ZITARES NCS 2 nd Generation Non-SELV, Constant current control gear, 1-channel, non-dimmable

Transcription

1 ECG versions Model Order no. Output currents Output power NCS135-70FX-20/ ma W NCS140-70FX-20/ ma W NCS FX-20/ ma W Adjustable by means of resistor. Performance characteristics Non-dimmable 1-channel ECG for constant current operation of LED modules Adjustable output currents by plug-in of resistors (LEDset) Non-SELV output voltage Very high efficiency of up to 93 % (100 % load) Soft start and low output current ripple For use in luminaires of protection class I ECG extensively protected against abnormal operating conditions at the output e.g. short-circuit, open circuit or overload Suitable for direct current operation and application in combination with central battery installations Identical dimensions for dimmable and non-dimmable versions Certified as thermally protected device Conformance with international regulations, regarding safety and operation, electromagnetic compatibility and immunity to interference Nominal service life: 100,000 h with failure rate 10 % and operation t c = t c,max - 10 K Applications Office Industrial Shop Markings alternations in the interest of improving our products. 07/2015 1/6

2 General technical data Mains voltage supply Rated voltage range V Max. permanent voltage range (continuous) V Rated frequency 0 / Hz Battery operation Voltage range for continuous operation VDC Lowest limiting value for temporary operation 176 VDC / 0.5 h Mains overvoltage Overvoltage protection 350 VAC / 2 h Automatic switch-off of the LEDs at appr. 350 VAC Protection against voltage peaks Voltage peaks L - N 1 kv Voltage peaks L/N -PE 2 kv Starting time Time to 100% luminous fl ux < 0.5 s Total harmonic distortion (THD) At 100% load to ECG-output < 10 % Output data Tolerance of output current +/- 5 % Max. ripple of output current +/- 10 % Max. wire length to LED module 2 m Galvanic separation to mains input no Protection functions output side Overload operation yes; ECG switch-off, restart after mains interruption Short-circuit operation yes; limitation of the output current Open-circuit operation yes; ECG switch-off, restart after mains interruption Lifetime Operation at t c = t c,max 50,000 h; failure rate 10 % Operation at t c = t c,max - 10 K 100,000 h; failure rate 10 % LEDset interface Galvanic separation to mains input no Range of contral voltage 5 V +/- 5 % Range of resistance detection (NCS135-70FX...) kω Range of resistance detection (NCS140-70FX...) 12, kω Range of resistance detection (NCS FX...) kω Connection terminals Type 90 - terminal with release hole Wire cross section 0.5 mm² mm² Wire stripping length 8 mm - 9 mm Thermal protected device Max. sureface temperature acc. to EN /C5e C Degree of protection Degree of protection of ECG housing IP 20 Terminals and ECG construction are designed for an automatic wiring with robots Order no. for release spike: /6 2/6 alternations in the interest of improving our products 07/2015

3 Temperatures (operation) Model Ambient (t a ) Case (t c ) NCS135-70FX C C max C NCS140-70FX C C max C NCS FX C C max C Lifetime Model NCS135-70FX NCS140-70FX NCS FX typ. I peak /Δt 38 A / 163 μs 38 A / 163 μs 43 A / 203 μs Number of ECG at one singlepole circuit breaker (CB) CB-Typ 10 A 16 A 20 A 25 A B C B C B C Typical current - time profile when switching on I[A] Ipeak ½ x Ipeak - Data for U supply = 230 VAC, mains impedance = 1 Ω - In case of multi-polar CB the maximum number is reduced by 20 % - The max. number may differ depending on CB manufacturer. Please consider the specifications of the manufacturer. - Basically, CB with C-characteristics are recommended to be used in lighting groups. Operating data t t Model Input current Input power W Power factor NCS135-70FX , , NCS140-70FX , , NCS FX , , All specifications with 230 VAC nominal operation and 100 % ECG Output currents 4) Output voltage / efficiency channel A % ma V W Total output 2), 3) power alternations in the interest of improving our products. 07/2015 3/6

4 Operating data NCS135-70FX NCS140-70FX NCS FX Output voltage per channel [V] Output current per channel [ma] Efficiency and power factor Effi ciency vs. output load 100 Power factor vs. output load ,95 Effi ciency [%] Power factor 0,9 0,85 0,8 NCS NCS , Total load on ECG output [%] Total load on ECG output [%] 4/6 4/6 alternations in the interest of improving our products. 07/2015

5 Wiring diagrams ECG 1 Connection of ECG output side A Connection of ECG input side L N PE + CH1: LED LEDset ohmic resistor more ECG LEDset interface The LEDset interface principally enables the connection of ohmic or electronic resistas functioning as current sinks. The resistor value is evaluated by the ECG and can be utilised for active switching of the output currents. Factory settings for output current (LEDset-interface open) NCS135-70FX... = 350 ma NCS140-70FX... = 400 ma NCS FX... = 700 ma Resistance range LEDset-interface NCS135-70FX... NCS140-70FX... NCS FX... Rset min. = 14 kω Rset max. = 43 kω I out [A] = 5 V Rset [Ω] Rset min. = 12,5 kω Rset max. = 43 kω 1000 Rset min. = 6,2 kω Rset max. = 15 kω Computation of the resistance value for the output current Rset resistance [E24 / E48] Output current Ω A , , , , , , , , , , , , , , ,800 alternations in the interest of improving our products. 07/2015 5/6

6 ECG dimensions Model X X M Y Z Z M mm mm mm mm mm NCS135-70FX NCS140-70FX NCS FX Xm X Zm Z Y Logistic data Model Order no. EAN Weight ECG NCS135-70FX , x 285 x NCS140-70FX , x 285 x NCS FX , x 285 x Packaging unit ECG PU Dimensions PU kg pcs. mm kg Weight PU Conformance with regulations EN EN EN EN EN IEC IEC General and safety requirements Particular requirements for d.c. or a.c. supplied electronic control gear for LED modules D.C. or A.C. supplied electronic control gear for LED modules - Performance requirements Equipment for general lighting purposes - EMC immunity requirements Limits and methods of measurement of radio disturbance characteristics of electrical lighting and similar equipment Environmental testing: Tests Test Fc: Vibration (sinusoidal) Environmental testing: Tests Test Ea and guidance: Shock 6/6 alternations in the interest of improving our products 07/2015