kp th fi rplac ON all night, st P2 at 11:50 am and P1 at 12:00 am. Dfault sttings: Program 1: P1 6:00 am P1 8:00 am Program 2: P2 11:50 pm P2 11:50 pm SETTING P1 OFF TIME Brifl y prss SET button to scroll to TIMER P1 (moon) whil th tim fl ashs. Prss (larg fl am) button to st th hour. Prss (small fl am) button to Brifl y prss SET button to scroll to st th minuts. f i r TIMER mod. - p a r t s. c o m SETTING P1 ON TIME Hold th SET button until P1 (sun) is displayd and th tim fl ashs. Prss (larg fl am) button to st th hour. SETTING P2 ON TIME Brifl y prss SET to scroll to TIMER mod P2 (sun) whil th tim fl ashs. Follow th instructions givn to st P1 ON tim. SETTING P2 OFF TIME Brifl y prss SET to scroll to TIMER mod P2 (moon) whil th tim fl ashs. Follow th instructions givn to st P1 OFF tim. Prss OFF button to sav ths sttings. Th timrs ar programmd. S th diagram on programming squncs on th following pag. Prss (small fl am) button to st th minuts. Tip If you want to program only on priod, program P1 and P1 with dsird tims and program P2 and P2 with th sam tim as P1. 5
Timr Programming Exampl (dfault tmpraturs shown) 6:00 a.m. P1 Start tim 8:00 a.m. P1 End tim 4:00 p.m. P2 Start tim 10:00 p.m. P2 End tim St tmp 74 F St tmp 40 F St tmp 74 F St tmp 40 F 6:00 a.m. P1 Start tim AUTOMATIC TURN DOWN LOW BATTERY INDICATION No communication. If thr is no communication btwn th rcivr and th handst for a priod of CAUTION 6 hours, th applianc gos into pilot mod. DO NOT USE a scrwdrivr or othr mtallic objct No chang in flam hight. If thr is no chang to rmov th battris from th battry box or th in flam hight for a priod of 6 hours, th applianc handst! This could caus a short circuit. gos f into i pilot r mod. - p a r t s. c o m NOTE: In TEMP or TIMER mods, th fl am hight Rmot handst: Th battry icon will show will vary according to room tmpratur. Th applianc will continu to work normally. Howvr, if th whn th battry nds to b rplacd. Rplac with on 9 V alkalin battry. room tmpratur rmains th sam for 6 hours, th Rcivr and battry box: Thr short bps will applianc will go into pilot mod. sound whn th motor turns whn th battris nd to b rplacd. Rplac with four 1.5 V alkalin battris. AUTOMATIC SHUT OFF Low battris in th rcivr. With low battry powr in th rcivr th systm shuts off compltly. NOTE: This dos not apply whn th powr supply is intrruptd. No chang in pilot. Th applianc shuts off compltly whn it is continually in pilot position without any chang for a priod of 5 days. HANDSET / RECEIVER MATCH Th rmot control handst and rcivr ar programmd to function togthr. In cas of a rplacmnt of th handst or th rcivr, you will nd to rst th rcivr to allow thm to function togthr. Contact your dalr for dtails. Bcaus our policy is on of constant dvlopmnt and improvmnt, dtails may vary slightly from thos givn in this publication. 6 Mils Industris Ltd. 190 2255 Dollarton Highway, North Vancouvr, BC, CANADA V7H 3B1 Tl. 604-984-3496 Fax 604-984-0246 www.valorfirplacs.com