Time over Fiber interfacility link systems 1 PPS CW/SINE STANDARDS IRIG GPS STABLE GROUP DELAY LOW ALLAN VARIANCE DUAL REDUNDANT POWER SUPPLIES FULLY HOT-SWAPPABLE UP TO SIX LINK MODULES PER 1RU RACK MULTIPLE BUFFERED OUTPUTS CUSTOMIZABLE IFL PLATFORM Linear Photonics Time-over-Fiber (ToF) products provide point-to-point and point-to-multipoint interfacility time standard distribution over single mode fiber. Single mode fiber offers the advantage of very low loss and stable group delay over very long distances. At the master site, choose from IRIG, 1 PPS, CW/Sine or GPS input protocols. Fiber Transmitter modules convert the electrical time signal standard to an intensity-modulated laser optical output. Choose from single or multiple fiber outputs for distribution to remote sites. At the remote site, the Fiber Receiver module converts the optical signal back to the electrical protocol while buffering the signal for directly driving single or multiple time devices. Master Clock Sine / CW 1 PPS IRIG LP IFL Rack single-mode fiber LP IFL Rack LOCAL GPS REMOTE LP IFL Rack REMOTE
TimeLink time-over-fiber link modules > 10 km LINK LENGTH EMI IMMUNITY ULTRA-WIDEBAND FREQUENCY RESPONSE LOW NOISE HIGH STABILITY LPL TimeLink products provide precise time distribution over optical fiber. All Optical Transmitters employ low noise Distributed Feedback (DFB) single-mode lasers and single mode optical fiber. All optical receivers employ InGaAs PIN photodiodes. These features combine to provide greater link length and frequency response, lower noise and higher stability than multimode optical or copper-based solutions. Links accept standard protocol IRIG, 1 PPS, CW/Sine (1-100 MHz) and GPS inputs. Point-to-point and point-to-multipoint options are available. IRIG Links incorporate Automatic Level Control to provide 0 db Linear gain independent of link loss. All standard and custom modules are available as hot-swappable Standard LPL IFL Plug-ins.
TimeLink LINK PERFORMANCE Transmitter Signal Input model type: 1 PPS 1 PPS Standard TTL / 50 Ω IRIG IRIG Standard 6 V modulated sine / 50 Ω CW/Sine 1-100 MHz / 50 Ω / -50 to 0 dbm GPS/L-Band 1000-2000 MHz / 50 Ω / -50 to 0 dbm Signal Input Connector SMA or BNC Optical Output Connector Single Mode FC/APC or LC/PC Optical Wavelength 1550 nm (standard) Number of Outputs CW/Sine and GPS/L-Band single output 1 PPS and IRIG 1, 2 or 4 outputs Module Size Single Output Single-Wide IFL Plug-in 2 or 4 Outputs Double-wide IFL Plug-in Alarm Indictator GRN: Operational RED: Laser Fault Receiver Optical Input Connector Single Mode FC/APC or LC/PC Signal Output model type: 1 PPS 1 PPS Standard TTL / 50 Ω IRIG IRIG Standard 6 V modulated sine / 50 Ω CW/Sine 1-100 MHz GPS/L-Band 1000-2000 MHz Signal Output Connector SMA or BNC Number of Outputs CW/Sine and GPS/L-Band single output 1 PPS and IRIG 1, 2 or 4 outputs Module Size Single Output Single-Wide IFL Plug-in 2 or 4 Outputs Double-wide IFL Plug-in Alarm Indicator GRN: Operational RED: Low/No Optical Input End-to-End Link Gain 1 PPS Fixed Output 1 PPS regenerated (< 2 ns rise time) IRIG Fixed Output IRIG Linear Transfer with ALC CW/Sine and GPS/L-Band Linear Transfer 0 db Gain with 1 km fiber Group Delay Variation +500 fs/ C typical Environmental Operating Temp Range 0 to 50 C Link Length 0 to 10 km 1E-10 1E-11 Allan Deviation τo= 1 ms LP DiLink 1E-12 1E-13 1E-14 1E-15 1E-16 0.001 0.01 0.1 1 10 100 Averaging Time (seconds) Pulsed Group Delay vs Temperature HF CW/Sine Link Modules System Allan Variance HF CW/Sine Link Modules
PEM PF 440-1- 1 4-40 Hole. 219" LINEAR PHOTONICS PEM PF11-1 4-40 Hol e.219" 02043 24 PEM PF 40-11- 1 4-40 Hole. 219" Dialigh t58 Series.156".062th 2402 mountin ickma 2x ghole PEM PF11-1 4-40 Hol e.219" PEM PF440-11- 1 4-40 Hole. 219" LINEAR PHOTONICS 2 043 402 2 43 4020 2 4 0204 3 2 2043 40 PEM PF11-1 4-40 Hol e. 219" PEM PF11-1 4-40 H ole.219" Dia light5 58Se ries.15 6"mo unting hole PEM PF440-11- 1 4-40 Hole. 219" TimeLink PART NUMBER INFORMATION Custom options are available. Call LPL. T L m p n r o m Module Type T Transmitter R Receiver example: TLTP2SL p Protocol Transmitter P 1 PPS 1 PPS Protocol R IRIG Dual Optical Outputs H HF, 1-100 MHz SMA RF Input L GPS/L-Band, 1000-2000 MHz LC/PC Optical Outputs n Number of Outputs 1 Single Output, Single-wide 2 Dual Output, Double-wide * 4 Quad Output, Double-wide * r S B RF Connector(s) SMA BNC o Optical Connector(s) F FC/APC L LC/PC * Multiple outputs are only availble A LC/APC on 1 PPS and IRIG models TimeLink SINGLE-WIDE PLUG-IN 2.36 TimeLink DOUBLE-WIDE PLUG-IN 5.16 9.06 9.06 1.66 2.78 RF In DILINK Transmitter Status Opt Out RF Out 5.6 Receiver Opt In Status 1.7
PE M PF1 1-1 4-4 0 Hol e.219" P EM P F11-1 4-40 Hole.21 9" PE M PF1 1-1 4-4 0 Hol e.219" Schurter 6200.4325 PEM PF4 40-11-1 4-40 H ole.219" PEM PF4 40-11-1 4-40 H ole.219" P EM P F11-1 4-40 Hole.21 9" PE M P F1 1-1 4-4 0 Hol e.2 19" PEM PF4 40-11-1 4-40 H ole.219" PEM PF4 40-11-1 4-40 H ole.219" PE M P F1 1-1 4-4 0 Hol e.2 19" P EM PF 11-1 4-40 Ho le.21 9" Schurter 6200.---- P E M PF 1-1 4-40 H o le.2 19 " PE M P F1 1-1 4-4 0 H ol e. 21 9" PE M PF 4 0-1 -1 4-40 H ole.21 9" PE M PF 4 0-1 -1 4-40 H ole.2 19" P EM P F4 40-1 1-1 4-4 0H ol e.2 19 " P EM P F4 40-1 1-1 4-4 0 Ho le. 219 " PE M PF 4 0-1 -1 4-40 H ole.21 9" PE M PF 4 0-1 -1 4-40 H ole.21 9" P EM P F4 40-1 1-1 4-4 0H ol e.2 19 " P EM P F4 40-1 1-1 4-4 0 Ho le. 219 " PE M PF 4 0-1 1-1 4-40 Ho le.21 9" PE M PF 4 0-1 -1 4-40 H ole.21 9" P EM P F4 40-1 -1 4-4 0H ole.2 19 " P EM P F4 40-1 1-1 4-4 0H ol e.2 19 " Schurter 6200.4325 P EM PF 11-1 4-40 Ho le.21 9" Schurter 6200.---- IFL-RACK system platform DUAL REDUNDANT POWER SUPPLIES FULLY HOT-SWAPPABLE UP TO SIX SINGLE-WIDE MODULES IN 1RU PE M P F1 1-1 4-4 0 Ho le.2 1 9" P EM P F 1-1 4-4 0 H o le.2 19 " 17.67 IFL RACK CHASSIS SPECIFICATION AC Input 95-260 V 50/60 Hz 2 A fused Dimensions w x l x h inch(cm) 18.9 x 18.75 x 1.7 (7.5 x 7.4 x 1.7) Front Panel Indicators Right/Left Power Supply LEDs Empty Weight 12 lbs including dual power supplies Capacity 6 single-wide slots 18.02 IFL RACK FRONT LEFT PWR SUPPLY STATUS 18.95 18.35 RIGHT PWR SUPPLY STATUS 1.25 1.72 IFL RACK REAR WITH POWER SUPPLIES FUSE 17.67 FUSE 1.63 STATUS STATUS
PEM PF11-1 4-40 Hole.219" PEM PF11-1 4-40 Hole.219" P E M PF 11-1 4-40 Ho le.2 19 " P E M PF 11-1 4-40 Ho le.2 19 " P E M PF 11-1 4-40 Ho le.2 19 " Schurter 6200.4325 P E M PF 11-1 4-40 Ho le.2 19 " IFL-PS IFL power supply IFL Power Supplies provide prime power for all IFL Rack equipment and plug-in modules. Each Power Supply is designed to provide power for full capacity to the rack. Two supplies can be installed, providing automatic redundant backup in case of failure. IFL-PS SPECIFICATION AC Input AC Line Fuse STATUS LED Power 95-260 V 50/60 Hz 2 A fused 5x20 mm 2A T-LAG Dual Color (RED=ALARM, GREEN=OK) 50 Watts at full rack capacity 5.42 6.05 6.50 CAUTION: Remove power cord before removing module LINEAR PHOTONICS 6.50 FUSE 5x20 Power Supply Module 2A T-LAG Status 1.61