IR Receiver Modules for New TSOP48.. 2 3 MECHANICAL DATA Pinning = OUT, 2 =, 3 = 6672 FEATURES Low supply curren Phoo deecor and preamplifier in one package Inernal filer for PCM frequency Improved shielding agains EMI Supply volage: 2.7 V o 5.5 V Improved immuniy agains ambien ligh Insensiive o supply volage ripple and noise Componen in accordance o RoHS 22/95/EC and WEEE 22/96/EC DESCRIPTION The TSOP48.. series are miniaurized receivers for infrared remoe conrol sysems. A PIN diode and a preamplifier are assembled on a lead frame, he epoxy package acs as an IR filer. The demodulaed oupu signal can direcly be decoded by a microprocessor. The TSOP48.. is he sandard IR remoe conrol receiver series, supporing all major daa formas. This componen has no been qualified according o auomoive specificaions. PARTS TABLE CARRIER FREQUENCY STANDARD APPLICATIONS (AGC2/AGC8) 3 khz TSOP483 33 khz TSOP4833 36 khz TSOP4836 36.7 khz TSOP4837 38 khz TSOP4838 4 khz TSOP484 56 khz TSOP4856 BLOCK DIAGRAM APPLICATION CIRCUIT 6833_5 Inpu AGC Band pass Demodulaor 33 kω 3 OUT 77_7 Transmier wih TSALxxxx IR receiver Circui OUT R C V O µc + PIN Conrol circui 2 The exernal componens R and C are opional o improve he robusnes agains elecrical oversress (ypical values are R = Ω, C =. µf). The oupu volage V O should no be pulled down o a level below V by he exernal circui. The capaciive load a he oupu should be less han 2 nf. Documen Number: 829 www.vishay.com Rev. 2.5, 29-Jan-9
New TSOP48.. IR Receiver Modules for ABSOLUTE MAXIMUM RATINGS () PARAMETER TEST CONDITION SYMBOL VALUE UNIT Supply volage (pin 3) -.3 o + 6. V Supply curren (pin 3) I S 5 ma Oupu volage (pin ) V O -.3 o 5.5 V Volage a oupu o supply - V O -.3 o ( +.3) V Oupu curren (pin ) I O 5 ma Juncion emperaure T j C Sorage emperaure range T sg - 25 o + 85 C Operaing emperaure range T amb - 25 o + 85 C Power consumpion T amb 85 C P o mw Soldering emperaure s, mm from case T sd 26 C Noe () Sresses beyond hose lised under Absolue Maximum Raings may cause permanen damage o he device. This is a sress raing only and funcional operaion of he device a hese or any oher condiions beyond hose indicaed in he operaional secions of his specificaion is no implied. Exposure o absolue maximum raing condions for exended periods may affec he device reliabiliy. ELECTRICAL AND OPTICAL CHARACTERISTICS () PARAMETER TEST CONDITION SYMBOL MIN. TYP. MAX. UNIT E v =, = 5 V I SD.65.85.5 ma Supply curren (pin 3) E v = 4 klx, sunligh I SH.95 ma Supply volage 2.7 5.5 V Transmission disance Oupu volage low (pin ) Minimum irradiance Maximum irradiance Noe () T amb = 25 C, unless oherwise specified TYPICAL CHARACTERISTICS T amb = 25 C, unless oherwise specified E v =, es signal see fig., IR diode TSAL62, I F = 4 ma I OSL =.5 ma, =.7 mw/m 2, es signal see fig. Pulse widh olerance: pi - 5/f o < po < pi + 6/f o, es signal see fig. pi - 5/f o < po < pi + 6/f o, es signal see fig. d 45 m V OSL mv min..7.35 mw/m 2 max. 3 W/m 2 Direciviy Angle of half ransmission disance ϕ /2 ± 45 deg V O V OH V OL Opical Tes Signal (IR diode TSAL62, I F = A, 3 pulses, f = f, = ms) pi * T * pi /f is recommended for opimal funcion Oupu Signal ) 7/f < d < 5/f 2) pi - 5/f < po < pi + 6/f d ) po 2) Fig. - Oupu Acive Low 6 po - Oupu Pulse Widh (ms) 239.9.8.7.6.5.3 Oupu Pulse Widh Inpu Burs Lengh λ = 95 nm, Opical Tes Signal, Fig.. 2 3 4 5 - Irradiance (mw/m²) Fig. 2 - Pulse Lengh and Sensiiviy in Dark Ambien www.vishay.com Documen Number: 829 2 Rev. 2.5, 29-Jan-9
IR Receiver Modules for New TSOP48.. V O V OH V OL Opical Tes Signal 6 µs 6 µs = 6 ms Oupu Signal, (see fig. 4) on off 94 834 min. - Threshold Irradiance (mw/m 2 ) 5 4.5 4 3.5 3 2.5 2.5.5 Correlaion wih Ambien Ligh Sources: W/m 2 =.4 klx (Sd. illum. A, T = 2855 K) W/m 2 = 8.2.kLx (Dayligh, T = 59 K) Wavelengh of Ambien Illuminaion: λ = 95 nm.. 2393_ - Ambien DC Irradiance (W/m²) Fig. 3 - Oupu Funcion Fig. 6 - Sensiiviy in Brigh Ambien T on, T off - Oupu Pulse Widh (ms) 2392.8.7.6.5.3. λ = 95 nm, Opical Tes Signal, Fig. 3. 2 3 4 5 - Irradiance (mw/m²) Fig. 4 - Oupu Pulse Diagram T on T off min. - Threshold Irradiance (mw/m²).7.6 f = f.5 f = 3 khz.3 f = 2 khz. f = khz f = Hz 2394_ ΔVs RMS - AC Volage on DC Supply Volage (mv) Fig. 7 - Sensiiviy vs. Supply Volage Disurbances min. / - Rel. Responsiviy 6925.2..8.6. f = f ± 5 % Δ f(3 db) = f /.7.9..3 f/f - Relaive Frequency Fig. 5 - Frequency Dependence of Responsiviy E - Max. Field Srengh (V/m) 2747 5 45 4 35 3 25 2 5 5 5 5 2 25 3 f - EMI Frequency (MHz) Fig. 8 - Sensiiviy vs. Elecric Field Disurbances Documen Number: 829 www.vishay.com Rev. 2.5, 29-Jan-9 3
New TSOP48.. IR Receiver Modules for.8 2 3.7 Max. Envelope Duy Cycle.6.5.3. = 2 mw/m²..9.8.7 4 5 6 7 8 2396_2 2 4 6 8 2 4 Burs Lengh (number of cycles/burs) Fig. 9 - Max. Envelope Duy Cycle vs. Burs Lengh.6.6 96 2223p2 d rel - Relaive Transmission Disance Fig. 2 - Horizonal Direciviy min. - Threshold Irradiance (mw/m²).3 5.5..5-3 - 3 5 7 9 2397_ T amb - Ambien Temperaure ( C) Fig. - Sensiiviy vs. Ambien Temperaure min. - Sensiiviy (mw/m²).35.3 5.5..5 2398_.5 2.5 3.5 4.5 5.5 - Supply Volage (V) Fig. 3 - Sensiiviy vs. Supply Volage S ( λ ) rel - Relaive Specral Sensiiviy 699.2..8.6. 75 85 95 5 5 λ - Wavelengh (nm) Fig. - Relaive Specral Sensiiviy vs. Wavelengh www.vishay.com Documen Number: 829 4 Rev. 2.5, 29-Jan-9
IR Receiver Modules for New TSOP48.. SUITABLE DATA FORMAT The TSOP48.. series is designed o suppress spurious oupu pulses due o noise or disurbance signals. Daa and disurbance signals can be disinguished by he devices according o carrier frequency, burs lengh and envelope duy cycle. The daa signal should be close o he band-pass cener frequency (e.g. 38 khz) and fulfill he condiions in he able below. When a daa signal is applied o he TSOP48.. in he presence of a disurbance signal, he sensiiviy of he receiver is reduced o insure ha no spurious pulses are presen a he oupu. Some examples of disurbance signals which are suppressed are: DC ligh (e.g. from ungsen bulb or sunligh) Coninuous signals a any frequency Modulaed IR signals from common fluorescen lamps (example of noise paern is shown in figure 4 or figure 5) IR Signal 692 IR Signal from Fluorescen Lamp wih Low Modulaion 5 5 2 Time (ms) Fig. 4 - IR Signal from Fluorescen Lamp wih Low Modulaion IR Signal from Fluorescen Lamp wih High Modulaion IR Signal 692 5 2 Time (ms) Fig. 5 - IR Signal from Fluorescen Lamp wih High Modulaion TSOP48.. Minimum burs lengh cycles/burs Afer each burs of lengh a minimum gap ime is required of o 7 cycles 2 cycles For burss greaer han a minimum gap ime in he daa sream is needed of 7 cycles > 4 x burs lengh Maximum number of coninuous shor burss/second 8 Recommended for NEC code Recommended for RC5/RC6 code Recommended for Sony code Recommended for Thomson 56 khz code Recommended for Misubishi code (38 khz, preburs 8 ms, 6 bi) Recommended for Sharp code Suppression of inerference from fluorescen lamps Mos common disurbance signals are suppressed Noe For daa formas wih shor burss please see he daa shee of TSOP4.. Documen Number: 829 www.vishay.com Rev. 2.5, 29-Jan-9 5
New TSOP48.. IR Receiver Modules for PACKAGE DIMENSIONS in millimeers 6 3.9 3.5 ±.5 (5.55) 8.25 6.95 5.3.85 max..89 OUT.5 max..7 max. 2.54 nom..3 2.54 nom. 4. 5.6 Marking area No indicaed olerances ± Drawing-No.: 6.55-569.-4 Issue: 3; 7.2.8 63 R 2.5 echnical drawings according o DIN specificaions www.vishay.com Documen Number: 829 6 Rev. 2.5, 29-Jan-9
Legal Disclaimer Noice Vishay Disclaimer All produc specificaions and daa are subjec o change wihou noice. Vishay Inerechnology, Inc., is affiliaes, agens, and employees, and all persons acing on is or heir behalf (collecively, Vishay ), disclaim any and all liabiliy for any errors, inaccuracies or incompleeness conained herein or in any oher disclosure relaing o any produc. Vishay disclaims any and all liabiliy arising ou of he use or applicaion of any produc described herein or of any informaion provided herein o he maximum exen permied by law. The produc specificaions do no expand or oherwise modify Vishay s erms and condiions of purchase, including bu no limied o he warrany expressed herein, which apply o hese producs. No license, express or implied, by esoppel or oherwise, o any inellecual propery righs is graned by his documen or by any conduc of Vishay. The producs shown herein are no designed for use in medical, life-saving, or life-susaining applicaions unless oherwise expressly indicaed. Cusomers using or selling Vishay producs no expressly indicaed for use in such applicaions do so enirely a heir own risk and agree o fully indemnify Vishay for any damages arising or resuling from such use or sale. Please conac auhorized Vishay personnel o obain wrien erms and condiions regarding producs designed for such applicaions. Produc names and markings noed herein may be rademarks of heir respecive owners. Documen Number: 9 www.vishay.com Revision: 8-Jul-8