EMC filters. 3-line filters for converters and power electronics Rated current 8 to 80 A. Date: January 2006

Transcription

1 EMC ilters 3-line ilters Rated current 8 to 80 A Series/Type: Date: January 2006 EPCOS AG Reproduction, publication and dissemination o this data sheet and the inormation contained therein without EPCOS prior express consent is prohibited.

2 Power line ilters or 3-phase systems Rated voltage 440/250 V AC, 50/60 Hz Rated current 8 to 80 A Construction 3-line ilter Metal case Features Very high insertion loss due to two-stage construction Optimized leakage current Easy to install Degree o protection: IP 20 1) Optimized or long motor cables and operation under ull load Design complies with EN , UL 1283, CSA C22.2 No.8 Applications Frequency converters or motor drives, e.g. elevators pumps traction systems conveyor systems HVAC systems (heating, ventilation and air conditioning) Wind arms Power supplies Terminals Finger-sae terminal blocks Marking Marking on component: Manuacturer s logo, ordering code, rated voltage, rated current, rated temperature, climatic category, date code Minimum marking on packaging: Manuacturer s logo, ordering code 1) To IEC Important notes at the end o this document. 2 01/06

3 Typical circuit diagram LINE L1 L1 LOAD L2 L2 L3 L3 SSB Technical data and measuring conditions Rated voltage V R Rated current I R Test voltage V test Overload capability (thermal) Leakage current l leak Climatic category (IEC ) 440/250 V AC, 50/60 Hz Reerred to 40 C ambient temperature 1770 V DC, 2 s (line/line) 2700 V DC, 2 s (lines/case) 1.5 I R or 3 min per hour or 2.5 I R or 30 s per hour At 400 V AC, 50 Hz 25//21 ( 25 C/+ C/21 days damp heat test) Characteristics and ordering codes V R I R Terminal I leak R typ Approx. Ordering code AC V A cross section mm 2 ma mω weight kg 440/ < B84143B0008R < B84143B0012R < B84143B0016R < B84143B0025R < B84143B0036R < B84143B0050R < B84143B0080R000 For ilters or higher currents see B84143B*R110. Important notes at the end o this document. 3 01/06

4 Dimensional drawings B84143B0008R000 B00016R000 (8 16 A) PE M6 x ±0.5 36±1 81 max. 1± ±1 30±1 193 max. 126 max. 115±0.2 L3 L2 L1 LINE Marking LOAD L3 L2 L1 140± max. 6.6± max. Terminal blocks 4 mm 2 Tightening torque Nm SSB6-Z-E B84143B0025R000 B0050R000 (25 50 A) PE M6 x 24 31±0.5 46±1 91 max. 1± ±1 30±1 281 max. 126 max. 115±0.2 L2 L1 L3 PE LINE Marking LOAD PE L3 L2 L1 140± max. 6.6± max. Terminal blocks 10 mm 2 Tightening torque Nm SSB7-8-E Important notes at the end o this document. 4 01/06

5 B84143B0080R000 (80 A) PE M10 x max. 331 max. 48.5±0.5 73±1 141 max. 1.0±0.1 23± max. 45±0.5 L1 L2 L3 PE L1 Marking L2 L3 LINE LOAD PE 155± max. 6.6± ±0.4 Terminal blocks 25 mm 2 Tightening torque Nm SSB0993-K-E Important notes at the end o this document. 5 01/06

6 Insertion loss (typical values at Z = 50 Ω) unsymmetrical, adjacent branches terminated common mode, all branches in parallel (asymmetrical) dierential mode (symmetrical) Filters or 8 A Filters or 12 A SSB SSB0807-H B84143B0008R Hz 10 8 Filters or 16 A 80 SSB0808-Q B84143B0012R Hz 10 8 Filters or 25 A 80 SSB0809-Y B84143B0016R Hz 10 8 B84143B0025R Hz 10 8 Important notes at the end o this document. 6 01/06

7 Insertion loss (typical values at Z = 50 Ω) unsymmetrical, adjacent branches terminated common mode, all branches in parallel (asymmetrical) dierential mode (symmetrical) Filters or 36 A Filters or 50 and 80 A SSB SSB0994-T B84143B0050R000 B84143B0036R000 B84143B0080R Hz Hz 10 8 Important notes at the end o this document. 7 01/06

8 EMC ilters Cautions and warnings Important inormation Please read all saety and warning notes careully beore installing the EMC ilter and putting it into operation (see ). The same applies to the warning signs on the ilter. Please ensure that the signs are not removed nor their legibility impaired by external inluences. Death, serious bodily injury and substantial material damage to equipment may occur i the appropriate saety measures are not carried out or the warnings in the text are not observed. Using according to the terms The EMC ilters may be used only or their intended application within the speciied values in lowvoltage networks in compliance with the instructions given in the data sheets and the data book. The conditions at the place o application must comply with all speciications or the ilter used. Warnings It shall be ensured that only qualiied persons (electricity specialists) are engaged on work such as planning, assembly, installation, operation, repair and maintenance. They must be provided with the corresponding documentation. Danger o electric shock. EMC ilters contain components that store an electric charge. Dangerous voltages can continue to exist at the ilter terminals or longer than ive minutes even ater the power has been switched o. The protective earth connections shall be the irst to be made when the EMC ilter is installed and the last to be disconnected. Depending on the magnitude o the leakage currents, the particular speciications or making the protective-earth connection must be observed. Impermissible overloading o the EMC ilter, such as impermissible voltages at higher requencies that may cause resonances etc. can lead to destruction o the ilter housing. EMC ilters must be protected in the application against impermissible exceeding o the rated currents by suitable overcurrent protective. 8 01/06

9 EMC ilters Important notes The ollowing applies to all products named in this publication: 1. Some parts o this publication contain statements about the suitability o our products or certain areas o application. These statements are based on our knowledge o typical requirements that are oten placed on our products in the areas o application concerned. We nevertheless expressly point out that such statements cannot be regarded as binding statements about the suitability o our products or a particular customer application. As a rule, EPCOS is either unamiliar with individual customer applications or less amiliar with them than the customers themselves. For these reasons, it is always ultimately incumbent on the customer to check and decide whether an EPCOS product with the properties described in the product speciication is suitable or use in a particular customer application. 2. We also point out that in individual cases, a malunction o passive electronic components or ailure beore the end o their usual service lie cannot be completely ruled out in the current state o the art, even i they are operated as speciied. In customer applications requiring a very high level o operational saety and especially in customer applications in which the malunction or ailure o a passive electronic component could endanger human lie or health (e.g. in accident prevention or lie-saving systems), it must thereore be ensured by means o suitable design o the customer application or other action taken by the customer (e.g. installation o protective circuitry or redundancy) that no injury or damage is sustained by third parties in the event o malunction or ailure o a passive electronic component. 3. The warnings, cautions and product-speciic notes must be observed. 4. In order to satisy certain technical requirements, some o the products described in this publication may contain substances subject to restrictions in certain jurisdictions (e.g. because they are classed as hazardous ). Useul inormation on this will be ound in our Material Data Sheets on the Internet ( Should you have any more detailed questions, please contact our sales oices. 5. We constantly strive to improve our products. Consequently, the products described in this publication may change rom time to time. The same is true o the corresponding product speciications. Please check thereore to what extent product descriptions and speciications contained in this publication are still applicable beore or when you place an order. We also reserve the right to discontinue production and delivery o products. Consequently, we cannot guarantee that all products named in this publication will always be available. 6. Unless otherwise agreed in individual contracts, all orders are subject to the current version o the General Terms o Delivery or Products and Services in the Electrical Industry published by the German Electrical and Electronics Industry Association (ZVEI). 7. The trade names EPCOS, EPCOS-Jones, Baoke, CeraDiode, CSSP, MLSC, PhaseCap, PhaseMod, SIFI, SIKOREL, SilverCap, SIMID, SIOV, SIP5D, SIP5K, UltraCap, WindCap are trademarks registered or pending in Europe and in other countries. Further inormation will be ound on the Internet at /06

10 Mouser Electronics Authorized Distributor Click to View Pricing, Inventory, Delivery & Liecycle Inormation: EPCOS: B84143B12R B84143B80R B84143B36R B84143B25R B84143B8R B84143B50R B84143B16R