SCHEMATIC W W Allegro Logo Date: //0 Sheet of File: C:\altium\..\LPRev.SchDoc Drawn By: Bob Pickett A Size Number Revision 8-087-000-SCH Title D LP D Shunt SEL B SEL B PWMPin R k HA+ HA+ PWM/VSP PWM HA- JP R.99k HB- HB+ HA- SEL HB+ OUTA HC- HC+ HB- OUTA 7 HC+ GND 8 OUTB HC- OUTB CN 7 0 PHA PHA OUTC 8 9 VBB VBB OUTC CN C Shunt C U 0.uF 0uF PHA CN JP GND C C HRET HC- HC+ 7 HB- 8 HB+ 9 HA- 0 HA+ HBIAS GND 7 SLUG J A VBB A VBB SEL D Do not install CN PHA -DB
LAYOUT Northeast Cutoff Worcester, Massachusetts 0-00 U.S.A..08.8.000; www.allegromicro.com
LAYOUT Northeast Cutoff Worcester, Massachusetts 0-00 U.S.A..08.8.000; www.allegromicro.com
LAYOUT Northeast Cutoff Worcester, Massachusetts 0-00 U.S.A..08.8.000; www.allegromicro.com
BILL OF MATERIALS BOARD,DEMO,LP 8-087-000-BOM Rev. All Devices MUST be ROHS Compliant Page of Bill of Materials //0 Item Quantity Designator value Description PartType Footprint C 0uF 0V Capacitor Taiyo Yuden UMKBJ0KM-T; 0 Digikey 87-7--ND C 0.uF V Capacitor TDK C0X7RCK; Digikey - 080 --ND 7 CN, CN, J -Pin.mm spaced connector, -Pin Screw On Shore ED/DS; Digikey -Pin.mm connector, - Down Terminal Block (Use -pin connectors), ED-ND Use -Pin Connectors Pin.mm Screw Down Connector, 8-Pin.mm Connector CN -pin mm Spaced Single Row Header Sullins NRPNPAEN-RC; Digikey NRPNPAEN-RC S800--ND CN On Shore ED0/DS; Digikey -pin screw down connector ED0-ND D TVS Zener Do not install DO-AA 7, HA+, HA-, HB+, HB-, HC+, HC-, OUTA, OUTB, OUTC, PHA, PWM, PWMPin, SEL, VBB, Mini Test Point Keystone 000; Digikey 000K-ND Mini Test Point 8 Bumpon Foot M SJ-0 (CLEAR); Digikey SJ0- Bumpon Foot 7-ND 9 Pins JP, JP Cut pins from 0-pin strip Samtec TSW-0-07-T-S; Digikey -pos. shunt SAM0-0-ND 0 pcb 8-087-00 Rev. R.99k /8W Resistor Panasonic ERJ-ENF99V; Digikey 080 P.99KCCT-ND R k /8W Resistor Panasonic ERJ-GEYJ0V; Digikey 080 P.0KACT-ND shunts for JP and JP M 990-0000-DA; Digikey M980- ND U -Phase Fan Driver xlp-t -pin_lp W, W Gauge Buss Wire (00mils above pcb) Scope Ground Northeast Cutoff Worcester, Massachusetts 0-00 U.S.A..08.8.000; www.allegromicro.com
Revision History Number Date Description August, 0 Initial release Copyright 0, reserves the right to make, from time to time, such departures from the detail specifications as may be required to permit improvements in the performance, reliability, or manufacturability of its products. Before placing an order, the user is cautioned to verify that the information being relied upon is current. Allegro s products are not to be used in any devices or systems, including but not limited to life support devices or systems, in which a failure of Allegro s product can reasonably be expected to cause bodily harm. The information included herein is believed to be accurate and reliable. However, assumes no responsibility for its use; nor for any infringement of patents or other rights of third parties which may result from its use. For the latest version of this document, visit our website: www.allegromicro.com Northeast Cutoff Worcester, Massachusetts 0-00 U.S.A..08.8.000; www.allegromicro.com