Dual Operational Amplifiers JAN. Product Description The consists of two independent, high gain, internally frequency compensated operational amplifiers which were designed specifically to operate from a single power supply over a wide range of voltages. Operation from split power supplies is also possible and the low power supply current drains in independent of the magnitude of the power supply voltage. Application areas include transducer amplifiers, dc gain blocks and all the conventional op amp circuits, which now can be more easily implemented in single power supply systems. For example, the can be directly operated off of the standard +5 power supply voltage which is used in digital systems and will easily provide the required interface electronics without requiring the additional ±5 power supplies. Features Wide range of supply voltages to 6 Low supply current drain independent of supply voltage.7ma (TYP.) Low input biasing current Low input offset voltage and offset current Input common-mode voltage range includes ground Differential input voltage range equal to the power supply voltage DC voltage gain: /m TYP. Internally frequency compensation RoHS Compliant, %Pb & Halogen Free Block Diagram CC INERTING INPUT NON-INERTING INPUT OUTPUT
Pin Assignments OUTPUT A 8 CC INERTING INPUT A NON-INERTING INPUT A A B - + + - 7 6 OUTPUT B INERTING INPUT B GND 4 5 NON-INERTING INPUT B TOP IEW Ordering Information Device PF SF Package DIP-8 SOP-8 Marking Information
Absolute Maximum Ratings Symbol Parameter alue Unit CC Single Supply 4 CC, EE Split Supply ± IDR Input Differential oltage Range ±4 I OS Output Short-circuit to GND Continuous T J Junction Temperature 5 ºC T STG Storage Temperature Range -65 to +5 ºC T A Operating Ambient Temperature Range -4 to 85 ºC θ JA Thermal Resistance ( Junction to Ambient ) DIP-8 5 ºC/W SOP-8 6 θ JC Thermal Resistance ( Junction to Case ) DIP-8 4 ºC/W SOP-8 ESD ESD Rating (HBM) K
Electrical Characteristics at specified free-air temperature, CC =5 (Unless Otherwise Noted) Symbol Parameter Test Conditions* Min Typ Max Unit IO α IO I IO αi IO Input offset voltage Average temperature coefficient of input offset voltage Input offset current Average temperature coefficient of input offset current CC =5 to Max. 5ºC 7 IC = ICR min, o =.4 Full range 9 o =.4 I IB Input bias current o =.4 ICR OH OL A D CMRR K SR O / O Io I OS I CC Common-mode input voltage ange High-level output voltage Low-level output voltage Large-signal differential voltage amplification Common-mode rejection ratio Supply voltage rejection ratio (Δ CC /Δ IO ) Crosstalk attenuation Output current Short-circuit output current Supply current (two amplifiers) CC = 5 to MAX m Full range 7 μ/ºc 5ºC 5 Full range 5 na Full range pa/ºc 5ºC 5 Full range 5 5ºC to cc-.5 Full range to CC - R L = kω 5ºC CC -.5 CC = MAX, R L = kω CC = MAX, R L = kω Full range 6 Full range 7 8 R L = kω Full range 5 m CC = 5 5ºC 5 o= to R L =kω Full range 5 CC = 5 to MAX IC = ICR min na /m 5ºC 65 8 db CC = 5 to MAX 5ºC 65 db f = k to k (Hz) 5ºC db CC = 5, 5ºC - - ID =, o = Full range - CC = 5 5ºC ID = -, o = 5 Full range 5 ID = -, o = m CC at 5, GND at 5, o = o =.5, No load CC = MAX, o =.5cc, No load ma 5ºC μa 5ºC ±4 ±6 ma Full range.7. Full range *All characteristics are measured under open-loop conditions with zero common-mode input voltage unless otherwise specified. MAX CC for testing Purposes is. Full range is -4ºC to 85ºC ma 4
Typical Performance Characteristics IN-INPUT OLTAGE( DC) 5 5 Input oltage Range NEGATIE POSITIE 5 5 OR -POWER SUPPLY OLATAGE( DC) Supply Current IB - INPUT CURRENT(nADC) Input Current 9 8 CM =DC 7 6 =DC 5 4 =5DC =5DC -55-5 -5 5 5 45 65 85 5 5 TA - TEMPERATURE( C) C oltage Gain ID- SUPPLY CURRENT DRAIN(mADC) DC) 4 ma ID TA = C C TO +5 C C TA =-55 CC -SUPPLY OLTAGE(DC) AOL-OLTAGE GAIN(dB) 6 8 4 RL=KΩ RL=K RL=K RL=KΩ -SUPPLY OLTAGE(DC) 4 Open Loop Frequency Response Common Mode Rejection Ratio AOL-OLTAGE GAIN(dB) 6 8 6 4. F IN / = TO 5 DC -55 C TA +5 C C M O. K K K M M f -FREQUENCY(Hz) =DC -55 C TA +5 C C C CMRR-COMMON MODE REJECTION RATION(dB) 8 6 4 K K +5 Ω O K BUFFER K -5 K K K M f -FREQUENCY(Hz) 5
Typical Performance Characteristics (Continue) oltage Follower Pulse Response oltage Follower Pulse Response(Small Signal) OUTPUT OLTAGE OUT() INPUT OLTAGE IN() 4 t - TIME( s) RL.K.KΩ =5DC 4 eo-output OLTAGE(mA) 5 45 4 5 5 ein OUTPUT eo 5pF INTPUT =+DC TA=5 C 4 5 6 7 t - TIME( s) 8 Large Signal Frequency Response Output Characteristics Current Sourcing O- OUTPUT SWING(P-P) 5 5 K K 5DC IN 7DC O K =OUTPUT OLTAGE REFERENCED TO (DC) 8 7 6 5 4 / IO INDEPENDENT OF TA=5 C K K K f -FREQUENCY(Hz) M... IO- OUTPUT SOURCE CURRENT(mADC) Output Characteristics Current Sinking Current Limiting O-OUTPUT OLTAGE( OLTAGE(mDC). =5DC =5DC =DC / IO O T A=5 C C.... IO -OUTPUT SINK CURRENT(mADC) IO- OUTPUT CURRENT(mA (madc) 9 8 7 6 5 4-55 IO -5-5 5 5 45 65 85 5 TA - TEMPERATURE( C) C 5 6
Package Dimension SOP-8 PLASTIC PACKAGE D θ E E/ E/ E θ R R GAUGE PLANE PIN MARKING e b θ h θ L A A c A SYMBOL Dimensions Millimeters Inches MIN MAX MIN MAX A.5.75.5.69 A..5.4. A.5.65.49.65 b..5.. b.8.48..9 c.7.5.7. D 4.9 (TYP).9 (TYP) E 6. (TYP).6 (TYP) E.9 (TYP).54 (TYP) e.7 (TYP).5 (TYP) L.4.7.6.5 L.4 (TYP).4 (TYP) L.5 (TYP). (TYP) R.7 -. - R.7 -. - h.5.5.. θ 8 8 θ 5 5 5 5 θ - - 7
DIP-8 PLASTIC PACKAGE E / e G GAUGE PLANE PIN MARKING E c b ec D A E BASE PLANE A A SEATING PLANE L D / LEAD 4 PLACES e b ea eb b SYMBOL Dimensions Millimeters Inches MIN MAX MIN MAX A - 5. -. A.8 -.5 - A.9 4.95.5.95 b.6.56.4. b.4.78.45.7 b.76.4..45 c..6.8.4 D 9..6.55.4 D. -.5 - E 7.6 8.6..5 E 6. 7..4.8 e.54 (TYP). (TYP) ea 7.6 (TYP). (TYP) eb -.9 -.4 ec..5..6 L.9.8.5.5 G.8 (TYP).5 (TYP) 8
Additional Information : 한국대리점 : 디웰전자 (Diwell Electronics Co., Ltd.) 경기도군포시당정동 58 군포창업보육센터 호, Kunpo Business Incubator Center, 58, Dangjung-Dong, Gunpo-City, Gyeonggi-Do, South Korea Phone : 7-85-8 (+8-7-85-8) Fax : -49-8 (+8--49-8) 기술및구매문의 email : expoeb@diwell.com, dsjeong@diwell.com