Product Brief Intel Ethernet SFP+ Optics Network Connectivity

Transcription

1 Product Brief Intel Ethernet SFP+ Optics Network Connectivity Intel Ethernet SFP+ Optics Intel Ethernet SFP+ SR, SRX (extended tep), and LR Optics, offer dependable interoperability and consistent perforance across the network when used with Intel Ethernet 500 and 700 Series Network Adapters Key Features Hot-pluggable SFP+ MSA copliant odule SR and LR support 1GbE and 10GbE SRX (extended teperature) supports 10GbE only Duplex LC connector Built-in digital diagnostic functions RoHS-6 copliant (lead-free) Overview For custoers looking for Ethernet connections over 15 eters, Intel Ethernet SFP+ Optics can extend the reach to 300 eters or longer. These optical odules support both short range and long range distances with 10 Gigabit Intel Ethernet Network Adapters. The flexibility provided through reach and range enables custoers to create networking configurations that best eet the needs of their data center environent. Other installation benefits include: Saller physical diensions, use less power, tighter bend radius, lighter weight, and have a longer reach copared to copper edia options. Fiber optics are also ore iune to harsh environental factors. The light used for data transission does not carry an electrical current so it cannot be ipacted by electrical transissions or radio frequency interference. And, light has a superior signal strength that is near ipervious to unwanted network taps. 10 Gigabit Intel Ethernet Network Adapters with SFP+ connectivity are also the ost scalable providing ore secure connections for virtualization, flexibility for LAN and SAN networking, and proven reliable perforance. Other use cases include connecting servers to End of Row (EoR) and Top of Rack (ToR) switches.

2 GENERAL SPECIFICATIONS Network Standards Physical Layer Interface SR SRX LR 1000BASE-SX 1GbE 10GBASE-SR 10GbE 10GBASE-SR 10GbE 1000BASE-LX 1GbE 10GBASE-LR 10GbE SFP+ Module Specifications Electrical interface: SFF-8431 Rev 4.1 I 2 C Register interface: SFF-8472 Rev 10.4 Mechanical: SFF-8432 Rev 5.0 SR OPTICAL CHARACTERISTICS Optical Characteristics for RS0 = HIGH (10 Gb Operation) (T OP = 0 C to 70 C, V CC =3.14 Vdc to 3.46 Vdc) Transitter Optical Modulation aplitude (OMA) P OMA -1.5 db 1 Average Launch Power P AVE -5-1 db 2 Optical Wave Length λ n 1 RMS Spectral Width Δλ rs 0.45 db 1 Optical Extinction Ratio ER db Transitter and Dispersion Penalty TDP 3.9 db. Average Launch Power of OFF Transitter P OFF -30 db Tx Jitter Tx Per IEEE Requireents Encircled Flux <4.5 μ 30 <19 μ 86 % 3 Relative Insensity Noise RIN 12 OMA -128 db/hz Receiver Receiver Sensitivity 10.3 Gb/s R SENS db 4 Stressed Receiver Sensitivity (OMA) 10.3 R Gb/s SENS2-7.5 db 5 Maxiu Input Power P MAX +0.5 db Wavelength Range λ C n Receiver Reflectance R rx -12 db LOS De-Assert LOS D -14 db LOS Assert LOS A db Loss Hysteresis 0.5 db 1. Per Tradeoff Table 52.8, IEEE Average Power figures are inforative only, per IEEE Measured into Type A1a (50/125 μ ultiode) fiber per ANSI/TIA/EIA Measured with worst ER; BER<10-12 ; PRBS. 5. Per IEEE

3 SR OPTICAL CHARACTERISTICS (CONTINUED) Bit Rate BR Gb/s 1 Bit Rate Error Ratio BER Gb/s GBASE-SR/SW. 2. Tested with a PRBS. SR OPTICAL CHARACTERISTICS (CONTINUED) Paraeter Sybol Maxiu Supported Distance Units 1 10 Gb/s Fiber Type 850 n OFL Band-width 6.25 μ 160 MHz-k Lax OM1 200 MHz-K μ 400 MHz-K OM2 500 MHz-K Lax OM MHz-K > SR ENVIRONMENTAL SPECIFICATIONS 850 n SFP transceivers have a coercial operating teperature range fro 0 C to +70 C case teperature Paraeter Sybol Min Typ Max Units Case Operating Teperature T op 70 C Storage Teperature T sto C 3

4 SRX OPTICAL CHARACTERISTICS Optical Characteristics for RS0 = HIGH (10 Gb Operation) (T OP = -5 C to 85 C, V CC =3.14 Vdc to 3.46 Vdc) Transitter Optical Modulation aplitude (OMA) P OMA -1.5 db 1 Average Launch Power P AVE -5-1 db 2 Optical Wave Length λ n 1 RMS Spectral Width Δλ rs db 1 Optical Extinction Ratio ER db Transitter and Dispersion Penalty TDP 3.9 db. Average Launch Power of OFF Transitter P OFF -30 db Tx Jitter Tx j Per IEEE Requireents Encircled Flux <4.5 μ 30 <19 μ 86 % 3 Relative Insensity Noise RIN 12 OMA -128 db/hz Receiver Receiver Sensitivity 10.3 Gb/s R SENS db 4 Stressed Receiver Sensitivity (OMA) 10.3 R Gb/s SENS2-7.5 db 5 Maxiu Input Power P MAX +0.5 db Wavelength Range λ C n Receiver Reflectance R rx -12 db LOS De-Assert LOS D -14 db LOS Assert LOS A db Loss Hysteresis 0.5 db 1. Per Tradeoff Table 52.8, IEEE Average Power figures are inforative only, per IEEE Measured into Type A1a (50/125 μ ultiode) fiber per ANSI/TIA/EIA Measured with worst ER; BER<10-12 ; PRBS. 5. Per IEEE SRX OPTICAL CHARACTERISTICS (CONTINUED) Bit Rate (RSO = LOW) BR Gb/s 1 Bit Rate (RSO = HIGH) BER Gb/s GBASE-SR/SW. Contact your Intel Representative for higher data-rate support. 2. Tested Tested with a PRBS. See note above for conditions. 4

5 SRX OPTICAL CHARACTERISTICS (CONTINUED) Paraeter Sybol Maxiu Supported Distance Units Fiber Type 850 n OFL Band-width 6.25 μ 160 MHz-k 26 Lax OM1 200 MHz-K μ 400 MHz-K 66 OM2 500 MHz-K 82 OM MHz-K Lax 300. OM MHz-K 400 SRX ENVIRONMENTAL SPECIFICATIONS Paraeter Sybol Min Typ Max Units Case Operating Teperature T op C Storage Teperature T sto C LR OPTICAL CHARACTERISTICS Optical Characteristics for RS0 = HIGH (10 Gb Operation) (T OP = 0 C to 70 C, V CC =3.14 Vdc to 3.46 Vdc) Transitter Optical Modulation aplitude (OMA) P OMA -5.2 db Average Launch Power P AVE db 1 Optical Wave Length λ n Side-ode Suppresion Ratio RIN 30 db Optical Extinction Ratio ER 3.5 db Transitter and Dispersion Penalty TDP 3.2 db. Average Launch Power of OFF Transitter P OFF -30. db Tx Jitter Tx Per IEEE Requireents Relative Insensity Noise RIN -128 db/hz Receiver Receiver Sensitivity 10.3 Gb/s R SENS db 2 Stressed Receiver Sensitivity (OMA) 10.3 R Gb/s SENS db 3 Average Receiver Power P AVE db Optical Center Wavelength λ C n Receiver Reflectance R rx -12 db LOS De-Assert LOS D -17 db LOS Assert LOS A -30 db Loss Hysteresis 0.5 db 1. Average power figures are inforative only, per IEEE Valid between 1260 and 1355 n. Measured with worst ER; BER<10-12 ; PRBS. 3. Valid between 1260 and 1355 n. Per IEEE

6 LR GENERAL SPECIFICATIONS Bit Rate (RSO = LOW) BR 1.25 Gb/s 1 Bit Rate (RSO = HIGH) BR Gb/s 2 Maxiu Supported Link Length L MAX 10 K BASE-LX. Tested with a PRBS. (Transceiver data rate selected through the 2-wire bus in accordance with SFF-8472 Rev Soft RS0 is set at Bit3, Byte 110, Address A2h. Soft RS0 default state on power up is 0 LOW, and the state is reset following a power cycle. Writing 1 HIGH selects ax. data rate operation. Transceiver data rate is the logic OR of the input state of the RS0 pin and soft RS0 bit. Thus, if either the RS0 pin OR the soft RS0 bit is HIGH, then the selected data rate will be 9.95 and 10.3 Gb/s. Conversely, to select data rate 1.25 Gb/s, both the RS0 pin and the soft RS0 bit are set LOW.) 2. 10GBASE-LR/LW. Tested with a PRBS. (See note above for conditions.) LR ENVIRONMENTAL SPECIFICATIONS Transceivers have an operating teperature range fro -5 C to +70 C case teperature Paraeter Sybol Min Typ Max Units Case Operating Teperature T op C Storage Teperature T sto C INTEL ETHERNET SFP+ OPTIC PRODUCT CODES Configuration Product Code Intel Order Nubers (Retail / OEM Generic) SR Optic E10GSFPSR / SRX Optic 1 E10GSFPSRX LR Optic E10GSFPLR / Extended tep Note: Other brands of SFP+ optical odules will not work with the Intel Ethernet Converged Network Adapter X520 Series. Note: When two Intel Ethernet Converged Network Adapter X520 Series SFP+ devices are connected back to back, they should be configured with the sae Speed/Duplex setting. Results ay vary if speed settings are ixed. Regulatory Copliance Transceivers are Class 1 Laser Products and coply with US FDA regulations. These products are certified to eet the Class 1 eye safety requireents of EN (IEC) and the electrical safety requireents of EN (IEC) Copies of certificates are available fro Intel Corporation upon request. For Product Inforation For inforation about all Intel Ethernet Products, visit: intel.co/ethernet Warranty Intel liited lifetie hardware warranty, 90-day oney-back guarantee (U.S. and Canada) and worldwide support. Custoer Support For custoer support options in North Aerica visit: intel.co/content/www/us/en/support/contact-support.htl No license (express or iplied, by estoppel or otherwise) to any intellectual property rights is granted by this docuent. Intel disclais all express and iplied warranties, including without liitation, the iplied warranties of erchantability, fitness for a particular purpose, and non-infringeent, as well as any warranty arising fro course of perforance, course of dealing, or usage in trade. This docuent contains inforation on products, services and/or processes in developent. All inforation provided here is subject to change without notice. Contact your Intel representative to obtain the latest forecast, schedule, specifications and roadaps. The products and services described ay contain defects or errors which ay cause deviations fro published specifications. Intel, the Intel logo are tradearks of Intel Corporation or its subsidiaries in the U.S. and/or other countries. *Other naes and brands aybe claied as the property of others. Copyright 2017, Intel Corporation. All Rights Reserved. Printed in USA 0617/ED/123E Please Recycle US 6