FCC PART & I C RSS CLASS I I PERMI SSI VE CHANGE 2.4 GHz FHSS TEST REPORT

Transcription

1 FCC PART & I C RSS CLASS I I PERMI SSI VE CHANGE 2.4 GHz FHSS TEST REPORT NW State Road 4 5 New berry, FL USA Ph.: or Fax: Em ail: info@tim coengr.com W ebsite: w w w.tim coengr.com Applicant Address SI LI CON LABORATORI ES FI NLAND OY SI NI KALLI ONTE 5 A ESPOO, FL , FI NLAND FCC I D QOQW T1 2 I C Model Num ber Product Description A- BGTW T1 2 A WT12 BLUETOOTH MODULE Date Sam ple Received 4/ 7/ 2016 Final Test Date 9/ 19/ 2016 Tested By Approved By Tim Royer Cory Leverett Report Version Description Issue Date Number Number 1849UT16TestReport Rev1 Initial Issue 09/ 15/ UT16TestReport Rev2 Added Lower BE Plots 09/ 21/ 2016 THE ATTACHED REPORT SHALL NOT BE REPRODUCED EXCEPT I N FULL W I THOUT THE W RI TTEN APPROVAL OF TI MCO ENGI NEERI NG, I NC.

2 TABLE OF CONTENTS GENERAL REMARKS... 4 GENERAL INFORMATION... 5 EUT Specification... 5 Host Equipment... 5 RESULTS SUMMARY... 6 BANDEDGE... 7 RADIATED SPURI OUS EMI SSI ONS EMC EQUI PMENT LIST Report: 1849UT16TestReport_Rev2 Page 3 of 15

3 GENERAL REMARKS The attached report shall not be reproduced except in full without the written permission of Timco Engineering I nc. The test results relate only to the items tested. Sum m ary The device under test does: Fulfill the general approval requirements as identified in this test report Not fulfill the general approval requirements as identified in this test report Attestations This equipment has been tested in accordance with the standards identified in this test report. To the best of my knowledge and belief, these tests were performed using the measurement procedures described in this report. All instrumentation and accessories used to test products for compliance to the indicated standards are calibrated regularly in accordance with I SO 17025: 2005 requirements. I attest that the necessary measurements were made at: Tim co Engineering I nc NW State Road 4 5 New berry, FL Authorized Signatory Name: Tested by: Name and Title: Tim Royer, Project Manager/ Testing Technician Date: 9 / 1 9 / Review ed and approved by: Name and Title: Cory Leverett, Project Manager Date: 0 9 / 2 1 / Report: 1849UT16TestReport_Rev2 Page 4 of 15

4 GENERAL I NFORMATI ON EUT Specification Host Equipm ent Regulatory Standards FCC Title 47 CFR Part I C RSS-247 I ssue 1 & RSS-GEN I ssue 4 FCC I D QOQW T1 2 I C A- BGTW T1 2 A Model WT12 EUT Description BLUETOOTH MODULE BT Chipset Version BT V2.1 + EDR with Adaptive Frequency Hopping only Operating Frequency TX: MHz EUT Power Source Vac/ 50 60Hz DC Power Battery Operated Exclusively Test I tem Prototype Pre- Production RX: MHz Production Type of Equipment Fixed Mobile Portable Antenna Connector None Antenna I ntegral Chip Antenna Test Conditions Measurement Standard Test Exercise Temperature: 24-26º C Relative hum idity: 50-65% ANSI C (Test Procedures) ANSI C (Radiated Site Validation) Engineering Software in the EUT was used to enable the modes of operation, 3DH5 Packet types were used for all tests Device Manufact urer Model FCC I D/ I C Portable Radio Relm Wireless Corp. BK Radio KNG2-P800C K95KNGP800C 2116A-KNGP800C Supplied By RELM Used For Host Report: 1849UT16TestReport_Rev2 Page 5 of 15

5 RESULTS SUMMARY FCC Rule Part No. IC Standard Ref. Requirem ent Test Item Result (d) RSS Unwanted s Bandedge Radiated Spurious Pass Pass Notes: Report: 1849UT16TestReport_Rev2 Page 6 of 15

6 BANDEDGE Rule Part No.: FCC (d) & , IC RSS & RSS GEN 8.9 Requirem ents: Test Method: Setup: s m ust be at least 20dB down from the highest em ission level Within the authorized band as m easured with a 100 khz RBW, additionally adjacent restricted band edge em issions m ust com ply with and RSS- GEN 8.9 limits. ANSI C Authorized band-edge relative m ethod ANSI C Restricted band- edge m arker delta m ethod Notes: The m arker delta m ethod of m easurem ent technique used for adjacent restricted bandedges m ay be used for m easuring em issions that are up to 2 MHz rem oved from the bandedge. Radiated em issions that are rem oved by m ore than 2 MHz from the bandedge m ust be m easured in the conventional m anner. RESULTS: Meets Requirem ents Report: 1849UT16TestReport_Rev2 Page 7 of 15

7 BANDEDGE Data: Horizontal 3 DH5 Upper Restricted Band Edge Hopping Stopped Peak/ Average Carrier Level Below Carrier ( db) Lim it Margin ( db) Peak Average RESULTS: Meets Requirem ents Report: 1849UT16TestReport_Rev2 Page 8 of 15

8 BANDEDGE Data: Horizontal 3 DH5 Upper Restricted Band Edge Hopping Peak/ Average Carrier Level Below Carrier ( db) Lim it Margin ( db) Peak Average RESULTS: Meets Requirem ents Report: 1849UT16TestReport_Rev2 Page 9 of 15

9 BANDEDGE Data: Horizontal 3 DH5 Low er Restricted Band Edge Hopping Stopped Peak/ Average Carrier Level Below Carrier ( db) Lim it Margin ( db) Report: 1849UT16TestReport_Rev2 Page 10 of 15

10 BANDEDGE Data: Horizontal 3 DH5 Low er Restricted Band Edge Hopping Peak/ Average Carrier Level Below Carrier ( db) Lim it Margin ( db) Peak Average Report: 1849UT16TestReport_Rev2 Page 11 of 15

11 RADI ATED SPURI OUS EMI SSI ONS Rules Part No.: FCC part (d) & , IC RSS & RSS GEN 8.9 Requirem ents: s found in restricted bands the levels m ust com ply with the general limits found in FCC part Frequency Limits FCC Part , I C RSS-GEN to 490 khz 2400/ F (khz) µv/ 300 m eters 490 to 1705 khz 24000/ F (khz) µv/ 30 m eters 1705 khz to 30 MHz dbµv/ 30 m eters dbµv/ 3 m eters dbµv/ 3 m eters dbµv/ 3 m eters Above dbµv/ 3 m eters Test Method: ANSI C63.4 Annex D Validation of radiated em issions standard test sites ANSI C Com m on requirem ents radiated em issions ANSI C s below 30 MHz ANSI C s between 30 & 1000 MHz ANSI C s above 1 GHz St rength Calculation: The field strength at 3m was established by adding the m eter reading of the spectrum analyzer (which is set to read in units of dbµv) to the antenna correction factor supplied by the antenna m anufacturer plus the coax loss. The antenna correction factors are stated in term s of db. The gain of the preselector was accounted for in the spectrum analyzer m eter reading. Exam ple: Freq (MHz) Meter Reading + ACF + CL = FS dbµv db = dbµv/ 3m Report: 1849UT16TestReport_Rev2 Page 12 of 15

12 RADI ATED SPURI OUS EMI SSI ONS Setup: s below 3 0 MHz s MHz s above 1 GHz Report: 1849UT16TestReport_Rev2 Page 13 of 15

13 RADI ATED SPURI OUS EMI SSI ONS Notes: The EUT was checked in three orthogonal planes as required, a setup photo is provided to show the orientation of the worst case position. Only the worst case data rate and Output Power which produced em issions within 20dB of the limit are reported. The spectrum was m easured from 9 KHz to 25 GHz Test Dat a: Restricted Band s 3 DH5 Strength at 3 Meters Tuned Freq (MHz) Freq (MHz) Detector Type (QP/ PK/ A V) Meter Reading (dbuv) Ant. Polarity (H/ V) Coax Loss (db) Correct io n Factor (db/ m ) Strength (dbuv/ m ) Margin (db) 2, , AV 5.5 V , , PK 8.13 V , , AV -5 V , , PK 5.3 V , , AV 2.2 V , , PK 3.9 V , , AV 1.3 V , , PK 2.55 V , , AV -1.1 V , , PK 4.58 V , , AV 1.5 H , , PK 2.25 H , , AV 5 H , , PK 6.65 H , , AV -1.2 V , , PK 0.04 V Results Meet Requirem ents Report: 1849UT16TestReport_Rev2 Page 14 of 15

14 EMC EQUI PMENT LI ST EMI Test Receiver R & S ESU 40 Cham ber Coaxial Cable - Cham ber 3 cable set (Prim ary) Bore-sight Antenna Positioning Tower High Pass Filter 18GHz Band Reject Filter GHz Rohde & Schwarz Micro-Coax Cham ber 3 cable set (Prim ary) Sunol Sciences ESU / 01/ 16 04/ 01/ 18 Device Manufacturer Model Serial Cal/ Char Due Date Num ber Date Antenna: Eaton / 14/ 15 07/ 14/ 17 Biconical 1096 Cham ber Antenna: Log- Electro- LPA / 14/ 15 07/ 14/ 17 Periodic 1122 Metrics CHAMBER Panashield 3M N/ A 04/ 25/ 16 12/ 31/ 17 Antenna: ETS-Lindgren / 25/ 15 02/ 25/ 17 Double-Ridged Horn/ ETS Horn 2 Cham ber Antenna: EMCO / 18/ 15 11/ 18/ 17 Double-Ridged Horn GH Software: Tim co N/ A Version 4.0 NA NA Strength Program Antenna: Active Loop ETS-Lindgren / 18/ 15 11/ 18/ 17 KMKM ; KMKM ; KFKF / 08/ 16 08/ 08/ 18 TLT2 NA NA NA Micro-Tronics HPS / 13/ 16 05/ 13/ 18 Micro-Tronics BRM G042 05/ 13/ 16 15/ 13/ 18 Pre-am p RF-LAMBDA RLNA00M45GA NA 01/ 04/ 16 01/ 04/ 18 * EMI RECEI VER SOFTW ARE VERSI ON The receiver firm ware used was version 4.43 Service Pack 3 END OF TEST REPORT Report: 1849UT16TestReport_Rev2 Page 15 of 15