Chapter 8..5 CBD Page of 5 TROUBLE SHOOTING AND DIAGNOSIS CBD Description If there is a problem with a system with CBD not working properly there are two tools for help to get the system working or to find the reason for the : A trouble shooting guide that gives you a check list and a diagnosis tool that offers the possibility to read out registrations from the system itself. Trouble Shooting User: st edition rev. 007-0-09
Chapter 8..5 CBD Page of 5 Service: Diagnose CBD with software 00770 version.86 and other new versions are able to show an diagnose. If an that stops the system occurs, the CBD will alert with an statement, if the CBD is not out of action e.g. mains fuse broke or defect transformer. Too view the states a control DPC with display is needed (all DPC s, which are produced after March, 006 are suited). Should more s occur at the same time, up to 6 states can appear in the display in succession, if the key on the DPC is activated for several seconds. Below stated list shows a description of the possible states. st edition rev. 007-0-09
Chapter 8..5 CBD Page of 5 DPC Error Code List: Error States Name Description Potential Cause Action E0 Position lost The desk has unknown position and needs to be initialized E0 wards has occurred E0 Overload downwards has occurred E6 Error Illigal keys pressed (handled internally in DPC CBD Error: Position Hit up e.g. down simultaneously Initialize Remove overload Remove overload Error States Name Description Potential Cause Action E08 Watchdog Indicates that software ed to activate routine that checks calculations E09 Stack overflow Indicates that software caused a stack overflow (infinite loop) E0 Short circuit One of the motor outputs are short circuited E E Double key pressed Cable orientation Indicates that one or more key (s) are pressed on passive matrix on a control One motor cable is not mounted correctly E Position One channel has position different then others Program fault Processor problems Program fault Processor problems Squeezed motor cable Short in motor Multiple keys pressed on different handsets or squeezed control cable button constalling activated Motor cable plugged upside down Bad cable Too much back drive occurred E Power Power happened Mains E5 Channel mismatch DL added Change in number of actuators since initialization Contact LINAK A/S Contact LINAK A/S Exchange cable or motor st edition rev. 007-0-09
Chapter 8..5 CBD Page of 5 E7 Channel E8 Channel E9 Channels E0 Channel type E E E E Channel type Channel type Channel type Channel pulse E5 Channel pulse E6 Channel pulse E7 Channel pulse E8 Channel E9 Channel E0 Channel E Channel E Channel Channel is detected Channel is detected Channel is detected Channel is not same type as when initialized Channel is not Channel is not Channel is not Channel had too many pulse s Channel had too many pulse s Channel had too many pulse s Channel had too many pulse s If DL is not changed ure in leg Change in DL type Check cable connections change cable st edition rev. 007-0-09
Chapter 8..5 CBD Page 5 of 5 E Channel E Channel E5 Channel E6 E7 E8 E9 Channel anti Channel anti Channel anti Channel anti Anti Anti Anti Anti E 0 Channel SLS Safety limit switch E Channel SLS Safety limit switch E Channel SLS Safety limit switch E Channel SLS Safety limit switch E Channel E5 Channel E6 Channel E7 Channel wrong in channel wrong in channel wrong in channel wrong in channel /hall ure /hall ure /hall ure /hall ure are are are are st edition rev. 007-0-09