Product escription The SGA- is a high performance SiGe HBT MMIC Amplifier. A arlington configuration featuring 1 micron emitters provides high FT and excellent thermal perfomance. The heterojunction increases breakdown voltage and minimizes leakage current between junctions. Cancellation of emitter junction non-linearities results in higher suppression of intermodulation products. Only 2 C-blocking capacitors, a bias resistor and an optional F choke are required for operation. The matte tin finish on Sirenza s lead-free package utilizes a post annealing process to mitigate tin whisker formation and is ohs compliant per EU irective /95. This package is also manufactured with green molding compounds that contain no antimony trioxide nor halogenated fire retardants. Gain () 24 12 Gain & vs. Freq. @ = GAIN 1 2 4 5-1 -2 - -4 () SGA- SGA-Z Pb C-5, Cascadable SiGe HBT MMIC Amplifier ohs Compliant & Green Package Product Features Now available in Lead Free, ohs Compliant, & Green Packaging High Gain : 1.8 at 195 Cascadable 5 Ohm Operates From Single Supply Low Thermal esistance Package Applications PA river Amplifier Cellular, PCS, GSM, UMTS IF Amplifier Wireless ata, Satellite Symbol G Small Signal Gain P 1 Power at 1 Compression OIP Third Order Intercept Point B andwidth etermined by (>1) Input Units m m F requency M in. T yp. 85 195 24 85 195 85 195 1.2 14. 7 1.5 1.2 7.5.1 2.2. 5 195 17. 1.2 195 25. NF Noise Figure 195. 5 V evice Operating Voltage V 1. 9 2. 2 2. 5 I evice Operating Current ma 17 2 2 TH, j-l Thermal esistance (junction to lead) Test Conditions: The information provided herein is believed to be reliable at press time. Sirenza Microdevices assumes no responsibility for inaccuracies or omissions. Sirenza Microdevices assumes no responsibility for the use of this information, and all such information shall be entirely at the user s own risk. Prices and specifications are subject to change without notice. No patent rights or licenses to any of the circuits described herein are implied or granted to any third party. Sirenza Microdevices does not authorize or warrant any Sirenza Microdevices product for use in life-support devices and/or systems. Copyright 21 Sirenza Microdevices, Inc.. All worldwide rights reserved. Technology Court, Broomfield, CO 821 Phone: (8) SMI-MMIC http://www.sirenza.com 1 C/ W 255 = 5 V I = 2 ma Typ. OIP Tone Spacing = 1, Pout per tone = -1 m = 14 Ohms = 25ºC Z S = Z L = 5 Ohms ES-12 ev E
SGA- C-5 Cascadable MMIC Amplifier Typical F Performance at Key Operating Frequencies Frequency Frequency () () Symbol Unit 1 5 85 195 24 5 G Small Signal Gain 14. 9 14. 7 1. 5 1. 2 OIP Third Order Intercept Point m 2. 4 2. 2. 1. 9 P 1 Power at 1 Compression m 7. 7. 5. 1 5. 4 Input 21. 21. 5 19. 17. 17. 2 15. 24. 1 2. 27. 8 25. 2. 4 2. 7 S 12 everse Isolation 17. 8. 5. 7 19. 1 19. 2 19. 2 NF Noise Figure.. 2. 5 4. Test Conditions: = 85 V I = 8 2 ma Typ. OIP Tone Spacing = 1, Pout per tone = -1 m m = 9 14 Ohms = 25ºC Z S = Z L = 5 Ohms Noise Figure () 5 4 2 1 Noise Figure vs. Frequency V = 2.2 V, I = 2 ma.5 1 1.5 2 2.5 Absolute Maximum atings evice Current evice Absolute Limit ( I ) 4 ma Voltage ( V ) 4 V F Input Power + m Junction Temp. ( T ) + 15 C J Operating Temp. ange ( T ) -4 C to +85 C L S torage Temp. +15 C Operation of this device beyond any one of these limits may cause permanent damage. For reliable continous operation, the device voltage and current must not exceed the maximum operating values specified in the table on page one. Bias conditions should also satisfy the following expression: I V < ( T - T ) /, j-l J L TH OIP vs. Frequency V = 2.2 V, I = 2 ma P 1 vs. Frequency V = 2.2 V, I = 2 ma 1 25 8 OIP (m) 2 15 1.5 1 1.5 2 2.5 P1 (m) 4 2.5 1 1.5 2 2.5 Technology Court, Broomfield, CO 821 Phone: (8) SMI-MMIC http://www.sirenza.com 2 ES-12 ev E
SGA- C-5 Cascadable MMIC Amplifier Typical F Performance Over Temperature ( Bias: V = 2.2 V, I = 2 ma (Typ.) ) 24 S 21 S 11-1 S21() 12 S11() -2 - -4 C -4 1 2 4 5-4 C 1 2 4 5-1 S 12 S -15-1 S12() -2 S() -2-25 - 1 2 4 5-4 C - -4-4 C 1 2 4 5 NOTE: Full S-parameter data available at www.sirenza.com Technology Court, Broomfield, CO 821 Phone: (8) SMI-MMIC http://www.sirenza.com ES-12 ev E
A SGA- C-5 Cascadable MMIC Amplifier Basic Application Circuit Application Circuit Element Values F in 1 uf 1 C 1,2 SGA- 4,5 F out eference esignator C Frequency (Mhz) 5 85 195 24 5 1 8 5 9 1 8 15 8 15 ecommended Bias esistor Values for I =2mA = ( V -V / I S ) Supply Voltage(V ) 5 V V 8 V 1 V S 4 1 2 9 1 uf 1 C Note: provides C bias stability over temperature. B IAS Mounting Instructions CB 1. Use a large ground pad area near device pins 1, 2, 4, and 5 with many plated through-holes as shown.. We recommend 1 or 2 ounce copper. Measurements for this data sheet were made on a 1 mil thick F-4 board with 1 ounce copper on both sides. Part Identification Marking 5 4 A 1 2 5 4 AZ 1 2 Caution: ES sensitive Appropriate precautions in handling, packaging and testing devices must be observed. Pin # 1, 2, 5 Function F IN 4, GN F OUT/ escription F input pin. This pin requires the use an external C blocking capacitor chosen for the frequency of operation. Part Number Ordering Information of Connection to ground. Use via holes for best performance to reduce lead inductance as close to ground leads as possible. F output and bias pin. C voltage is present on this pin, therefore a C blocking capacitor is necessary for proper operation. Part Number eel Size evices/eel SGA- 7" SGA-Z 7" Technology Court, Broomfield, CO 821 Phone: (8) SMI-MMIC http://www.sirenza.com 4 ES-12 ev E
SGA- C-5 Cascadable MMIC Amplifier SOT- PCB Pad Layout imensions in inches [millimeters] F OUT F I N SOT- Nominal Package imensions imensions in inches [millimeters] A link to the SOT- package outline drawing with full dimensions and tolerances may be found on the product web page at www.sirenza.com. Notes: 1. Provide a large ground pad area under device pins 1, 2, 4, & 5 with many plated via holes as shown. 2. imensions given for 5 Ohm F I/O lines are for 1 mil thick Getek. Scale accordingly for different board thicknesses and dielectric contants.. We recommend 1 or 2 ounce copper. Measurements for this data sheet were made on a 1 mil thick Getek with 1 ounce copper on both sides. Technology Court, Broomfield, CO 821 Phone: (8) SMI-MMIC http://www.sirenza.com 5 ES-12 ev E