TABLE OF CONTENTS. 6. PHOTOGRAPH Photo of Conducted Emission Measurement Photo of Radiation Emission Measurement...

Transcription

1

2 TABLE OF CONTENTS 1. SUMMARY OF TEST RESULTS GENERAL INFORMATION Details of E.U.T Description of Support Device Block Diagram of Test Setup Test Facility Abnormalities from Standard Conditions MEASURING DEVICES AND TEST EQUIPMENT For Mains terminals Disturbance voltage Test For Radiated Emission Measurement MAINS TERMINAL DISTURBANCE VOLTAGE MEASUREMENT Block Diagram of Test Setup Limit of Mains Terminal Disturbance voltage measurement Test Procedure Operating Condition of E.U.T Mains Terminal Disturbance Voltage Test Results RADIATED EMISSION MEASUREMENT Block Diagram of Test Limit of Radiated Emission Measurement Test Procedure Operating Condition of E.U.T Radiated Emission Measurement Result PHOTOGRAPH Photo of Conducted Emission Measurement Photo of Radiation Emission Measurement Appendix I (Photos of E.U.T.) (6 pages) Page 2 of 36

3 Revision History of This Test Report Report Number Description Issued Date NTC F Initial Issue NTC F-1 NTC F-2 Changed the applicant, brand name and models number. Changed the manufacturer and factory, model number, updated the edition of the standard Page 3 of 36

4 1. SUMMARY OF TEST RESULTS The E.U.T. has been tested according to the following specifications: EMISSION Standard Test Type Result Remarks CFR 47 FCC Part 15, Subpart B, Class A 2016 Mains Terminal Disturbance Voltage Test PASS Uncertainty: 2.7dB Radiated Emission Test PASS Uncertainty: 3.4dB Page 4 of 36

5 2. GENERAL INFORMATION 2.1 Details of E.U.T. E.U.T. Model No. : UPS : BX600YYYY, BX800YYYY (Y can be 0 to 9, A to Z, a to z, -, _ or blank for marketing purpose) (All tests were carried on model BX600L-LM and BX800L-LM.) Brand Name : Rating : M/N: BX600YYYY Input: AC120V, 60Hz, 5A; Output: AC120V, 60Hz, 600VA, 300W DC 12V(Internal Battery) M/N: BX800YYYY Input: AC120V, 60Hz, 6.6A; Output: AC120V, 60Hz, 800VA, 400W DC 12V(Internal Battery) E.U.T. Type : Class A Class A digital device. A digital device that is marketed for use in a commercial, industrial or business environment, exclusive of a device which is marketed for use by the general public or is intended to be used in the home. Operation Frequency : Below 108MHz(Declaration by manufacturer) Test Voltage Cable Description of model difference : AC 120V/60Hz, DC 12V(Internal Battery) : None : Both of models have the same circuit schematic, construction and critical components. Their difference in model name, Input current, output voltage and output power are only for trading purpose. Page 5 of 36

6 Remark : 1. This report was an additional report based on original report NTC F. 2. Both of reports are the same except for the manufacturer, factory, model number and edition of the standard. 3. Model BX600L-LM, BX800L-LM and model BX600-LM, BX800-LM have the same circuitry, electrical mechanical, PCB Layout and physical construction. Their difference in model number. 4. According this change, the original test data were continued to be referenced. 2.2 Description of Support Device None 2.3 Block Diagram of Test Setup Block diagram of connection between the E.U.T. and simulators (1)For Normal operation mode AC Mains EUT Load (2)For Stored energy operation mode EUT Load Page 6 of 36

7 2.4 Test Facility Site Description EMC Lab : Listed by CNAS, August 14, 2015 The certificate is valid until August 13, 2018 The Laboratory has been assessed and proved to be in compliance with CNAS/CL01 The Certificate Registration Number is L5795. Listed by FCC, July 03, 2014 The Certificate Number is Listed by Industry Canada, June 18, 2014 The Certificate Registration Number. Is Name of Firm : Dongguan Nore Testing Center Co., Ltd. (Dongguan NTC Co., Ltd.) Site Location : Building D, Gaosheng Science & Technology Park, Zhouxi Longxi Road, Nancheng District, Dongguan, Guangdong, China. 2.5 Abnormalities from Standard Conditions None Page 7 of 36

8 3. MEASURING DEVICES AND TEST EQUIPMENT 3.1 For Mains terminals Disturbance voltage Test Item Equipment Manufacturer Model No. Serial No. Last Cal. Cal. Interval 1. Test Receiver Rohde & Schwarz ESCI Mar. 08, Year 2. L.I.S.N Rohde & Schwarz ENV Mar. 08, Year 3. L.I.S.N Schwarzbeck NNLK Mar. 22, Year 4. RF Switching Compliance Direction RSU-M Mar. 08, Year Unit Systems Inc. 5. Pulse Limiter MTS-systemtechnik MTS-IMP Mar. 08, Year For Radiated Emission Measurement Item Equipment Manufacturer Model No. Serial No. Last Cal. Cal. Interval 1. Test Receiver Rohde & Schwarz ESCI Mar. 08, Year 2. Antenna Schwarzbeck VULB Mar. 22, Year 3. Positioning Controller UC UC 3000 N/A N/A N/A 4. Color Monitor SUNSPO SP-140A N/A N/A N/A 5. Single Phase Power Line SAEMC PF201A N/A N/A Filter 6. 3 Phase Power Line Filter SAEMC PF401A N/A N/A 7. DC Power Filter SAEMC PF301A N/A N/A 8. Cable Huber+Suhner CBL3-NN-9M Mar. 08, Year 9. Cable Huber+Suhner CIL02 N/A Mar. 08, Year 10. Power Amplifier HP HP 8447D 1145A00203 Mar. 08, Year Page 8 of 36

9 4. MAINS TERMINAL DISTURBANCE VOLTAGE MEASUREMENT 4.1 Block Diagram of Test Setup 40cm 80cm EUT Test Receiver 80cm Power Source L.I.S.N 40cm 80cm Ground Reference Plane 4.2 Limit of Mains Terminal Disturbance voltage measurement Test Standard: CFR 47 FCC Part 15, Class A Frequency range Limits (db(uv)) (MHz) Quasi-peak Average 0.15 to to Note: 1. The lower limit shall apply at the transition frequencies. 2. The limit decreases linearly with the logarithm of the frequency in the range 0.15 MHz to 0.5 MHz. Page 9 of 36

10 4.3 Test Procedure The E.U.T. is put on the 0.8 m high table and connected to the AC mains through a Artificial Mains Network (AMN). This provided a 50ohm coupling impedance for the tested equipments. Both sides of AC line are checked to find out the maximum conducted emission levels according to the FCC ANSI C regulations during conducted emission test. The bandwidth of the test receiver (R&S Test Receiver ESCI) is set at 9 KHz. 4.4 Operating Condition of E.U.T Setup the E.U.T. and simulators as shown in Section Turn on the power of all equipments Let the E.U.T. work in test modes (Normal operation mode, Stored energy operation mode) and test it. 4.5 Mains Terminal Disturbance Voltage Test Results PASS. Please refer to the following pages. Page 10 of 36

11 Page 11 of 36

12 Page 12 of 36

13 Page 13 of 36

14 Page 14 of 36

15 Page 15 of 36

16 Page 16 of 36

17 Page 17 of 36

18 Page 18 of 36

19 5. RADIATED EMISSION MEASUREMENT 5.1 Block Diagram of Test 5.2 Limit of Radiated Emission Measurement Test Standard: CFR 47 FCC Part 15, Class A Frequency range Distance Field Strengths Limit MHz Meters V/m db( V)/m 30 ~ ~ ~ ~ Remark:(1) Emission level (db) V = 20 log Emission level V/m (2) The smaller limit shall apply at the cross point between two frequency bands. (3) Distance is the distance in meters between the measuring instrument, antenna and the closest point of any part of the device or system. Page 19 of 36

20 5.3 Test Procedure E.U.T. and its simulators are placed on a turntable, which is 0.8 meter high above ground. The turntable can rotate 360 degrees to determine the position of the maximum emission level. E.U.T. is set 3.0 meters away from the receiving antenna, which is mounted on a antenna tower. The antenna can be moved up and down between 1.0 meter and 4 meters to find out the maximum emission level. Broadband antenna (calibrated bilog antenna) is used as receiving antenna. Both horizontal and vertical polarization of the antenna is set on measurement. In order to find the maximum emission levels, all of the interface cables must be manipulated according to FCC ANSI C on radiated emission measurement. The bandwidth of the EMI test receiver (R&S ESCI7) is set at 120 KHz. The frequency range from 30 MHz to 1000 MHz is checked. 5.4 Operating Condition of E.U.T Setup the E.U.T. and simulators as shown in Section Turn on the power of all equipments Let the E.U.T. work in test modes (Normal operation mode, Stored energy operation mode) and test it. 5.5 Radiated Emission Measurement Result PASS. Please refer to the following pages. Page 20 of 36

21 Page 21 of 36

22 Page 22 of 36

23 Page 23 of 36

24 Page 24 of 36

25 Page 25 of 36

26 Page 26 of 36

27 Page 27 of 36

28 Page 28 of 36

29 6. PHOTOGRAPH 6.1 Photo of Conducted Emission Measurement 6.2 Photo of Radiation Emission Measurement Page 29 of 36

30 APPENDIX I (Photos of E.U.T.) Page 30 of 36

31 Figure 1 General Appearance of the E.U.T. M/N: BX600L-LM Figure 2 General Appearance of the E.U.T. M/N: BX600L-LM Page 31 of 36

32 Figure 3 General Appearance of the E.U.T. M/N: BX600L-LM Figure 4 General Internal of the E.U.T. M/N: BX600L-LM Page 32 of 36

33 Figure 5 General Appearance of the PCB Figure 6 General Appearance of the PCB Page 33 of 36

34 Figure 7 General Appearance of the E.U.T. M/N: BX800L-LM Figure 8 General Appearance of the E.U.T. M/N: BX800L-LM Page 34 of 36

35 Figure 9 General Appearance of the E.U.T. M/N: BX800L-LM Figure 10 General Internal of the E.U.T. M/N: BX800L-LM Page 35 of 36

36 Figure 11 General Appearance of the PCB Figure 12 General Appearance of the PCB --- End --- Page 36 of 36