Technical Application Guide for UP-SHINE LED Panel Light UP-PLX-W UP-PLX-WD
Introduction Up-shine LED troffer adopts LM- SMD led chip, with UL&cUL, DLC approved for North America market. 1X, X, X sizes are available for various demand. Branded led driver with top quality component ensures long life time. -1V dimmable and nondimmable version both provided. The ultra slim profile fits seamlessly into any workplace. It is available in the following installation ways: embedded into ceiling, suspended with hanging wires. Up to % energy saving compared to standard CFL Long lifetime of 5, hours -1V dimmable 1 wide beam angle CCT: 7K 3K K 5K No UV/IR light Environment friendly, without Mercury or any other hazardous substances Application notes IP for indoor use Professional electrician for installation only Switch off before installation Do not touch when in use Keep away from hot steam and corrosive gas Application Areas Widely used for various commercial lighting and residential lighting applications, such as offices, shopping mall, hotel, restaurant, hospital, home lighting etc. Certificates TM
Product Information 113 117 3 557 1 3.5 5 Technical Specifications Model Voltage Power Power Factor Lumen (±5%) Beam angle CCT Lifespan CRI Dimmable Dimension UP-PLX-W AC1-77V W.9 1 o 7K 5h No 113*3*1mm UP-PLX-W AC1-77V W.9 1 o 3K 5h No 113*3*1mm UP-PLX-W AC1-77V W.9 1 1 o K 5h No 113*3*1mm UP-PLX-W AC1-77V W.9 17 1 o 5K 5h No 113*3*1mm UP-PLX-WD AC1-77V W.9 1 o 7K 5h Yes 113*3*1mm UP-PLX-WD AC1-77V W.9 1 o 3K 5h Yes 113*3*1mm UP-PLX-WD AC1-77V W.9 33 1 o K 5h Yes 113*3*1mm UP-PLX-WD AC1-77V W.9 37 1 o 5K 5h Yes 113*3*1mm Driver data Sheet Fixture Compatibility Rated Wattage Driver data DIM Non-dim Input rated Voltage AC1-77V AC1-77V Frequency 5/Hz 5/Hz Input Voltage AC9-35V AC9-35V Efficiency 5% 5% Total load Wattage 57W±5% 57W±5% Power Factor.9.9 Rated input current.7a.7a Full load output Voltage DC35-3V DC35-3V Rated output current 1mA 1mA Output current range 1mA±5% 1mA±5% Power tolerance ±5% ±5% Current output tolerance ±5% ±5% Dimming range 1%-1% Dimmer V-1V dimmer Short circuit protection PASS PASS Over voltage protection PASS PASS Over temperature protection PASS PASS Withstand voltage AC375V AC375V Electrical Classification Ingress Protection Operating Temp Operating Humidity Storage Temp W Ⅱ IP - o C~5 o C ~9% - o C~5 o C
Spectral Distribution 7K 3K. Max=533 [1.=] 3.5SDCM F7K. Max=1 [1.=] 5.5SDCM F3K.7.7...5..3 x=. y=.9.5..3 x=.3 y=.379...1.1. 3 5 7. 3 5 7 K 5K. Max=7171 [1.=].1SDCM FK. Max=9 [1.=].5SDCM F5K.7.7...5..3 x=.31 y=.31.5..3 x=.373 y=.35...1.1. 3 5 7. 3 5 7 Photometric Diagram 7K 3K -1-9 -/+ 1 9 1 1 MH=1m C/ C9/7 Flux out: 195 lm 3.1ft.3, 91.57fc 1m., 9lx.5ft.1, 1.5fc m.3, 5.lx 1.13ft 37.5cm 1.53ft 5.7cm -1-9 -/+ 1 9 1 1 MH=1m C/ C9/7 Flux out: 3759 lm 3.1ft 5.5, 17.9fc 1m 55.1, 7lx.5ft 13.13, 1.97fc m 11.3, 51.7lx 9.9ft 9.3cm.99ft 57.cm 1 1 9.3ft.77, 1.fc 3m 1.57, 15.lx 3.ft 131.9cm 1 1 9.3ft 5.3,.5fc 3m.79,.lx.9ft.cm 1 1 1 13.1ft 1.55, 5.fc m 1.3, 3.35lx.7ft 13.cm 1 13.1ft 3.1, 1.9fc m 3.3, 11.9lx 37.9ft 1157.71cm -3 3 AVERAGE BEAM ANGLE(5%): 113.1 DEG -5 - -15-1 -5 5 1 15 5 1.ft.99, 3.77fc 5.33ft 5m 1.5,.55lx 1.5cm Height Eavg, Emax Angle: 11.7deg Diameter -3 3 AVERAGE BEAM ANGLE(5%): 111.5 DEG -5 - -15-1 -5 5 1 15 5 1.ft.1,.715fc 7.ft 5m.1, 7.lx 17.1cm Height Eavg, Emax Angle: 11.71deg Diameter K 5K -1-9 -/+ 1 9 1 1 MH=1m C/ C9/7 Flux out: 5 lm 3.1ft.5, 9.7fc 1m.1, 1lx.5ft.1,.5fc m.3, 3.lx 1.7ft 357.3cm.13ft 75.cm -1-9 -/+ 1 9 1 1 MH=1m C/ C9/7 Flux out: 37 lm 3.1ft 5.3, 97.7fc 1m.1, 11lx.5ft.51, 3.7fc m.51, 3.lx 13.57ft 3.3cm.53ft 77.cm 1 1 9.3ft.777, 1.7fc 3m.57, 15.lx 3.ft 111.cm 1 1 9.3ft.57, 1.7fc 3m.57, 1.lx 33.ft 1.9cm 1 1 1 13.1ft 1.55, 5.fc m 1., 1.35lx 1.5ft 1353.cm 1 13.1ft 1.55, 5.fc m 1.3, 3.35lx.3ft 135.cm -3 3 AVERAGE BEAM ANGLE(5%): 113.1 DEG -5 - -15-1 -5 5 1 15 5 1.ft.959, 3.77fc 55.3ft 5m 1.5,.7lx 173.1cm Height Eavg, Emax Angle: 1.3deg Diameter -3 3 AVERAGE BEAM ANGLE(5%): 113. DEG -5 - -15-1 -5 5 1 15 5 1.ft.97, 3.53fc 5.33ft 5m 11.5, 1.5lx 13.7cm Height Eavg, Emax Angle: 119.9deg Diameter
Polar Diagram Comparison -15 O +/- O 15 O -1 O 1 O -9 O 9 O - O 1 O 1-3 O 3 O O AVERAGE BEAM ANGLE (5%): 113.1DEG C/, 11.7 deg C3/1, 111.5 deg C/, 11.3 deg C9/7, 115. deg Driver lifetime & LED light decay rate Driver Lifetime LED Light Decay Rate 9 11%. Lifetime (hours) 7 5 3 1 5 o C 75 o C 5 o C 95 o C 15 o C Capacitor Tc ( o C) % Luminous Flux 15% 1% 95% 9% 5%.35.3.5..15 % 75% FLUX.1.5 U'V' 7%. 1 3 5 7 9 1 LifeTime (hours) Temperature The testing is operated at 5 C The lifetime of capacitor, minimum of 5, hours if operated at 15 C, will be doubled whenever the temperature drops 1 C The highest withstand temperature of IC, MOS could be 1 C The highest withstand temperature of LED junction temperature is 15 C Temperature ( o C) 7 5 3 1 1:9: 15::1 1:11:1 17::1 17:53:1 ::1 19:35:1 ::1 1:17:1 ::1 :59:1 3:5:1 :1:1 1:3:1 :3:1 3:1:1 :5:1 :5:1 5:7:1 :3:1 7:9:1 ::1 Time The driver lifespan is based on capacitor working temperature. IC Capacitor MOS PCB Fitting Voltage transformer Environmental temperature
Installation 1.Recessed into ceiling 1. Remove ceiling plaster slab. Connect power supply 3. Fix the panel light into right place. Stabilize the panel. Suspending 1. A.Fix the anchor into target place on the ceiling B.Fix the installation mount on the ceiling with plastic anchor. Hang the panel to ceiling with suspended installation kits 3. Adjust the length of steel wire. Connect the power supply X X 3. Surface mounted 1. Unpack box and take out aluminum profile A - pcs, aluminum profile B - pcs, as well as accessory pack.. Assembling 3 pieces aluminum profile together with screw. 3. Fix semi-finished frame onto ceiling with screw(concrete ceiling requires plastic anchor). Slide panel into frame properly. 5. Fix the last piece of aluminum profile with screw after panel is well placed. Packaging Information SIZE(CM) N.W/pc (KGS) G.W.(KGS) Q'TY(PCS) Carton 1*1*7.5 9..5 '' standard container '' standard container CTNS Q'TY(PCS) VOLUME(CBM) 5 Phone: + 755 919 739 Add: nd building Dingfeng High-Tech Zone, Fuyuan 1st road, Fu Yong Sub-district, Bao'an, Shenzhen China