IP67 Ⅱ Ⅱ File Name:OWA-60U-SPEC 201-04-1
SPECIFICATION MODEL OWA-60U-12 OWA-60U-1 OWA-60U-20 OWA-60U-24 OWA-60U-30 OWA-60U-36 OWA-60U-42 OWA-60U-48 OWA-60U-4 DC VOLTAGE CONSTANT CURRENT REGION 12V 6 ~ 12V 1V 7. ~ 1V 20V 10 ~ 20V 24V 12 ~ 24V 30V 1 ~ 30V 36V 18 ~ 36V 42V 21 ~ 42V 48V 24 ~ 48V 4V 27 ~ 4V RATED CURRENT RATED POWER A 4A 3A 2.A 2A 1.67A 60.12W 1.A 63W 1.2A 1.12A 60.48W RIPPLE & NOISE (max.) Note.2 1mVp-p 1mVp-p 1mVp-p 1mVp-p 200mVp-p 200mVp-p 2mVp-p 2mVp-p 3mVp-p OUTPUT VOLTAGE TOLERANCE Note.3 ±4.0% ±4.0% ±4.0% ±3.0% ±3.0% ±2.0% LINE REGULATION LOAD REGULATION ±1.% SETUP, RISE TIME Note.4 0ms, 80ms/230VAC 0ms, 80ms/11VAC at 9% load HOLD UP TIME (Typ.) VOLTAGE RANGE FREQUENCY RANGE 10ms at full load 90 ~ 264VAC 47 ~ 63Hz 11VAC / 230VAC 127 ~ 370VDC INPUT EFFICIENCY (Typ.) 11VAC 230VAC 87% 91% 91% AC CURRENT (Typ.) 1.2A / 11VAC 0.7A / 230VAC INRUSH CURRENT (Typ.) LEAKAGE CURRENT COLD START 3A(twidth=7 μs measured at % Ipeak) at 11VAC COLD START 6A(twidth=7 μs measured at % Ipeak) at 230VAC <0.2mA / 240VAC 9 ~ 108% OVER CURRENT Protection type : Constant current limiting, recovers automatically after fault condition is removed SHORT CIRCUIT Hiccup mode, recovers automatically after fault condition is removed PROTECTION 14 ~ 16V 17. ~ 23V 23 ~ 27V 28 ~ 34V 34 ~ 40V 41 ~ V 46 ~ 4V 3 ~ 62V 8 ~ 66V OVER VOLTAGE Protection type : Shut down o/p voltage, re-power on to recover OVER TEMPERATURE Shut down o/p voltage, re-power on to recover ENVIRONMENT WORKING TEMP. WORKING HUMIDITY STORAGE TEMP., HUMIDITY TEMP. COEFFICIENT VIBRATION -3 ~ +70 (Refer to "Derating Curve") 20 ~ 9% RH non-condensing -40 ~ +80, 10 ~ 9% RH ± 0.03%/ (0 ~ ) 10 ~ 0Hz, G 12min./1cycle, period for 72min. each along X, Y, Z axes SAFETY STANDARDS UL87 listed; CSA C22.2 No.2.13-12(except for 42V,48V,4V); IP67 approved for power body WITHSTAND VOLTAGE I/P-O/P:3.7KVAC SAFETY & ISOLATION RESISTANCE I/P-O/P:M Ohms / 0VDC / 2 / 70% RH EMC EMC EMISSION Compliance to FCC Part1 OTHERS NOTE MTBF DIMENSION 292.8K hrs min. 130*3*3mm MIL-HDBK-217F (2 ) PACKING 0.41Kg; 16pcs/6.8Kg/0.8CUFT File Name:OWA-60U-SPEC 201-04-1
Block Diagram PWM fosc : 2~67KHz I/P EMI FILTER & RECTIFIERS POWER SWITCHING RECTIFIERS & FILTER O.L.P. +V -V O.T.P. O.L.P. PWM CONTROL DETECTION CIRCUIT O.V.P. Derating Curve Static Characteristics 90 LOAD (%) 80 60 40 20 230VAC Input only LOAD (%) 80 70 60 40-3 -2-10 0 1 30 60 70 AMBIENT TEMPERATURE ( ) (HORIZONTAL) 90 12 13 14 1 16 17 180 200 230 264 INPUT VOLTAGE (V) 60Hz File Name:OWA-60U-SPEC 201-04-1
EFFICIENCY vs LOAD (48V Model) OWA-60U series possess superior working efficiency that up to 91% can be reached in field applications. 92 91 90 89 88 EFFICIENCY (%) 87 86 8 84 83 82 10% 20% 30% 40% % 60% 70% 80% % 230V 11V LOAD DRIVING METHODS OF LED MODULE There are two major kinds of LED drive method, "direct drive" and "with LED driver". A typical LED power supply may either work in "constant voltage mode (CV)" or "constant current mode (CC)" to drive the LEDs. Mean Well's LED power supply with CV+ CC characteristic can be operated at both CV mode (with LED driver, at area (A) and CC mode (direct drive, at area (B). In the constant current region, the highest voltage at the output of the driver depends on the configuration of the end systems. Vo(%) (A) Constant Voltage area (B) Constant Current area Should there be any compatibility issues, please contact MEAN WELL. (min) (C) Hiccup Protection Io(%) Typical LED power supply I-V curve File Name:OWA-90U-SPEC 201-04-1
Mechanical Specification CASE NO.: OWA-60 Unit:mm 130 10± SVT 18AWG 2C 3 31. 8. 300± 20 UL118 16AWG 2C 2- ψ 4. T case: Max. Case Temperature. 3 11± 0. ID 2.1 x OD. C"+" Outside Inside -V not connected to AC FG 3 Input Plug Type All models : NEMA 1-1p male plug Output Plug Assignment All models : 2.1φ x.φ x 11 mm, center +, tuning fork type PIN NO. OUTPUT Outside Inside CENTER +V Recommend Mounting Direction Installation Manual Please refer to : http://www.meanwell.com/webnet/search/installationsearch.html File Name:OWA-60U-SPEC 201-04-1